EN 14035-21:2005

Fireworks - Part 21: Jumping ground spinners - Specification and test methods

This European Standard specifies requirements for the construction, performance, primary packaging and labelling of jumping ground spinners and the corresponding test methods. It is applicable to fireworks which are classified as jumping ground spinners of category 2 in EN 14035-2.
It is not applicable to jumping ground spinners containing any report charge.
It is not applicable to jumping ground spinners containing pyrotechnic composition that includes any of the following substances:
-   arsenic or arsenic compounds;
-   mixtures containing a mass fraction of chlorates greater than 80 percent;
-   mixtures of chlorates with metals;
-   mixtures of chlorates with red phosphorus;
-   mixtures of chlorates with potassium hexacyanoferrate(II);
-   mixtures of chlorates with sulfur;
-   mixtures of chlorates with sulfides;
-   lead or lead compounds;
-   mercury compounds;
-   white phosphorus;
-   picrates or picric acid;
-   potassium chlorate with a mass fraction of bromates greater than 0,15 percent;
-   sulfur with an acidity, expressed as mass fraction of sulfuric acid, greater than 0,002 percent;
-   zirconium with a particle size of less than 40 mm.
NOTE   In EN 14035-2, jumping ground spinners are classified as follows:
- brief description: non-metallic tubes containing gas- and sparks-producing pyrotechnic composition, with or without an aural pyrotechnic composition;
- principal effects: rotation on the ground frequently interrupted by a jumping motion and emission of sparks and flames with or without whistling effect.
Schemes for type testing of jumping ground spinners and batch testing of jumping ground spinners are specified in Annex A and Annex B respectively.

Feuerwerkskörper - Teil 21: Sprungräder - Anforderungen und Prüfverfahren

Artifices de divertissement - Partie 21: Tourbillons sauteurs - Spécifications et méthodes d'essai

La présente Norme européenne spécifie les exigences de construction, performance, conditionnement et étiquetage des tourbillons sauteurs, ainsi que les méthodes d’essai correspondantes. Elle s’applique aux artifices de divertissement classés sous le nom de tourbillons sauteurs de catégorie 2 dans l'EN 14035-2.
La présente norme ne s’applique pas aux tourbillons sauteurs ayant une charge à effet sonore.
Elle ne s’applique pas aux tourbillons sauteurs dont la composition pyrotechnique comprend l’une des substances suivantes :
   arsenic ou composés d’arsenic ;
   mélanges contenant une fraction en masse de chlorates supérieure à 80 % ;
   mélanges de chlorates et de métaux ;
   mélanges de chlorates et de phosphore rouge ;
   mélanges de chlorates et d’hexacyanoferrate (II) de potassium ;
   mélanges de chlorates et de soufre ;
   mélanges de chlorates et de sulfures ;
   plomb ou composés de plomb ;
   composés de mercure ;
   phosphore blanc ;
   picrates ou acide picrique ;
   chlorate de potassium contenant une fraction en masse de bromates supérieure à 0,15 % ;
soufre présentant une acidité, exprimée en fraction de masse d’acide sulfurique supérieure à 0,002 % ;
   zirconium ayant une taille de particule inférieure à 40 mm.
NOTE   Dans l’EN 14035-2, les tourbillons sauteurs sont classés comme suit :
description abrégée : des tubes non métalliques contenant une composition pyrotechnique produisant du gaz et des étincelles, avec ou sans composition à effet sonore ;
effets principaux : rotation au sol fréquemment interrompue par un saut et l'émission d'étincelles et de flammes avec ou sans effet ifflant.
Les schémas d'essais de type et d'essais de lot des tourbillons sauteurs sont respectivement spécifiés aux Annexes A et B.

Ognjemet – 21. del: Vrtavke, skakajoče, talne – Specifikacija in preskusne metode

General Information

• Status: Withdrawn
• Publication Date: 01-Nov-2005
• Withdrawal Date: 28-Sep-2010
• ICS: 73.100.30 - Equipment for drilling and mine excavation
• Technical Committee: CEN/TC 212 - Fireworks
• Drafting Committee: CEN/TC 212 - Fireworks
• Current Stage: 9960 - Withdrawal effective - Withdrawal
• Start Date: 29-Sep-2010
• Completion Date: 29-Sep-2010
• Ref Project: SIST EN 14035-21:2006 - Fireworks - Part 21: Jumping ground spinners - Specification and test methods

Relations

• Replaced By: EN 15947-4:2010 - Pyrotechnic articles - Fireworks, Categories 1, 2 and 3 - Part 4: Test methods
• Effective Date: 08-Jun-2022
• Replaced By: EN 15947-3:2010 - Pyrotechnic articles - Fireworks, Categories 1, 2, and 3 - Part 3: Minimum labelling requirements
• Effective Date: 08-Jun-2022
• Replaced By: EN 15947-5:2010 - Pyrotechnic articles - Fireworks, Categories 1, 2, and 3 - Part 5: Requirements for construction and performance
• Effective Date: 08-Jun-2022

Standards Content (Sample)

SLOVENSKI STANDARD
01-januar-2006
2JQMHPHW±GHO9UWDYNHVNDNDMRþHWDOQH±6SHFLILNDFLMDLQSUHVNXVQHPHWRGH
Fireworks - Part 21: Jumping ground spinners - Specification and test methods
Feuerwerkskörper - Teil 21: Sprungräder - Anforderungen und Prüfverfahren
Artifices de divertissement - Partie 21: Tourbillons sauteurs - Spécifications et méthodes
d'essai
Ta slovenski standard je istoveten z: EN 14035-21:2005
ICS:
71.100.30 Eksplozivi. Pirotehnika Explosives. Pyrotechnics
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD
EN 14035-21
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2005
ICS 73.100.30
English Version
Fireworks - Part 21: Jumping ground spinners - Specification
and test methods
Artifices de divertissement - Partie 21: Tourbillons sauteurs Feuerwerkskörper - Teil 21: Sprungräder - Anforderungen
- Spécifications et méthodes d'essai und Prüfverfahren
This European Standard was approved by CEN on 12 September 2005.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 14035-21:2005: E
worldwide for CEN national Members.

