ISO 23269-4:2010
(Main)Ships and marine technology — Breathing apparatus for ships — Part 4: Self-contained breathing apparatus for emergency escape required by the IMO IBC and IGC Codes
Ships and marine technology — Breathing apparatus for ships — Part 4: Self-contained breathing apparatus for emergency escape required by the IMO IBC and IGC Codes
ISO 23269-4:2010 provides performance specifications for the self-contained breathing apparatus (SCBA) required by paragraph 14.2.8.2 of the International Maritime Organization (IMO) International Bulk Chemical (IBC) Code and paragraph 14.4.2.2 of the IMO International Gas Carrier (IGC) Code for emergency escape. Apparatus complying with ISO 23269-4:2010 are not intended for fire-fighting, cargo handling, or approach or entry into flames.
Navires et technologie maritime — Appareils respiratoires pour navires — Partie 4: Appareils respiratoires autonomes pour issues de secours exigés d'après les codes IBC et IGC de l'OMI
General Information
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 23269-4
First edition
2010-10-15
Ships and marine technology —
Breathing apparatus for ships —
Part 4:
Self-contained breathing apparatus for
emergency escape required by the IMO
IBC and IGC Codes
Navires et technologie maritime — Appareils respiratoires pour
navires —
Partie 4: Appareils respiratoires autonomes pour issues de secours
exigés d'après les codes IBC et IGC de l'OMI
Reference number
ISO 23269-4:2010(E)
©
ISO 2010
---------------------- Page: 1 ----------------------
ISO 23269-4:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
COPYRIGHT PROTECTED DOCUMENT
© ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2010 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 23269-4:2010(E)
Contents Page
Foreword .iv
Introduction.v
1 Scope.1
2 Normative references.1
3 Terms and definitions .1
4 General design requirements.1
5 Environmental tests.1
6 Basic performance tests and requirements .2
6.1 General.2
6.2 Chemical resistance test of the eyepiece and transparent materials.2
6.3 Chemical resistance test of facepiece .2
7 Additional tests and requirements .2
7.1 Donning test.2
7.2 Practical performance test .3
8 Instructions for use .3
9 Marking.3
Bibliography.4
© ISO 2010 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 23269-4:2010(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of prep
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.