SIST EN 500-4:2011
(Main)Mobile road construction machinery - Safety - Part 4: Specific requirements for compaction machines
Mobile road construction machinery - Safety - Part 4: Specific requirements for compaction machines
This part of EN 500 specifies the safety requirements for compaction machines as defined in Clause 3 and deals with all significant hazards, hazardous situations and events relevant to compaction machines, when they are used as intended and under conditions of misuse which are reasonably foreseeable. This document specifies additional requirements to and/or exceptions from EN 500-1 ”Common requirements”. This part of EN 500 is not applicable for seated ride-on operated rollers with a drum width less than nominal 0,8 m.
Bewegliche Straßenbaumaschinen - Sicherheit - Teil 4: Besondere Anforderungen an Verdichtungsmaschinen
Dieser Teil von EN 500 enthält die Sicherheitsanforderungen für Verdichtungsmaschinen, wie in Abschnitt 3 definiert, und behandelt alle signifikanten Gefährdungen, Gefährdungssituationen und Gefährdungs-ereignisse, die auf Verdichtungsmaschinen zutreffen, wenn sie bestimmungsgemäß und unter den Bedingungen des Missbrauchs, die vernünftigerweise vom Hersteller vorhersehbar sind, verwendet werden. Dieses Dokument legt ergänzende Anforderungen und/oder Ausnahmen von EN 500-1 „Gemeinsame Anfo-rderungen“ fest. Dieser Teil von EN 500 gilt nicht für Walzen mit aufsitzendem Maschinenführer mit einer Bandagenbreite weniger als nominal 0,8 m.
Machines mobiles pour la construction de routes - Sécurité - Partie 4: Prescriptions spécifiques pour compacteurs
La présente partie de l’EN 500 précise les prescriptions de sécurité pour les machines de compactage telles que définies à l’Article 3 et traite de tous les phénomènes dangereux, situations dangereuses et évènements dangereux significatifs relatifs aux machines de compactage lorsqu’elles sont utilisées normalement et dans des conditions de mauvaise utilisation qui sont raisonnablement prévisibles.
Le présent document fournit des prescriptions complémentaires à l’EN 500-1 "Prescriptions communes" et/ou spécifie des exceptions.
Premični stroji za gradnjo cest - Varnost - 4. del: Posebne zahteve za stroje za kompaktiranje tal
Ta del EN 500 opredeljuje varnostne zahteve za stroje za kompaktiranje tal, kot so opredeljene v točki 3, in obravnava vse velike nevarnosti, nevarne situacije in primere, ki se nanašajo na stroje za kompaktiranje tal, kadar se uporabljajo kot predvideno in pod pogoji napačne uporabe, ki jih je mogoče razumno predvideti. Ta dokument opredeljuje dodatne zahteve k izjemam in/ali izjeme od EN 500-1 »Skupne zahteve«. Ta del EN 500 ne velja za valjarje, ki se jih sede upravlja, z bobnom širine manj kot nominalnih 0,8 m.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 500-4:2011
01-julij-2011
1DGRPHãþD
SIST EN 500-4:2007/kprA2:2010
SIST EN 500-4:2007+A1:2009
3UHPLþQLVWURML]DJUDGQMRFHVW9DUQRVWGHO 3RVHEQH]DKWHYH]DVWURMH]D
NRPSDNWLUDQMHWDO
Mobile road construction machinery - Safety - Part 4: Specific requirements for
compaction machines
Bewegliche Straßenbaumaschinen - Sicherheit - Teil 4: Besondere Anforderungen an
Verdichtungsmaschinen
Machines mobiles pour la construction de routes - Sécurité - Partie 4: Prescriptions
spécifiques pour compacteurs
Ta slovenski standard je istoveten z: EN 500-4:2011
ICS:
93.080.10 Gradnja cest Road construction
SIST EN 500-4:2011 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 500-4:2011
---------------------- Page: 2 ----------------------
SIST EN 500-4:2011
EUROPEAN STANDARD
EN 500-4
NORME EUROPÉENNE
EUROPÄISCHE NORM
February 2011
ICS 93.080.10 Supersedes EN 500-4:2006+A1:2009
English Version
Mobile road construction machinery - Safety - Part 4: Specific
requirements for compaction machines
Machines mobiles pour la construction de routes - Sécurité Bewegliche Straßenbaumaschinen - Sicherheit - Teil 4:
- Partie 4: Prescriptions spécifiques pour compacteurs Besondere Anforderungen an Verdichtungsmaschinen
This European Standard was approved by CEN on 9 January 2011.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2011 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 500-4:2011: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 500-4:2011
EN 500-4:2011 (E)
Contents Page
Foreword .6
Introduction .8
1 Scope .8
2 Normative references .8
3 Terms and definitions .9
4 List of significant hazards . 11
5 Safety requirements and/or protective measures . 11
5.1 Lighting, signalling and marking lights and reflex-reflector devices . 11
5.2 Operation and handling . 11
5.2.1 Retrieval transportation and towing . 11
5.2.2 Pedestrian-controlled rollers . 11
5.3 Operator’s station . 13
5.4 Operator's seat . 13
5.5 Controls and indicators .
...
SLOVENSKI STANDARD
kSIST FprEN 500-4:2010
01-september-2010
3UHPLþQLVWURML]DJUDGQMRFHVW9DUQRVWGHO 3RVHEQH]DKWHYH]DVWURMH]D
NRPSDNWLUDQMHWDO
Mobile road construction machinery - Safety - Part 4: Specific requirements for
compaction machines
Bewegliche Straßenbaumaschinen - Sicherheit - Teil 4: Besondere Anforderungen an
Verdichtungsmaschinen
Machines mobiles pour la construction de routes - Sécurité - Partie 4: Prescriptions
spécifiques pour compacteurs
Ta slovenski standard je istoveten z: FprEN 500-4
ICS:
93.080.10 Gradnja cest Road construction
kSIST FprEN 500-4:2010 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
kSIST FprEN 500-4:2010
---------------------- Page: 2 ----------------------
kSIST FprEN 500-4:2010
EUROPEAN STANDARD
FINAL DRAFT
FprEN 500-4
NORME EUROPÉENNE
EUROPÄISCHE NORM
July 2010
ICS 93.080.10 Will supersede EN 500-4:2006+A1:2009
English Version
Mobile road construction machinery - Safety - Part 4: Specific
requirements for compaction machines
Machines mobiles pour la construction de routes - Sécurité Bewegliche Straßenbaumaschinen - Sicherheit - Teil 4:
- Partie 4: Prescriptions spécifiques pour compacteurs Besondere Anforderungen an Verdichtungsmaschinen
This draft European Standard is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical
Committee CEN/TC 151.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the
same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. FprEN 500-4:2010: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
kSIST FprEN 500-4:2010
FprEN 500-4:2010 (E)
Contents Page
Foreword .6
Introduction .7
1 Scope .7
2 Normative references .7
3 Terms and definitions .8
4 List of significant hazards . 10
5 Safety requirements and/or protective measures . 10
5.1 Lighting, signalling and marking lights and reflex-reflector devices . 10
5.2 Operation and handling . 10
5.2.1 Retrieval transportation and towing . 10
5.2.2 Pedestrian-controlled rollers . 10
5.3 Operator’s station . 12
5.4 Operator's seat .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.