EN ISO 13293:2012
(Main)Recreational diving services - Requirements for gas blender training programmes (ISO 13293:2012)
Recreational diving services - Requirements for gas blender training programmes (ISO 13293:2012)
ISO 13293:2012 specifies requirements for gas blender training programmes and the competencies required of an individual in order to obtain a gas blender certificate from a training organization, attesting that he/she has met or exceeded the requirements specified in ISO 13293:2012.
ISO 13293:2012 specifies two levels of gas blender qualification, as follows:
Level 1 gas blender;
Level 2 gas blender.
ISO 13293:2012 recognizes that a training programme can be organized and delivered in a modular way.
Dienstleistungen des Freizeittauchens - Anforderungen an Ausbildungsprogramme für Gas Blender (ISO 13293:2012)
Diese Internationale Norm legt Anforderungen an Ausbildungsprogramme für Gas Blender und die Kompetenzen fest, die eine Person erlangt haben muss, damit eine Ausbildungsorganisation eine Gas-Blender-Qualifikation vergeben kann, die bestätigt, dass diese Person die in dieser Internationalen Norm festgelegten Kompetenzen erreicht oder übertroffen hat.
Diese Internationale Norm legt zwei mögliche Qualifikationen für Gas Blender fest:
- Gas Blender der Ausbildungsstufe 1;
- Gas Blender der Ausbildungsstufe 2.
Diese Internationale Norm erkennt an, dass ein Ausbildungsprogramm in Modulen aufgebaut sein und durchgeführt werden kann.
Services relatifs à la plongée de loisirs - Exigences relatives aux programmes de formation à la préparation des mélanges gazeux (ISO 13293:2012)
L'ISO 13293:2012 spécifie les exigences relatives aux programmes de formation à la préparation de mélanges gazeux et les compétences que doit acquérir une personne pour qu'un organisme de formation lui décerne un certificat «préparateur de mélanges gazeux» attestant qu'elle a satisfait ou dépassé les compétences spécifiées dans l'ISO 13293:2012.
L'ISO 13293:2012 spécifie deux niveaux de qualification relative à la préparation des mélanges gazeux, comme suit:
préparateur de mélanges gazeux, niveau 1;
préparateur de mélanges gazeux, niveau 2.
L'ISO 13293:2012 admet qu'un programme de formation puisse être organisé et dispensé sous forme de modules.
Centri za rekreacijsko potapljanje - Zahteve za programe usposabljanja z mešalnikom plina (ISO 13293:2012)
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
01-marec-2014
Centri za rekreacijsko potapljanje - Zahteve za programe usposabljanja z
mešalnikom plina (ISO 13293:2012)
Recreational diving services - Requirements for gas blender training programmes (ISO
13293:2012)
Dienstleistungen des Freizeittauchens - Anforderungen an Ausbildungsprogramme für
Gas Blender (ISO 13293:2012)
Services relatifs à la plongée de loisirs - Exigences relatives aux programmes de
formation à la préparation des mélanges gazeux (ISO 13293:2012)
Ta slovenski standard je istoveten z: EN ISO 13293:2012
ICS:
03.080.99 Druge storitve Other services
03.200.99 'UXJLVWDQGDUGLY]YH]LV Other standards relating to
SURVWLPþDVRPLQWXUL]PRP leisure and tourism
97.220.40 Oprema za športe na Outdoor and water sports
prostem in vodne športe equipment
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN ISO 13293
NORME EUROPÉENNE
EUROPÄISCHE NORM
November 2012
ICS 03.080.30; 03.200
English Version
Recreational diving services - Requirements for gas blender
training programmes (ISO 13293:2012)
Services relatifs à la plongée de loisirs - Exigences Dienstleistungen des Freizeittauchens - Anforderungen an
relatives aux programmes de formation à la préparation des Ausbildungsprogramme für Gas Blender (ISO 13293:2012)
mélanges gazeux (ISO 13293:2012)
This European Standard was approved by CEN on 31 October 2012.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2012 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 13293:2012: E
worldwide for CEN national Members.
Contents Page
Foreword .3
Annex ZA (informative) A–deviations .4
Foreword
This document (EN ISO 13293:2012) has been prepared by Technical Committee ISO/TC 228 "Tourism and
related services" in collaboration with Technical Committee CEN/TC 329 “Tourism services”, the secretariat of
which is held by DIN.
This European Standard shall be given the status of a national standard, either by publication of an identical
text or by endorsement, at the latest by May 2013, and conflicting national standards shall be withdrawn at the
latest by May 2013.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights.
