CEN/TR 1404:2024
(Main)Test gases - Determination of emissions from appliances burning gaseous fuels during type-testing
Test gases - Determination of emissions from appliances burning gaseous fuels during type-testing
This document covers the measurements of the emissions of carbon monoxide (CO) and nitrogen oxides (NOX) produced by the combustion of gaseous fuel in domestic appliances. It is also possible to adapt it to liquid fuel appliances.
It explains how to correct the measured values obtained at the testing conditions of temperature, humidity and gas used into the reference conditions, as well as their conversion to different aeration factor expressed as %O2 in the dry products of combustion.
The document also contains information on the types of sampling probes, mainly their form and their dimensions, which depend on the type of flue gas system.
It also gives detailed information on the sampling of the flue gas to be analysed, the transport / transfer lines and their components, and the materials recommended for their construction.
This document contains hints on the calculation of the uncertainties and the parameters to be considered in the whole analysis chain from the sampling probe to the analysers including the calibration gases.
The calculation of the uncertainties of the measurements of NOX and CO is not covered by this document.
Bestimmung von Emissionen von Gasgeräten während der Typprüfung
Determination of emissions from appliances burning gaseous fuel during tape-testing
Določanje emisij iz plinskih aparatov pri tipskem preskušanju
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-oktober-2024
Nadomešča:
SIST-TP CR 1404:2004
Določanje emisij iz plinskih aparatov pri tipskem preskušanju
Determination of emissions from appliances burning gaseous fuel during tape-testing
Bestimmung von Emissionen von Gasgeräten während der Typprüfung
Determination of emissions from appliances burning gaseous fuel during tape-testing
Ta slovenski standard je istoveten z: CEN/TR 1404:2024
ICS:
13.040.40 Emisije nepremičnih virov Stationary source emissions
27.060.20 Plinski gorilniki Gas fuel burners
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
CEN/TR 1404
TECHNICAL REPORT
RAPPORT TECHNIQUE
May 2024
TECHNISCHER REPORT
ICS 97.040.20; 13.040.40 Supersedes CR 1404:1994
English Version
Test gases - Determination of emissions from appliances
burning gaseous fuels during type-testing
Determination of emissions from appliances burning Bestimmung von Emissionen von Gasgeräten während
gaseous fuel during tape-testing der Typprüfung
This Technical Report was approved by CEN on 22 January 2024. It has been drawn up by the Technical Committee CEN/TC 238.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2024 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TR 1404:2024 E
worldwide for CEN national Members.
Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms, definitions, symbols and abbreviations . 6
3.1 Terms and definitions . 6
3.2 Symbols and abbreviations . 8
4 Parameters impacting the uncertainty of the measurements . 8
4.1 General. 8
4.2 Calculation of individual sources of uncertainties . 8
4.3 Total systematic error. 9
4.4 Reproducibility / repeatability of the CO and NO emissions . 9
X
4.5 Warming up . 9
4.6 Response time . 11
4.7 Setting of zero . 11
4.8 Repeatability . 12
5 Main performance characteristics of the analysers . 13
5.1 General. 13
5.2 Linearity . 13
5.3 Drifts . 14
5.3.1 General. 14
5.3.2 Drift with ambient temperature . 14
5.3.3 Drift with ambient pressure . 15
5.3.4 Drift with time . 15
5.4 Interferences . 16
5.5 Measuring range . 16
5.6 Converter efficiency (NO to NO) . 16
6 Calibration gases . 17
6.1 Materials in contact with gases . 17
6.2 Characteristics of the calibration gases . 17
6.3 Accuracy of the calibration gases . 17
6.3.1 General. 17
6.3.2 Uncertainty in concentration of calibration gas . 17
7 Periodical checks . 17
8 Sampling line . 18
8.1 Introduction . 18
8.2 General. 18
8.2.1 Sampling flow rate in sampling line . 18
8.2.2 Sampling probe . 19
8.2.3 Response time . 19
8.3 Water vapour removable method (dry sampling) . 19
8.3.1 Minimum temperature . 19
8.3.2 Transport (sampling) line . 19
8.3.3 Cooler/condenser or permeation dryer . 19
8.3.4 Filter . 19
8.3.5 Manifold . 19
8.3.6 Flow meter / rotameter . 20
8.3.7 Sampling pump . 20
8.4 Wet sampling . 20
9 Testing procedures . 20
9.1 General . 20
9.2 Test room . 20
9.3 Calibration. 20
9.4 Sampling . 21
9.4.1 General . 21
9.4.2 Non-flued appliances are excluded from the scope. . 21
9.4.3 Flued appliances (type B appliances). 21
9.4.4 Balanced flue appliances (type C appliances) . 21
9.4.5 Forced draught burners in relation to the fire tube testing . 21
9.4.6 Test conditions . 21
9.5 Validity of the measurements . 21
9.6 Correction for ambient conditions . 21
9.7 Combustion parameters and conversion coefficients . 21
Annex A (informative) Sampling probes for type B appliances . 22
Annex B (informative) Sampling probes for type C appliances . 25
Annex C (informative) Sampling lines . 28
Annex D (informative) NO and CO: conversions to different units and dilutions . 29
X
Annex E (informative) NO and CO: correction ambient . 34
X
Annex F (informative) Combustion parameters and correction coefficients for CO and NO . 37
X
Annex G (informative) Determination of total CO and NO uncertainty . 40
X
Bibliography . 41
European foreword
This document (CEN/TR 1404:2024) has been prepared by Technical Committee CEN/TC 238 “Test
gases, test pressures, appliance categories and gas appliance types”, the secretariat of which is held by
AFNOR.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes CR 1404:1994.
In comparison with CR 1404:1994, the following significant changes have been made:
emissions, an alternative to the correction formula derived from the BCR program (E.1) is
— for NOX
proposed by CETIAT (E.2), this alternative formula is based on measurements;
— characteristics to be checked before carrying out tests are explained (warming-up period, response
time, setting of zero or repeatability;
— the way to determine the main performances characteristics of analysers are more detailed
(linearity, drifts, interferences, measuring range and converter efficiency are more detailed;
— the calculation of the uncertainties of the measurements of NO and CO is no longer covered by this
X
document, and Annex III, Uncertainty calculation of NOX and CO measurements, has been deleted.
Any feedback and questions on this document should be directed to the users’ national standards body.
A complete listing of these bodies can be found on the CEN website.
Introduction
This document is based on CR 1404 and othe
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.