Standard Terminology for Waste and Waste Management

SIGNIFICANCE AND USE
3.1 This terminology defines terms and specialized meanings of terms in the subject areas of waste and management of waste.  
3.2 This terminology is not intended for subjects other than waste and waste management. For terms applicable to other subject areas, the appropriate terminology standard(s) should be consulted. See the current edition of the Compilation of ASTM Standard Definitions4 and the list of terminology standards cited therein.  
3.3 Standards relating to subcategories of waste or waste management may use terms defined more narrowly than those included here. The more specialized terminology standards relating to the applicable specific subcategory, or terms defined within individual standards, or both, should be consulted for the exact meaning intended within a given standard.  
3.4 The Thesaurus on Resource Recovery Terminology (Special Technical Publication (STP) 832)5 contains many terms and may be useful for those not listed in terminology standards. However, a definition in a standard terminology shall be considered governing when the term is used in the sense or meaning defined therein.  
3.5 Statistical terms are not defined in this terminology to the extent that the terms, when used regarding waste and management of waste, have the same meanings as in Practice E177 or Terminology E456.  
3.6 Regulatory terms are often developed by regulatory agencies for special regulatory purposes and may have technical content or meaning different from terms defined herein. When a regulatory term exists that differs in meaning from a term given here, the regulatory term should be considered to take precedence for regulatory matters.
SCOPE
1.1 This terminology contains standard definitions of terms used in the general area of waste and waste management. It is intended to promote understanding by providing precise technical definitions of terms used in the standards developed by Committee D34 and its subcommittees.  
1.2 Terms used only within an individual standard, and having a meaning unique to that standard, may be defined or explained in the terminology section of that individual standard.  
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

General Information

Status
Historical
Publication Date
31-Oct-2016
Technical Committee
Drafting Committee
Current Stage
Ref Project

Relations

Buy Standard

Standard
ASTM D5681-16a - Standard Terminology for Waste and Waste Management
English language
20 pages
sale 15% off
Preview
sale 15% off
Preview
Standard
REDLINE ASTM D5681-16a - Standard Terminology for Waste and Waste Management
English language
20 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

NOTICE: This standard has either been superseded and replaced by a new version or withdrawn.
Contact ASTM International (www.astm.org) for the latest information
Designation: D5681 − 16a
Standard Terminology for
1
Waste and Waste Management
This standard is issued under the fixed designation D5681; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope D5231 Test Method for Determination of the Composition
of Unprocessed Municipal Solid Waste
1.1 This terminology contains standard definitions of terms
D5285 Test Method for 24-Hour Batch-Type Measurement
used in the general area of waste and waste management. It is
of Volatile Organic Sorption by Soils and Sediments
intended to promote understanding by providing precise tech-
3
(Withdrawn 2008)
nical definitions of terms used in the standards developed by
D5368 Test Methods for Gravimetric Determination ofTotal
Committee D34 and its subcommittees.
Solvent Extractable Content (TSEC) of Solid Waste
1.2 Terms used only within an individual standard, and 3
Samples (Withdrawn 2014)
having a meaning unique to that standard, may be defined or
D5369 Practice for Extraction of Solid Waste Samples for
explained in the terminology section of that individual stan-
Chemical Analysis Using Soxhlet Extraction (Withdrawn
dard.
3
2016)
1.3 This standard does not purport to address all of the
D5468 Test Method for Gross Calorific and Ash Value of
3
safety concerns, if any, associated with its use. It is the
Waste Materials (Withdrawn 2016)
responsibility of the user of this standard to establish appro-
D5660 Test Method forAssessing the Microbial Detoxifica-
priate safety and health practices and determine the applica-
tion of Chemically Contaminated Water and Soil Using a
bility of regulatory limitations prior to use.
Toxicity Test with a Luminescent Marine Bacterium
3
(Withdrawn 2014)
2. Referenced Documents
D5679 Practice for Sampling Consolidated Solids in Drums
2
2.1 ASTM Standards: or Similar Containers
D1129 Terminology Relating to Water
D5680 Practice for Sampling Unconsolidated Solids in
D4439 Terminology for Geosynthetics
Drums or Similar Containers
D4448 Guide for Sampling Ground-Water Monitoring Wells
D5743 Practice for Sampling Single or Multilayered
D4547 Guide for Sampling Waste and Soils for Volatile
Liquids, With or Without Solids, in Drums or Similar
Organic Compounds
Containers
D4646 Test Method for 24-h Batch-Type Measurement of
D5744 Test Method for Laboratory Weathering of Solid
Contaminant Sorption by Soils and Sediments
Materials Using a Humidity Cell
D4790 Terminology ofAromatic Hydrocarbons and Related
D5745 Guide for Developing and Implementing Short-Term
Chemicals
Measures or Early Actions for Site Remediation
D4874 Test Method for Leaching Solid Material in a Col-
D5746 Classification of Environmental Condition of Prop-
umn Apparatus
erty Area Types for Defense Base Closure and Realign-
D5120 Test Method for Inhibition of Respiration in Micro-
ment Facilities
bial Cultures in theActivated Sludge Process (Withdrawn
D5759 Guide for Characterization of Coal Fly Ash and
3
2014)
Clean Coal Combustion Fly Ash for Potential Uses
D5792 Practice for Generation of Environmental Data Re-
lated to Waste Management Activities: Development of
1
This terminology is under the jurisdiction of ASTM Committee D34 on Waste
Data Quality Objectives
Management and is the direct responsibility of Subcommittee D34.94 on Terminol-
ogy.
D5956 Guide for Sampling Strategies for Heterogeneous
Current edition approved Nov. 1, 2016. Published December 2016. Originally
Wastes
approved in 1995. Last previous edition approved in 2016 as D5681 – 16. DOI:
D6008 PracticeforConductingEnvironmentalBaselineSur-
10.1520/D5681-16A.
2
veys
For referenced ASTM standards, visit the ASTM website, www.astm.org, or
contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM
D6044 Guide for Representative Sampling for Management
Standards volume information, refer to the standard’s Document Summary page on
of Waste and Contaminated Media
the ASTM website.
3
D6051 Guide for Composite Sampling and Field Subsam-
The last approved version of this historical standard is referenced on
www.astm.org. pling for Environmental Waste Management Activities
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1

