Tyre valves for aircraft — Interchangeability dimensions — Amendment 1

Valves pour pneumatiques d'aéronefs — Dimensions d'interchangeabilité — Amendement 1

General Information

Status
Published
Publication Date
19-Feb-2014
Current Stage
6060 - International Standard published
Due Date
23-May-2015
Completion Date
20-Feb-2014
Ref Project

Relations

Buy Standard

Standard
ISO 7295:1988/Amd 1:2014
English language
1 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 7295
Second edition
1988-04-07
AMENDMENT 1
2014-03-01
Tyre valves for aircraft —
Interchangeability dimensions
AMENDMENT 1
Valves pour pneumatiques d’aéronefs — Dimensions
d’interchangeabilité
AMENDEMENT 1
Reference number
ISO 7295:1988/Amd.1:2014(E)
©
ISO 2014

---------------------- Page: 1 ----------------------
ISO 7295:1988/Amd.1:2014(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2014
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2014 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 7295:1988/Amd.1:2014(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types o
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.