prEN 12101-7

Smoke and heat control systems - Part 7: Smoke duct sections

This European Standard applies to smoke duct sections, placed on the market and intended to operate as part of a pressure differential system or smoke and heat exhaust system. This standard specifies requirements and gives reference to the test methods defined for smoke duct sections and their associated components, which are intended to be installed in such systems in buildings. It also provides for the evaluation of conformity of the products to the requirements of this standard. Furthermore, marking and information on installation and maintenance of these products are also given in this European Standard.

Rauch- und Wärmefreihaltung - Teil 7: Entrauchungsleitungen

Diese Europäische Norm gilt für Entrauchungsleitungen, die in den Markt gebracht wurden, um als Bestandteil einer Rauch- und Wärmeabzugsanlage eingesetzt zu werden. Diese Norm schreibt Anforderungen vor und verweist auf Prüfverfahren für Entrauchungsleitungen, die dazu gedacht sind, in Rauch- und Wärmeabzugsanlagen innerhalb von Gebäuden eingebaut zu werden.
Diese Europäische Norm regelt ebenfalls Bauteile, die innerhalb eines solchen Entrauchungsleitungssystems verwendet werden, wie z. B. Drehklappen und Schalldämpfer, mit Ausnahme von natürlichen und maschinell betriebenen Rauchabzügen und Entrauchungsklappen, die in getrennten Normen behandelt werden.
Leitungen, die nicht zur Rauch- und Wärmeabführung verwendet werden, werden in dieser Norm nicht behandelt.

Systèmes pour le contrôle des fumées et de la chaleur - Partie 7 : Tronçons de conduits de fumées

Sistemi za nadzor dima in toplote - 7. del: Kanali za nadzor dima

General Information

• Status: Not Published
• Technical Committee: CEN/TC 191 - Fixed firefighting systems
• Drafting Committee: CEN/TC 191/SC 1/WG 8 - Smoke ducts and dampers
• Current Stage: 4098 - Decision to abandon - Enquiry
• Start Date: 10-Sep-2009
• Completion Date: 10-Sep-2009
• Directive: 305/2011 - Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec
• Directive: 89/106/EEC - Construction products
• Mandate: M/109 - Mandate to CEN/CENELEC concerning the execution of standardization work for harmonized standards on fire alarm/detection, fixed firefighting, fire and smoke control and explosion suppression products
• Ref Project: oSIST prEN 12101-7:2004 - Smoke and heat control systems - Part 7: Smoke control ducts

Standards Content (Sample)

SLOVENSKI STANDARD
01-julij-2004
Sistemi za nadzor dima in toplote – 7. del: Kanali za nadzor dima
Smoke and heat control systems - Part 7: Smoke control ducts
Rauch- und Wärmefreihaltung - Teil 7: Entrauchungsleitungen
Systemes pour le contrôle des fumées et de la chaleur - Partie 7 : Conduits de
désenfumage
Ta slovenski standard je istoveten z: prEN 12101-7
ICS:
13.220.20 3RåDUQD]DãþLWD Fire protection
91.140.30 3UH]UDþHYDOQLLQNOLPDWVNL Ventilation and air-
VLVWHPL conditioning
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

DRAFT
EUROPEAN STANDARD
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2004
ICS
English version
Smoke and heat control systems - Part 7: Smoke control ducts
This draft European Standard is submitted to CEN members for enquiry. It has been drawn up by the Technical Committee CEN/TC 191.
If this draft becomes a European Standard, CEN members are bound to comply with the CEN/CENELEC Internal Regulations which
stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN in three official versions (English, French, German). A version in any other language
made by translation under the responsibility of a CEN member into its own language and notified to the Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36  B-1050 Brussels
© 2004 CEN All rights of exploitation in any form and by any means reserved Ref. No. prEN 12101-7:2004 E
worldwide for CEN national Members.