---------------------- Page: 1 ----------------------
D5681 − 16a
D6063 GuideforSamplingofDrumsandSimilarContainers E889 Test Method for Composition or Purity of a Solid
by Field Personnel Waste Materials Stream
E897 TestMethodforVolatileMatterintheAnalysisSample
D6250 Practice for Derivation of Decision Point and Confi-
3
of Refuse-Derived Fuel (Withdrawn 2011)
dence Limit for
...

This document is not an ASTM standard and is intended only to provide the user of an ASTM standard an indication of what changes have been made to the previous version. Because
it may not be technically possible to adequately depict all changes accurately, ASTM recommends that users consult prior editions as appropriate. In all cases only the current version
of the standard as published by ASTM is to be considered the official document.
Designation: D5681 − 16 D5681 − 16a
Standard Terminology for
1
Waste and Waste Management
This standard is issued under the fixed designation D5681; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
1. Scope
1.1 This terminology contains standard definitions of terms used in the general area of waste and waste management. It is
intended to promote understanding by providing precise technical definitions of terms used in the standards developed by
Committee D34 and its subcommittees.
1.2 Terms used only within an individual standard, and having a meaning unique to that standard, may be defined or explained
in the terminology section of that individual standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility
of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory
limitations prior to use.
2. Referenced Documents
2
2.1 ASTM Standards:
D1129 Terminology Relating to Water
D4439 Terminology for Geosynthetics
D4448 Guide for Sampling Ground-Water Monitoring Wells
D4547 Guide for Sampling Waste and Soils for Volatile Organic Compounds
D4646 Test Method for 24-h Batch-Type Measurement of Contaminant Sorption by Soils and Sediments
D4790 Terminology of Aromatic Hydrocarbons and Related Chemicals
D4874 Test Method for Leaching Solid Material in a Column Apparatus
3
D5120 Test Method for Inhibition of Respiration in Microbial Cultures in the Activated Sludge Process (Withdrawn 2014)
D5231 Test Method for Determination of the Composition of Unprocessed Municipal Solid Waste
D5285 Test Method for 24-Hour Batch-Type Measurement of Volatile Organic Sorption by Soils and Sediments (Withdrawn
3
2008)
D5368 Test Methods for Gravimetric Determination of Total Solvent Extractable Content (TSEC) of Solid Waste Samples
3
(Withdrawn 2014)
3
D5369 Practice for Extraction of Solid Waste Samples for Chemical Analysis Using Soxhlet Extraction (Withdrawn 2016)
3
D5468 Test Method for Gross Calorific and Ash Value of Waste Materials (Withdrawn 2016)
D5660 Test Method for Assessing the Microbial Detoxification of Chemically Contaminated Water and Soil Using a Toxicity
3
Test with a Luminescent Marine Bacterium (Withdrawn 2014)
D5679 Practice for Sampling Consolidated Solids in Drums or Similar Containers
D5680 Practice for Sampling Unconsolidated Solids in Drums or Similar Containers
D5743 Practice for Sampling Single or Multilayered Liquids, With or Without Solids, in Drums or Similar Containers
D5744 Test Method for Laboratory Weathering of Solid Materials Using a Humidity Cell
D5745 Guide for Developing and Implementing Short-Term Measures or Early Actions for Site Remediation
D5746 Classification of Environmental Condition of Property Area Types for Defense Base Closure and Realignment Facilities
D5759 Guide for Characterization of Coal Fly Ash and Clean Coal Combustion Fly Ash for Potential Uses
D5792 Practice for Generation of Environmental Data Related to Waste Management Activities: Development of Data Quality
Objectives
1
This terminology is under the jurisdiction of ASTM Committee D34 on Waste Management and is the direct responsibility of Subcommittee D34.94 on Terminology.
Current edition approved Feb. 1, 2016Nov. 1, 2016. Published February 2016December 2016. Originally approved in 1995. Last previous edition approved in 20132016
as D5681 – 13.16. DOI: 10.1520/D5681-16.10.1520/D5681-16A.
2
For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards
volume information, refer to the standard’s Document Summary page on the ASTM website.
3
The last approved version of this historical standard is referenced on www.astm.org.
Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States
1

---------------------- Page: 1 ----------------------
D5681 − 16a
D5956 Guide for Sampling Strategies for Heterogeneous Wastes
D6008 Practice for Conducting Environmental Baseline Surveys
D6044 Guide for Representative Sampling for Management of Waste and Contaminated Media
D6051 Guide for Composite Sampling and Field Subsampling for Environmental Waste Management Ac
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.