ISO 14839-1:2018
(Main)Mechanical vibration — Vibration of rotating machinery equipped with active magnetic bearings — Part 1: Vocabulary
Mechanical vibration — Vibration of rotating machinery equipped with active magnetic bearings — Part 1: Vocabulary
This document defines terms relating to rotating machinery equipped with active magnetic bearings. NOTE General terms and definitions of mechanical vibration are given in ISO 2041; those relating to balancing are given in ISO 21940-2; those relating to geometric characteristics such as coaxiality, concentricity and runout are explained in ISO 1101.
Vibrations mécaniques — Vibrations de machines rotatives équipées de paliers magnétiques actifs — Partie 1: Vocabulaire
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 14839-1
Second edition
2018-10
Mechanical vibration — Vibration of
rotating machinery equipped with
active magnetic bearings —
Part 1:
Vocabulary
Vibrations mécaniques — Vibrations de machines rotatives équipées
de paliers magnétiques actifs —
Partie 1: Vocabulaire
Reference number
ISO 14839-1:2018(E)
©
ISO 2018
---------------------- Page: 1 ----------------------
ISO 14839-1:2018(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 14839-1:2018(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
3.1 General terms . 1
3.2 Terms relating to rotors .10
3.3 Terms relating to stators .10
3.4 Terms relating to position transducers .11
3.5 Terms relating to dynamics, control and electronics .13
3.6 Terms relating to auxiliary equipment .17
Bibliography .19
Alphabetical index .20
© ISO 2018 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 14839-1:2018(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular the different approval criteria needed for the
different types of ISO documents should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www .iso .org/directives).
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all s
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.