Protective gloves against dangerous chemicals and micro-organisms - Part 5: Terminology and performance requirements for micro-organisms risks (ISO 374-5:2016)

ISO 374-5:2016 specifies the requirements and test methods for protective gloves intended to protect the user against micro-organisms.
NOTE          If other protection features is to be needed, e.g. chemical risks, mechanical risks, thermal risks, electrostatic dissipation etc., the appropriate specific performance standard is to be used in addition. Further information on protective gloves standards can be found in the EN 420.

Schutzhandschuhe gegen gefährliche Chemikalien und Mikroorganismen - Teil 5: Terminologie und Leistungsanforderungen für Risiken durch Mikroorganismen (ISO 374-5:2016)

Dieser Teil von ISO 374 legt ein Prüfverfahren für den Widerstand gegen Penetration von Handschuhen fest, die vor Mikroorganismen schützen.
ANMERKUNG   Wenn weitere Schutzmerkmale, z. B. chemische Risiken, mechanische Risiken, thermische Risiken, elektrostatische Entladung, erforderlich sind, muss zusätzlich die entsprechende spezifische Leistungsnorm verwendet werden. Weitere Informationen zu Schutzhandschuh-Normen können in EN 420 gefunden werden.

Gants de protection contre les produits chimiques dangereux et les micro-organismes - Partie 5: Terminologie et exigences de performance pour des risques par des micro-organisme (ISO 374-5:2016)

L'ISO 374-5:2016 spécifie une méthode d'essai permettant de déterminer la résistance à la pénétration des gants qui protègent contre les micro-organismes.
NOTE       Si d'autres fonctions de protection doivent être couvertes, par exemple les risques mécaniques, les risques thermiques, la dissipation électrostatique, etc., il convient que la norme de performance spécifique appropriée soit utilisée en complément. Des informations supplémentaires sur les normes concernant les gants de protection peuvent se trouver dans l'EN 420.

Varovalne rokavice za zaščito pred nevarnimi kemikalijami in mikroorganizmi - 5. del: Izrazje in zahtevane lastnosti za zaščito pred tveganji, povezanimi z mikroorganizmi (ISO 374-5:2016)

Ta evropski standard določa preskusno metodo za rokavice, odporne proti predrtju, ki ščitijo pred mikroorganizmi. OPOMBA: Če je treba zajeti tudi druge zaščitne lastnosti, npr. kemične nevarnosti, mehanske nevarnosti, toplotne nevarnosti, elektrostatično razelektritev itd., je treba uporabiti tudi ustrezne standarde zmogljivosti, npr. EN 374-1, EN 388, EN 407, EN 16350 idr.

General Information

Status
Published
Publication Date
22-Nov-2016
Withdrawal Date
30-May-2017
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
23-Nov-2016
Due Date
14-Nov-2017
Completion Date
23-Nov-2016

Relations

Buy Standard

Standard
EN ISO 374-5:2017
English language
12 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 374-5:2017
01-marec-2017
9DURYDOQHURNDYLFH]D]DãþLWRSUHGQHYDUQLPLNHPLNDOLMDPLLQPLNURRUJDQL]PL
GHO,]UD]MHLQ]DKWHYDQHODVWQRVWL]D]DãþLWRSUHGWYHJDQMLSRYH]DQLPL]
PLNURRUJDQL]PL ,62
Protective gloves against dangerous chemicals and micro-organisms - Part 5:
Terminology and performance requirements for micro-organisms risks (ISO 374-5:2016)
Schutzhandschuhe gegen gefährliche Chemikalien und Mikroorganismen - Teil 5:
Terminologie und Leistungsanforderungen für Risiken durch Mikroorganismen (ISO 374-
5:2016)
Gants de protection contre les micro-organismes - Partie 5: Terminologie et exigences
de performance pour des risques par des micro-organisme (ISO 374-5:2016)
Ta slovenski standard je istoveten z: EN ISO 374-5:2016
ICS:
13.340.40 Varovanje dlani in rok Hand and arm protection
SIST EN ISO 374-5:2017 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 374-5:2017

---------------------- Page: 2 ----------------------

SIST EN ISO 374-5:2017


EN ISO 374-5
EUROPEAN STANDARD

NORME EUROPÉENNE

November 2016
EUROPÄISCHE NORM
ICS 01.040.13; 13.340.40
English Version

Protective gloves against dangerous chemicals and micro-
organisms - Part 5: Terminology and performance
requirements for micro-organisms risks (ISO 374-5:2016)
Gants de protection contre les micro-organismes - Schutzhandschuhe gegen Chemikalien und
Partie 5: Terminologie et exigences de performance Mikroorganismen - Teil 5: Terminologie und
pour des risques par des micro-organisme (ISO 374- Leistungsanforderungen für Risiken durch
5:2016) Mikroorganismen (ISO 374-5:2016)
This European Standard was approved by CEN on 24 September 2016.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2016 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 374-5:2016 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 374-5:2017
EN ISO 374-5:2016 (E)
Contents Page
Europen foreword . 3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 89/686/EEC . 4

2

---------------------- Page: 4 ----------------------

SIST EN ISO 374-5:2017
EN ISO 374-5:2016 (E)
Europen foreword
This document (EN ISO 374-5:2016) has been prepared by Technical Committee CEN/TC 162
“Protective clothing including hand and arm protection and lifejackets", the secretariat of which is held
by DIN, in collaboration with Technical Committee ISO/TC 94 "Personal safety - Protective clothing and
equipment".
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by May 2017, and conflicting national standards shall be
withdrawn at the latest by May 2017.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent
rights.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of this
document.
According to the CEN-CENEL
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.