EN 15206:2007
(Main)Vitreous and porcelain enamels - Production of specimens for testing enamel on sheet steel, sheet aluminium and cast iron
Vitreous and porcelain enamels - Production of specimens for testing enamel on sheet steel, sheet aluminium and cast iron
This European Standard specifies the method for the production of specimens suitable for testing vitreous and porcelain enamel coatings.
The standard specifies 2 different specimens:
specimens taken from production article, and
specially produced specimens.
NOTE Only the specially produced specimens can be used when the loss in mass per unit area of the enamel coating is to be determined quantitatively as specimens cut from enamelled articles can reduce the accuracy of the test method.
Emails und Emaillierungen - Herstellung von Proben zur Prüfung von Stahlblech-Emails, Aluminium-Emails und Gusseisen-Emails
Dieses Dokument legt ein Prüfverfahren zur Herstellung von Proben fest, die für die Prüfung von
Email-Schichten geeignet sind.
Das Dokument legt zwei unterschiedliche Probenarten fest:
- Proben, aus emaillierten Gegenständen entnommen;
- speziell angefertigte Proben.
Wenn der Massenverlust je Flächeneinheit der Emailschicht quantitativ zu bestimmen ist, können nur speziell
angefertigte Proben angewendet werden, weil durch Proben, die aus emaillierten Gegenständen entnommen
werden, die Genauigkeit des Prüfverfahrens verringert werden kann.
Emaux vitrifiés - Production d'échantillons afin de soumettre à l'essai l'émail sur la tôle d'acier, la tôle d'aluminium et la fonte
La présente Norme européenne spécifie la méthode de production d’échantillons appropriés aux essais des revêtements vitrifiés et émaillés.
La présente norme distingue deux échantillons différents :
- les échantillons prélevés sur un produit de série ; et
- les échantillons fabriqués spécialement.
Lorsque la perte de masse par unité de surface du revêtement émaillé doit être déterminée quantitativement, seuls des échantillons fabriqués spécialement peuvent être utilisés. En effet, les échantillons prélevés sur des articles émaillés sont susceptibles de réduire la précision de la méthode d’essai.
Steklasti in keramični emajli - Izdelovanje vzorcev za preskušanje emajlov na jekleni pločevini, aluminijasti pločevini in železovi litini
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Vitreous and porcelain enamels - Production of specimens for testing enamel on sheet steel, sheet aluminium and cast ironEmaux vitrifiés - Production d'échantillons afin de soumettre a l'essai l'émail sur la tôle d'acier, la tôle d'aluminium et la fonteEmails und Emaillierungen - Herstellung von Proben zur Prüfung von Stahlblech-Emails, Aluminium-Emails und Gusseisen-EmailsTa slovenski standard je istoveten z:EN 15206:2007SIST EN 15206:2007en25.220.50Emajlne prevlekeEnamelsICS:SLOVENSKI
STANDARDSIST EN 15206:200701-april-2007
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 15206January 2007ICS 25.220.50 English VersionVitreous and porcelain enamels - Production of specimens fortesting enamel on sheet steel, sheet aluminium and cast ironEmaux vitrifiés - Production d'échantillons afin desoumettre à l'essai l'émail sur la tôle d'acier, la tôled'aluminium et la fonteEmails und Emaillierungen - Herstellung von Proben zurPrüfung von Stahlblech-Emails, Aluminium-Emails undGusseisen-EmailsThis European Standard was approved by CEN on 8 December 2006.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the CEN Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as theofficial versions.CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2007 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 15206:2007: E
EN 15206:2007 (E) 2 Contents Page Foreword.3 1 Scope.4 2 Normative references.4 3 Designation.4 4 Specimens from production articles.4 4.1 Requirements for the used articles.4 4.2 Shape and dimension requirements.4 4.3 Preparation.5 5 Specially produced specimens.5 5.1 Shape, dimension and substrate requirements.5 5.2 Enamelling of specimens.6 5.3 Surface of enamelled specimens.7 Bibliography.8
EN 15206:2007 (E) 3 Foreword This document (EN 15206:2007) has been prepared by Technical Committee CEN/TC 262 “Metallic and other inorganic coatings”, the secretariat of which is held by BSI. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by July 2007, and conflicting national standards shall be withdrawn at the latest by July 2007. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this Eu
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.