Safety requirements for cableway installations designed to carry persons - Carriers - Part 3: Fatigue testing

This European Standard specifies the safety requirements applicable to carriers for cableway installations for passenger transportation. This standard is applicable to the various types of installations and takes into account their environment.
This standard sets out the requirements to be met for fatigue tests for carriers of unidirectional monocable aerial ropeways of capacity not greater than 16 persons according to EN 13796 1:2014, 6.3.3.1.
This standard does not apply to cableway installations for the transportation of goods or to inclined lifts.

Sicherheitsanforderungen an Seilbahnen für den Personenverkehr - Fahrzeuge - Teil 3: Ermüdungsversuche

Diese Europäische Norm legt die Sicherheitsanforderungen an Fahrzeuge von Seilbahnen des Personenverkehrs fest. Dabei werden die verschiedenen Typen von Seilbahnen und deren Umgebung berücksichtigt.
Die vorliegende Europäische Norm beschreibt die Anforderungen, die während der Ermüdungsversuche an Fahrzeugen von Einseilumlaufbahnen mit einem Fassungsvermögen von bis zu 16 Personen nach EN 13796 1 einzuhalten sind.
Sie gilt weder für Seilbahnen des Güterverkehrs noch für Aufzüge.

Prescriptions de sécurité pour les installations à câbles transportant des personnes - Véhicules - Partie 3 : Essais de fatigue

Cette Norme européenne établit les prescriptions de sécurité s'appliquant aux véhicules des installations à câbles transportant des personnes. Elle s’applique aux différents systèmes et tient compte de leur environnement.
La présente norme européenne décrit les exigences à respecter lors des essais de fatigue des véhicules des téléphériques monocâbles à mouvement unidirectionnel dont la capacité est inférieure ou égale à 16 places, selon l’EN 13796-1.
Elle ne s'applique ni aux installations de transport à câbles destinées aux marchandises, ni aux ascenseurs.

Varnostne zahteve za žičniške naprave za prevoz oseb - Vozila - 3. del: Preskusi utrujenosti

Ta evropski standard določa varnostne zahteve, ki se uporabljajo za vozila žičniških naprav za prevoz oseb. Ta standard se uporablja za različne vrste naprav, pri čemer se upoštevajo okolja njihove uporabe. Ta evropski standard določa zahteve, ki jih je treba izpolnjevati pri preskusih utrujenosti vozil pri enovrvnih žičnicah z zmogljivostjo ne več kot 16 oseb v skladu s točko 6.3.3.1 1. dela tega standarda. Ta standard se ne uporablja za žičniške naprave za prevoz blaga ali nagnjena dvigala.

General Information

Status
Withdrawn
Publication Date
28-Feb-2017
Withdrawal Date
15-Nov-2022
Current Stage
9960 - Withdrawal effective - Withdrawal
Completion Date
16-Nov-2022

Relations

Buy Standard

Standard
EN 13796-3:2017
English language
11 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day
Draft
prEN 13796-3:2012
English language
12 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.XWUXMHQRVWLSicherheitsanforderungen an Seilbahnen für den Personenverkehr - Fahrzeuge - Teil 3: ErmüdungsversuchePrescriptions de sécurité pour les installations à câbles transportant des personnes - Véhicules - Partie 3: Essais de fatigueSafety requirements for cableway installations designed to carry persons - Carriers - Part 3: Fatigue testing45.100Cableway equipmentICS:Ta slovenski standard je istoveten z:EN 13796-3:2017SIST EN 13796-3:2017en,fr,de01-junij-2017SIST EN 13796-3:2017SLOVENSKI
STANDARDSIST EN 13796-3:20051DGRPHãþD



