SIST EN ISO 14044:2006/A1:2018
(Amendment)Environmental management - Life cycle assessment - Requirements and guidelines (ISO 14044:2006/Amd1:2017)
Environmental management - Life cycle assessment - Requirements and guidelines (ISO 14044:2006/Amd1:2017)
Umweltmanagement - Ökobilanz - Anforderungen und Anleitungen (ISO 14044:2006Amd1:2017)
Management environnemental - Analyse du cycle de vie - Exigences et lignes directrices (ISO 14044:2006/Amd 1:2017)
Ravnanje z okoljem - Ocenjevanje življenjskega cikla - Zahteve in smernice - Dopolnilo A1 (ISO 14044:2006/Amd1:2017)
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN ISO 14044:2006/A1:2018
01-julij-2018
Ravnanje z okoljem - Ocenjevanje življenjskega cikla - Zahteve in smernice -
Dopolnilo A1 (ISO 14044:2006/Amd1:2017)
Environmental management - Life cycle assessment - Requirements and guidelines (ISO
14044:2006/Amd1:2017)
Umweltmanagement - Ökobilanz - Anforderungen und Anleitungen (ISO
14044:2006Amd1:2017)
Management environnemental - Analyse du cycle de vie - Exigences et lignes directrices
(ISO 14044:2006/Amd 1:2017)
Ta slovenski standard je istoveten z: EN ISO 14044:2006/A1:2018
ICS:
13.020.10 Ravnanje z okoljem Environmental management
13.020.60 Življenjski ciklusi izdelkov Product life-cycles
SIST EN ISO 14044:2006/A1:2018 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 14044:2006/A1:2018
---------------------- Page: 2 ----------------------
SIST EN ISO 14044:2006/A1:2018
EN ISO 14044:2006/A1
EUROPEAN STANDARD
NORME EUROPÉENNE
February 2018
EUROPÄISCHE NORM
ICS 13.020.10
English Version
Environmental management - Life cycle assessment -
Requirements and guidelines - Amendment 1 (ISO
14044:2006/Amd 1:2017)
Management environnemental - Analyse du cycle de Umweltmanagement - Ökobilanz - Anforderungen und
vie - Exigences et lignes directrices - Amendement 1 Anleitungen (ISO 14044:2006/Amd 1:2017)
(ISO 14044:2006/Amd 1:2017)
This amendment A1 modifies the European Standard EN ISO 14044:2006; it was approved by CEN on 24 December 2017.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of
this amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2018 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 14044:2006/A1:2018 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN ISO 14044:2006/A1:2018
EN ISO 14044:2006/A1:2018 (E)
Contents Page
European Foreword . 3
2
---------------------- Page: 4 ----------------------
SIST EN ISO 14044:2006/A1:2018
EN ISO 14044:2006/A1:2018 (E)
European Foreword
This document (EN ISO 14044:2006/A1:2018) has been prepared by Technical Committee ISO/TC 207
"Environmental management" in collaboration with Technical Committee CEN/TC SS26 “Environmental
management” the secretariat of which is held by CEN.
This Amendment to the European Standard EN ISO 14044:2006 shall be given the status of a national
standard, either by publication of an identical text or by endorsement, at the latest by August 2018, and
conflicting national standards shall be withdrawn at the latest by August 2018.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta,
Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
Endorsement notice
The text of ISO 14044:2006/Amd 1:2017 has been approved by CEN as EN ISO 14044:2006/A1:2018
without any modification.
3
---------------------- Page: 5 ----------------------
SIST EN ISO 14044:2006/A1:2018
---------------------- Page: 6 ----------------------
SIST EN ISO 14044:2006/A1:2018
INTERNATIONAL ISO
STANDARD 14044
First edition
2006-07-01
AMENDMENT 1
2017-12
Environmental management — Life
cycle assessment — Requirements and
guidelines
AMENDMENT 1
Management environnemental — Analyse du cycle de vie —
Exigences et lignes directrices
AMENDEMENT 1
Reference number
ISO 14044:2006/Amd.1:2017(E)
©
ISO 2017
---------------------- Page: 7 ----------------------
SIST EN ISO 14044:2006/A1:2018
ISO 14044:2006/Amd.1:2017(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2017, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2017 – All rights reserved
---------------------- Page: 8 ----------------------
SIST EN ISO 14044:2006/A1:2018
ISO 14044:2006/Amd.1:2017(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see
...