According to the CEN/CENELEC Internal Regulations, the national standards organisations of the following
countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech
Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
Endorsement notice
The text of ISO 13293:2012 has been approved by CEN as a EN ISO 13293:2012 without any modification.
Annex ZA
(informative)
A–deviations
A-deviation: National deviation due to regulations, the alteration of which is for the time being outside the
competence of the CEN-CENELEC national member.
This European Standard does not fall under any Directive of the EU.
In the relevant CEN-CENELEC countries these A-deviations are valid instead of the provisions of the
European Standard until they have been removed.
Country National Regulation
France Sport Code, Livre III : Pratique sportive, Titre II:
Obligations liées aux activités sportives, Section 3:
Etablissements qui organisent la pratique ou
dispensent l’enseignement de la plongée
subaquatique, Sous-section 1: Etablissements qui
organisent et dispensent l’enseignement de la
plongée subaquatique à l’air, defines the safety and
technical requirements for the scuba diving service
providers. This regulation determines some
parameters for the diver himself, the scuba diving
instructor, but also for the service supervising.
The French Sport Code is strengthened by its
recognition at European level for the scuba instructors:
a permanent European derogation was granted to
France by a Commission Decision
[MARKT/D4/8339/200-EN) dated 2000-07-25. The
divers' qualifications remain very close to the
problematic.
Clause 2. Normative references According to the CEN/CENELEC Internal
Regulations, Part 3, standards listed under this
chapter are meant to be necessary for the
proper application of the standard.
The following referenced documents are indispensable
for the application of this document. For dated
references, only the edition cited applies. For undated
In France, the Sport Code, Livre III : Pratique
references, the latest edition of the referenced
sportive, Titre II: Obligations liées aux activités
document (including any amendments) applies.
sportives, Section 3: Etablissements qui
organisent la pratique ou dispensent
l’enseignement de la plongée subaquatique, Sous-
section 1: Etablissements qui organisent et
[…]
dispensent l’enseignement de la plongée
subaquatique à l’air, defines the safety and technical
requirements for the scuba diving service providers.
This regulation determines some parameters for the
ISO 24802-1, Recreational Diving Services —
diver himself, the scuba diving instructor, but also for
Safety related minimum requirements for the
the service supervising. This regulation has a double
training of recreational scuba instructors — Part 1:
aim :
Level 1
ISO 24802-2, Recreational Diving Services —
a) quality of services provided and,
Safety related minimum requirements for the
training of recreational scuba instructors — Part 2:
mainly,
Level 2
b) guarantee of safety for the divers.
ISO 24803, Recreational Diving Services —
Requirements for recreational diving service
ISO 24802-1, -2, and ISO 24803, as presented for
providers
divers are incompatible with the French regulation.
Taking into account the diversified requirements of the
activity in France, the French regulation is based on an
[…]
experiences’ progression graded on 5 levels. These 5
levels certify the quality and the safety of the service.
The ISO standard formulation is incompatible with the
technical and safety rules providing by the
establishments organizing the training of recreational
scuba divers as stated by the the Sport Code, Livre
III, Titre II, Section 3, Sous-section 1.
INTERNATIONAL ISO
STANDARD 13293
First edition
2012-11-01
Recreational diving services —
Requirements for gas blender training
programmes
Services relatifs à la plongée de loisirs — Exigences relatives aux
programmes de formation à la préparation des mélanges gazeux
Reference number
ISO 13293:2012(E)
©
ISO 2012
ISO 13293:2012(E)
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
ISO 13293:2012(E)
Contents Page
Foreword .iv
Introduction . v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Competencies of gas blenders . 2
5 Theoretical knowledge . 3
5.1 Purpose of gas blender training . 3
5.2 Gas blending and delivery methods . 3
5.3 Gases and gas blends . 3
5.4 Considerations for elevated oxygen levels . 4
5.5 Cylinder marking and handling . 5
5.6 Gas analysis and record keeping . 5
5.7 Gas blending calculations . 5
6 Practical skills . 5
7 Gas blender instructors . 6
8 Qualification . 6
Annex A (informative) Background information for gas blender training programmes . 7
Bibliography . 8
ISO 13293:2012(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International
Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 13293 was prepared by Technical Committee ISO/TC 228, Tourism and related services.
iv © ISO 2012 – All rights reserved
ISO 13293:2012(E)
Introduction
The requirements specified in this International Standard are minimum requirements; they do not preclude
the provision of additional training or the assessment by a service provider of additional competencies. This
International Standard represents a tool for comparison of existing (or future) qualifications of gas blenders wh
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.