EN 1113:2008/FprA1
(Amendment)Sanitary tapware - Shower hoses for sanitary tapware for water supply systems of type 1 and type 2 - General technical specification
Sanitary tapware - Shower hoses for sanitary tapware for water supply systems of type 1 and type 2 - General technical specification
This European Standard specifies:
- the dimensional, leaktightness, mechanical and hydraulic characteristics with which shower hoses shall comply;
- the procedures for testing these characteristics.
This European Standard applies to shower hoses of any material used for ablutionary purposes and intended for equipping and supplementing sanitary tapware for baths and showers.
This European Standard applies to shower hoses connected downstream of the obturator of the tapware.
Hoses which are an integral part of sanitary tapware (sink and wash basin mixing valves) or hoses intended to connect sanitary tapware to the water supplies are not covered by this European Standard.
Details of pressures and temperatures are given in Table 1.
Sanitärarmaturen - Brauseschläuche für Sanitärarmaturen für Wasserversorgungssysteme vom Typ 1 und Typ 2 - Allgemeine technische Spezifikation
Robinetterie sanitaire - Flexibles de douches pour robinetterie sanitaire pour les systèmes d'alimentation en eau de types 1 et 2 - Spécifications techniques générales
Sanitarne armature - Gibke cevi za sanitarne armature sistemov za oskrbo z vodo tipa 1 in tipa 2 - Splošne tehnične zahteve
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 1113:2009/kFprA1:2010
01-september-2010
6DQLWDUQHDUPDWXUH*LENHFHYL]DVDQLWDUQHDUPDWXUHVLVWHPRY]DRVNUER]YRGR
WLSDLQWLSD6SORãQHWHKQLþQH]DKWHYH
Sanitary tapware - Shower hoses for sanitary tapware for water supply systems of type 1
and type 2 - General technical specification
Sanitärarmaturen - Brauseschläuche für Sanitärarmaturen für
Wasserversorgungssysteme vom Typ 1 und Typ 2 - Allgemeine technische Spezifikation
Robinetterie sanitaire - Flexibles de douches pour robinetterie sanitaire pour les
systèmes d'alimentation en eau de types 1 et 2 - Spécifications techniques générales
Ta slovenski standard je istoveten z: EN 1113:2008/FprA1
ICS:
23.040.70 Gumene cevi in armature Hoses and hose assemblies
91.140.70 Sanitarne naprave Sanitary installations
SIST EN 1113:2009/kFprA1:2010 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 1113:2009/kFprA1:2010
---------------------- Page: 2 ----------------------
SIST EN 1113:2009/kFprA1:2010
EUROPEAN STANDARD
FINAL DRAFT
EN 1113:2008
NORME EUROPÉENNE
EUROPÄISCHE NORM
FprA1
July 2010
ICS 23.040.70; 91.140.70
English Version
Sanitary tapware - Shower hoses for sanitary tapware for water
supply systems of type 1 and type 2 - General technical
specification
Robinetterie sanitaire - Flexibles de douches pour Sanitärarmaturen - Brauseschläuche für Sanitärarmaturen
robinetterie sanitaire pour les systèmes d'alimentation en für Wasserversorgungssysteme vom Typ 1 und Typ 2 -
eau de types 1 et 2 - Spécifications techniques générales Allgemeine technische Spezifikation
This draft amendment is submitted to CEN members for unique acceptance procedure. It has been drawn up by the Technical Committee
CEN/TC 164.
This draft amendment A1, if approved, will modify the European Standard EN 1113:2008. If this draft becomes an amendment, CEN
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this amendment
into the relevant national standard without any alteration.
This draft amendment was established by CEN in three official versions (English, French, German). A version in any other language made
by translation under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same
status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2010 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1113:2008/FprA1:2010: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 1113:2009/kFprA1:2010
EN 1113:2008/FprA1:2010 (E)
Contents Page
Foreword .3
1 Modification to the Scope .4
2 Modification to 8.2 .5
3 Modification to the keys of Figure 9 .7
4 Modification to 9.3.4 .7
5 Modification to 9.3.5 .7
6 Modification to 10.2.3 .8
2
---------------------- Page: 4 ----------------------
SIST EN 1113:2009/kFprA1:2010
EN 1113:2008/FprA1:2010 (E)
Foreword
This document (EN 1113:2008/FprA1:2010) has been prepared by Technical Committee CEN/TC 164 “Water supply”,
the secretariat of which is held by AFNOR.
This document is currently submitted to the Unique Acceptance Procedure.
3
---------------------- Page: 5 --------
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.