Page
Contents
Foreword . 4
Introduction . 5
1 Scope. 7
2 Normative references. 7
3 Terms and definitions. 8
4 Applications. 10
4.1 General . 10
4.1.1 Functions and installation. 10
4.1.2 Specific fire resistant duct types. 10
4.1.3 Single compartment smoke control system ducts. 10
4.1.4 Multi compartment fire resisting smoke control system ducts . 10
5 Construction and components of smoke control system ducts. 12
5.1 General . 12
5.2 Construction of smoke control system ducts. 13
5.2.1 General Requirements. 13
5.2.2 Structural supports used for smoke control system ducts. 13
5.2.3 Duct sealant materials used in smoke control system ducts . 13
5.2.4 Penetration seals (between fire compartments) .13
5.2.5 Other components . 14
6 Test equipment. 14
6.1 Single compartment smoke control system ducts. 14
6.1.1 Elevated temperature tests . 14
6.2 Multi compartment fire resisting smoke control system ducts . 14
6.2.1 Fire resistance tests. 14
7 Test methods. 14
7.1 Single compartment smoke control system ducts. 14
7.1.1 General . 14
7.1.2 Elevated temperature pressure and leakage test . 14
7.1.3 Structural supports used for smoke control system ducts. 15
7.1.4 Duct sealant materials used in smoke control system ducts . 15
7.1.5 Maintenance of cross section. 15
7.2 Multi compartment fire resisting smoke control system ducts . 15
7.2.1 General . 15
7.2.2 Elevated temperature pressure and leakage test . 15
7.2.3 Structural supports used for smoke control system ducts. 15
7.2.4 Duct sealant materials used in smoke control system ducts . 15
7.2.5 Penetration seals (between fire compartments) .15
7.2.6 Maintenance of cross section. 15
7.3 Other components . 15
8 Performance criteria and classification. 16
8.1 Single compartment smoke control system duct. 16
8.1.1 Performance criteria . 16
8.1.2 Classification. 16
8.2 Multi compartment fire resisting smoke control system duct . 16
8.2.1 Performance criteria . 16
8.2.2 Classification. 16
9 Installation and maintenance information. 17
9.1 Installation information . 17
9.2 Maintenance information. 17
10 Marking. 17
11 Evaluation of conformity . 17
11.1 General . 17
11.2 Initial type testing. 18
11.2.1 General . 18
11.2.2 Modifications . 18
11.2.3 Previous tests and product families . 18
11.2.4 Test samples. 19
11.2.5 Test report. 19
11.3 Factory product control (FPC). 19
11.3.1 General . 19
11.3.2 General requirements . 19
11.3.3 Product specific requirements . 20
11.3.4 Initial inspection of factory and FPC. 21
11.3.5 Continuous surveillance of FPC. 21
11.3.6 Procedure for modifications . 22
Annex A (informative) Example of inspection and maintenance procedure. 23
(normative)
Annex B Factory production control supplemental requirements. 24
B.1 Factory production control . 24
B.1.1 Steel. 24
B.1.2 Boards . 24
B.1.3 Steel protected by board, mineral wool, or sprayed or other material. 26
B.1.4 Ducts made from other materials. 26
(informative)
Annex ZA Clauses of this European Standard addressing the provisions of
the EU Construction Products Directive .27
ZA.1 Scope of this annex . 27
ZA.2 Clauses of this European Standard addressing the essential characteristics of the
EU Construction Products Directive. 27
ZA.3 Procedure for the attestation of conformity of smoke control ducts. 28
ZA.4 CE Marking. 28
ZA.5 EC certificate and declaration of conformity . 29
Foreword
This document (prEN 12101-7:2004) has been prepared by Technical Committee CEN/TC 191 “Fixed
firefighting systems”, the secretariat of which is held by BSI.
This document is currently submitted to the CEN Enquiry.
This document has been prepared under a mandate given to CEN by the European Commission and
the European Free Trade Association, and supports essential requirements of EU Directive(s).
For relationship with EU Directive(s), see informative annex ZA, which is an integral part of this
document.
This European Standard has the general title “Smoke and heat control systems” and consists of the
following separate parts:
Part 1: Specification for smoke barriers,
Part 2: Specification for natural smoke and heat exhaust ventilators,
Part 3: Specification for powered smok
...