Contents Page
Foreword .4
1 Scope .6
2 Normative references .7
3 Terms and definitions.7
4 Construction.7
4.1 Means of ignition.7
4.2 Attachment of initial fuse .7
4.3 Protection of initial fuse .7
4.3.1 General .7
4.3.2 Initial fuse protected by fuse cover .7
4.3.3 Initial fuse protected by primary pack or selection pack.7
4.3.4 Initial fuse designed to resist side ignition.8
4.4 Materials of firework case .8
4.5 Integrity.8
4.6 Net explosive content .8
4.7 Visibility of fuse .8
5 Performance .8
5.1 Initial fuse .8
5.2 Principal effects .8
5.3 Functioning .8
5.4 Explosions.9
5.5 Motion of the jumping ground spinner.9
5.6 Burning matter .9
5.7 Projected debris.9
6 Primary pack or selection pack .9
7 Minimum labelling requirements .9
7.1 General .9
7.2 Type name and category .10
7.3 Safety information.10
7.3.1 General .10
7.3.2 Jumping ground spinners.10
7.3.3 Identification of top side.10
7.4 Name, address and telephone number of manufacturer or distributor or importer .10
7.5 Reference to this document.11
7.6 Printing .11
7.6.1 Labelling .11
7.6.2 Type size.11
7.7 Marking of very small jumping ground spinners.11
7.7.1 Reduced size .11
7.7.2 Reduced information .11
7.8 Additional information on the primary pack (if applicable) .11
8 Test methods.11
8.1 Attachment of initial fuse (type test and batch test) .12
8.1.1 Apparatus .12
8.1.2 Procedure .12
8.2 Performance (type test and batch test) .12
8.2.1 Test environment .12
8.2.2 Apparatus .12
8.2.3 Procedure .12
8.3 Determination of net explosive content (type test) .13
8.3.1 Apparatus .13
8.3.2 Procedure .13
8.4 Side ignition of initial fuse (type test).13
8.4.1 Material .13
8.4.2 Test area .13
8.4.3 Apparatus .13
8.4.4 Test specimen.13
8.4.5 Procedure .14
8.5 Labelling (type test and batch test) .15
Annex A (normative) Type testing.16
Annex B (normative) Batch testing .23
Annex C (normative) Method for determination of smouldering rate of cigarette.26
Annex D (informative) A-Deviations.27

Foreword
This European Standard (EN 14035-21:2005) has been prepared by Technical Committee CEN/TC 212
“Fireworks”, the secretariat of which is held by NEN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by May 2006, and conflicting national standards shall be withdrawn at the
latest by May 2006.
This European Standard is one of a series of standards as listed below.
EN 14035-1, Fireworks - Part 1: Terminology.
EN 14035-2, Fireworks - Part 2: Categorisation.
EN 14035-3, Fireworks - Part 3: Aerial wheels - Specification and test methods.
EN 14035-4, Fireworks - Part 4: Bangers and banger batteries - Specification and test methods.
prEN 14035-5, Fireworks - Part 5: Batteries and combinations - Specification and test methods.
EN 14035-6, Fireworks - Part 6: Bengal flames - Specification and test methods.
EN 14035-7, Fireworks - Part 7: Bengal matches - Specification and test methods.
EN 14035-8, Fireworks - Part 8: Bengal sticks - Specification and test methods.
EN 14035-9, Fireworks - Part 9: Crackling granules - Specification and test methods.
EN 14035-10, Fireworks - Part 10: Double bangers - Specification and test methods.
EN 14035-12, Fireworks - Part 12: Flash bangers and flash banger batteries - Specification and test methods.
EN 14035-13, Fireworks - Part 13: Flash pellets - Specification and test methods.
EN 14035-15, Fireworks - Part 15: Fountains - Specification and test methods.
EN 14035-17, Fireworks - Part 17: Ground spinners - Specification and test methods.
EN 14035-18, Fireworks - Part 18: Hand-held fountains - Specification and test methods.
EN 14035-19, Fireworks - Part 19: Hand-held sparklers - Specification and test methods.
EN 14035-20, Fireworks - Part 20: Jumping crackers - Specification and test methods.
EN 14035-21, Fireworks - Part 21: Jumping ground spinners - Specification and test methods.
EN 14035-22, Fireworks - Part 22: Mines - Specification and test methods.
EN 14035-23, Fireworks - Part 23: Non-hand-held sparklers - Specification and test methods.
EN 14035-24, Fireworks - Part 24: Novelty matches - Specification and test methods.
EN 14035-25, Fireworks - Part 25: Party poppers - Specification and test methods.
EN 14035-27, Fireworks - Part 27: Rockets - Specification and test methods.
EN 14035-28, Fireworks - Part 28: Roman candles - Specification and test methods.
EN 14035-29, Fireworks - Part 29: Serpents - Specification and test methods.
EN 14035-31, Fireworks - Part 31: Shell–in-mortars - Specification and test methods.
EN 14035-33, F
...