SLOVENSKI STANDARD
SIST EN ISO 14044:2006/oprA1:2017
01-februar-2017
Ravnanje z okoljem - Ocenjevanje življenjskega cikla - Zahteve in smernice (ISO
14044:2006/DAM 1:2016)
Environmental management - Life cycle assessment - Requirements and guidelines (ISO
14044:2006/DAM 1:2016)
Umweltmanagement - Ökobilanz - Anforderungen und Anleitungen (ISO
14044:2006/DAM 1:2016)
Management environnemental - Analyse du cycle de vie - Exigences et lignes directrices
(ISO 14044:2006/DAM 1:2016)
Ta slovenski standard je istoveten z: EN ISO 14044:2006/prA1
ICS:
13.020.10 Ravnanje z okoljem Environmental management
13.020.60 Življenjski ciklusi izdelkov Product life-cycles
SIST EN ISO 14044:2006/oprA1:2017 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN ISO 14044:2006/oprA1:2017
---------------------- Page: 2 ----------------------
SIST EN ISO 14044:2006/oprA1:2017
DRAFT AMENDMENT
ISO 14044:2006/DAM 1
ISO/TC 207/SC 5 Secretariat: AFNOR
Voting begins on: Voting terminates on:
2016-12-07 2017-02-28
Environmental management — Life cycle assessment —
Requirements and guidelines
AMENDMENT 1
Management environnemental — Analyse du cycle de vie — Exigences et lignes directrices
AMENDEMENT 1
ICS: 13.020.60; 13.020.10
THIS DOCUMENT IS A DRAFT CIRCULATED
This document is circulated as received from the committee secretariat.
FOR COMMENT AND APPROVAL. IT IS
THEREFORE SUBJECT TO CHANGE AND MAY
NOT BE REFERRED TO AS AN INTERNATIONAL
STANDARD UNTIL PUBLISHED AS SUCH.
IN ADDITION TO THEIR EVALUATION AS
ISO/CEN PARALLEL PROCESSING
BEING ACCEPTABLE FOR INDUSTRIAL,
TECHNOLOGICAL, COMMERCIAL AND
USER PURPOSES, DRAFT INTERNATIONAL
STANDARDS MAY ON OCCASION HAVE TO
BE CONSIDERED IN THE LIGHT OF THEIR
POTENTIAL TO BECOME STANDARDS TO
WHICH REFERENCE MAY BE MADE IN
Reference number
NATIONAL REGULATIONS.
ISO 14044:2006/DAM 1:2016(E)
RECIPIENTS OF THIS DRAFT ARE INVITED
TO SUBMIT, WITH THEIR COMMENTS,
NOTIFICATION OF ANY RELEVANT PATENT
RIGHTS OF WHICH THEY ARE AWARE AND TO
©
PROVIDE SUPPORTING DOCUMENTATION. ISO 2016
---------------------- Page: 3 ----------------------
SIST EN ISO 14044:2006/oprA1:2017
ISO 14044:2006/DAM 1:2016(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2016, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2016 – All rights reserved
---------------------- Page: 4 ----------------------
SIST EN ISO 14044:2006/oprA1:2017
ISO 14044:2006/DAM 1:2016(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International
Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies
casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
Amendment 1 to ISO 14044:2006 was prepared by Technical Committee ISO/TC 207, Management
environmental, Subcommittee SC 5, life cycle assessment.
© ISO 2016 – All rights reserved iii
---------------------- Page: 5 ----------------------
SIST EN ISO 14044:2006/oprA1:2017
---------------------- Page: 6 -------------------
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.