SIST EN 13796-3:2017



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 13796-3
March
t r s y ICS
v wä s r r Supersedes EN
s u y { xæ uã t r r wEnglish Version
Safety requirements for cableway installations designed to carry persons æ Carriers æ Part
uã Fatigue testing Prescriptions de sécurité pour les installations à câbles transportant des personnes æ Véhicules æ Partie
u ã Essais de fatigue
Sicherheitsanforderungen an Seilbahnen für den Personenverkehr æ Fahrzeuge æ Teil
uã Ermüdungsversuche This European Standard was approved by CEN on
s December
t r s vä
egulations which stipulate the conditions for giving this European Standard the status of a national standard without any alterationä Upætoædate lists and bibliographical references concerning such national standards may be obtained on application to the CENæCENELEC Management Centre or to any CEN memberä
translation under the responsibility of a CEN member into its own language and notified to the CENæCENELEC Management Centre has the same status as the official versionsä
CEN members are the national standards bodies of Austriaá Belgiumá Bulgariaá Croatiaá Cyprusá Czech Republicá Denmarká Estoniaá Finlandá Former Yugoslav Republic of Macedoniaá Franceá Germanyá Greeceá Hungaryá Icelandá Irelandá Italyá Latviaá Lithuaniaá Luxembourgá Maltaá Netherlandsá Norwayá Polandá Portugalá Romaniaá Serbiaá Slovakiaá Sloveniaá Spainá Swedená Switzerlandá Turkey and United Kingdomä
EUROPEAN COMMITTEE FOR STANDARDIZATION COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre:
Avenue Marnix 17,
B-1000 Brussels
9
t r s y CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Membersä Refä Noä EN
s u y { xæ uã t r s y ESIST EN 13796-3:2017



EN 13796-3:2017 (E) Contents Page European Foreword .3 1 Scope .5 2 Normative references .5 3 Terms and definitions .5 4 Symbols and abbreviations .5 5 General .6 6 Parts to be tested .6 7 Information to be supplied by the manufacturer .6 8 Examination prior to test .7 9 Test requirements .7 10 Test parameters .8 10.1 Test parameters for unidirectional aerial ropeways with fixed grips .8 10.2 Test parameters for unidirectional aerial ropeways with detachable grips .9 11 Conclusion of the test . 10 11.1 Inspection of test pieces after the test . 10 11.2 Evaluation of the test results . 10 11.3 Test report . 10 Annex ZA (informat
...

SLOVENSKI STANDARD
oSIST prEN 13796-3:2012
01-oktober-2012
9DUQRVWQH]DKWHYH]DåLþQLãNHQDSUDYH]DSUHYR]RVHE9R]LODGHO3UHVNXVL
XWUXMHQRVWL
Safety requirements for cableway installations designed to carry persons - Carriers - Part
3: Fatigue testing
Sicherheitsanforderungen an Seilbahnen für den Personenverkehr - Fahrzeuge - Teil 3:
Ermüdungsversuche
Prescriptions de sécurité pour les installations à câbles transportant des personnes -
Véhicules - Partie 3: Essais de fatigue
Ta slovenski standard je istoveten z: prEN 13796-3
ICS:
45.100 2SUHPD]DåLþQLFH Cableway equipment
oSIST prEN 13796-3:2012 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
oSIST prEN 13796-3:2012

---------------------- Page: 2 ----------------------
oSIST prEN 13796-3:2012


EUROPEAN STANDARD
DRAFT
prEN 13796-3
NORME EUROPÉENNE

EUROPÄISCHE NORM

May 2012
ICS 45.100 Will supersede EN 13796-3:2005
English Version
Safety requirements for cableway installations designed to carry
persons - Carriers - Part 3: Fatigue tests
Prescriptions de sécurité pour les installations à câbles Sicherheitsanforderungen an Seilbahnen für den
transportant des personnes - Véhicules - Partie 3: Essais Personenverkehr - Fahrzeuge - Teil 3: Ermüdungsversuche
de fatigue
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 242.

If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.

This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.

Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.

Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.


EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2012 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 13796-3:2012: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
oSIST prEN 13796-3:2012
prEN 13796-3:2012 (E)
Contents Page
Forew ord .3
1  Scope .5
2  Normative references .5
3  Terms and definitions .5
4  Symbols and abbreviations .5
5  General .6
6  Parts to be tested .6
7  Information to be supplied by the manufacturer .6
8  Examination prior to test .7
9  Test requirements .7
10  Test parameters .8
10.1  Test parameters for unidirectiona
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.