ISO 81714-1:2010

Design of graphical symbols for use in the technical documentation of products - Part 1: Basic rules

ISO 81714-1 was prepared jointly by Technical Committees ISO/TC 10, Technical product documentation, Subcommittee SC 10, Process plant documentation and tpd-symbols, and IEC/TC 3, Information structures, documentation and graphical symbols. The draft was circulated for voting to the national bodies of both ISO and IEC.

General Information

• Status: Published
• Publication Date: 14-Jun-2010
• ICS: 01 - GENERALITIES. TERMINOLOGY. STANDARDIZATION. DOCUMENTATION
• ICS: 01.080.01 - Graphical symbols in general
• ICS: 01.110 - Technical product documentation
• Technical Committee: TC 3 - Documentation, graphical symbols and representations of technical information
• Current Stage: PPUB - Publication issued
• Start Date: 30-Jun-2010
• Completion Date: 11-Jun-2010

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 81714-1
Second edition
2010-06-15


Design of graphical symbols for use in
the technical documentation of
products —
Part 1:
Basic rules
Création de symboles graphiques à utiliser dans la documentation
technique de produits —
Partie 1: Règles fondamentales





Reference number
ISO 81714-1:2010(E)
©
ISO 2010

---------------------- Page: 1 ----------------------
ISO 81714-1:2010(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.


COPYRIGHT PROTECTED DOCUMENT


©  ISO 2010
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [e-mail]
Web www.iso.org
Published in Switzerland

ii © ISO 2010 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 81714-1:2010(E)
Contents Page
Foreword .iv
1 Scope.1
2 Normative references.1
3 Terms and definitions .1
4 Markers.2
5 Design of graphical symbols.3
5.1 Graphic representation.3
5.2 Design procedure .3
6 Design principles.3
6.1 Shape.3
6.2 Operational state .4
6.3 Classes of graphical symbols.4
6.4 Combination of graphical symbols .4
6.5 Grid; module .7
6.6 Line width and module size.7
6.7 Lines and arcs .7
6.8 Minimum space between parallel lines .8
6.9 Hatched and filled areas .8
6.10 Connect node.8
6.11 Position of a connect node.
...