EN 14851:2005
(Main)Aerosol containers - Aerosol foam flammability test
Aerosol containers - Aerosol foam flammability test
This European Standard describes the method of determining the flammability of an aerosol product sprayed in the form of a foam, mousse, gel or paste.
Aerosolverpackungen - Prüfung der Brennbarkeit von Schaumprodukten
Diese Europäische Norm legt ein Verfahren zur Ermittlung der Brennbarkeit eines Aerosolproduktes, das in
Form von Schaum, Creme, Gel oder Paste ausgebracht wird fest.
Récipients pour aérosols - Essai d'inflammation des produits moussants en aérosols
La présente Norme européenne décrit une méthode permettant de déterminer l’inflammation d’un produit en générateur aérosol restitué sous la forme d’une mousse, d’un gel ou d’une pâte.
Embalaža za aerosole – Preskus vnetljivosti penastih aerosolov
If no ignition of the sample is apparent, reapply the ignition source to the edge of the sample. 7.8 If ignition occurs, note the following: maximum height of the flame in centimetres above the base of the watchglass; flame duration in seconds. 7.9 Dry and re-weigh the aerosol dispenser and calculate the mass of the released product. 7.10 Ventilate the test area immediately after each test. 7.11 If ignition does not occur and the released product remains in the form of a foam, paste, mousse or gel throughout the test, repeat steps 7.7 to 7.10. Allow the product to stand for 30 s, 1 min, 2 min and 4 min before applying the ignition source. 7.12 Repeat 7.5 to 7.11 twice more (a total of three) for the same can. 7.13 Repeat 7.5 to 7.12 for another two aerosol cans (three cans in total) of the same product. 8 Test report The test report shall include the following information: a) whether the product ignites; b) maximum flame height in centimetres; c) duration of flame in seconds; d) mass of the product tested.
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 14851:2006
01-februar-2006
Embalaža za aerosole – Preskus vnetljivosti penastih aerosolov
Aerosol containers - Aerosol foam flammability test
Aerosolverpackungen - Prüfung der Brennbarkeit von Schaumprodukten
Récipients pour aérosols - Essai d'inflammation des produits moussants en aérosols
Ta slovenski standard je istoveten z: EN 14851:2005
ICS:
13.220.40 Sposobnost vžiga in Ignitability and burning
obnašanje materialov in behaviour of materials and
proizvodov pri gorenju products
55.130 3ORþHYLQNH]DDHURVROH Aerosol containers
SIST EN 14851:2006 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 14851:2006
---------------------- Page: 2 ----------------------
SIST EN 14851:2006
EUROPEAN STANDARD
EN 14851
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2005
ICS 13.220.40; 55.130
English Version
Aerosol containers - Aerosol foam flammability test
Récipients pour aérosols - Essai d'infmammation des Aerosolpackungen - Prüfung der Brennbarkeit von
produits moussants en aérosols Schaumprodukten
This European Standard was approved by CEN on 14 October 2005.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 14851:2005: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 14851:2006
EN 14851:2005 (E)
Contents
1 Scope .4
2 Terms and definitions.4
3 Principle.4
4 Apparatus .4
5 Preparation of test apparatus .4
6 Test conditions .5
7 Test procedure .5
8 Test report .5
2
---------------------- Page: 4 ----------------------
SIST EN 14851:2006
EN 14851:2005 (E)
Foreword
This document (EN 14851:2005) has been prepared by Technical Committee CEN/TC 261 “Packaging”, the
secretariat of which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an identical text or
by endorsement, at the latest by May 2006, and conflicting national standards shall be withdrawn at the latest by
May 2006.
This draft European Standard is one of a series of thirteen related standards with the following titles:
EN 14847, Aerosol containers — Tinplate containers — Dimensions of the 25,4 mm aperture.
EN 14848, Aerosol containers — Metal containers with 25,4 mm aperture — Dimensions of valve cups.
EN 14849, Aerosol containers — Glass containers — Dimensions of aerosol valve ferrules.
EN 14850, Aerosol containers — Metal containers with 25,4 mm aperture — Measurement of contact height.
EN 14851, Aerosol containers — Aerosol foam flammability test.
EN 14852, Aerosol containers — Determination of the ig
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.