CEN/TS 14775:2004
(Main)Solid biofuels - Method for the determination of ash content
Solid biofuels - Method for the determination of ash content
This document specifies a method for the determination of ash content of all solid biofuels (CEN/TS 14588).
Feste Biobrennstoffe - Verfahren zur Bestimmung des Aschegehaltes
Die folgenden zitierten Dokumente sind für die Anwendung dieses Dokuments erforderlich. Bei datierten Verweisungen gilt nur die in Bezug genommene Ausgabe. Bei undatierten Verweisungen gilt die letzte Ausgabe des in Bezug genommenen Dokuments (einschließlich aller Änderungen).
CEN/TS 14588:2003, Feste Biobrennstoffe - Terminologie, Definitionen und Beschreibung.
CEN/TS 14774-3, Feste Biobrennstoffe - Verfahren zur Bestimmung des Wassergehaltes - Teil 3: Wasser in gewöhnlichen Analysenproben.
prCEN/TS 14779, Feste Biobrennstoffe - Verfahren zur Erstellung von Probenahmeplänen und -zertifikaten.
prCEN/TS 14780, Feste Biobrennstoffe - Verfahren der Probenteilung.
Biocombustibles solides - Méthode détermination de la teneur en cendre
Trdna biogoriva – Metoda določevanja pepela
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-november-2004
7UGQDELRJRULYD±0HWRGDGRORþHYDQMDSHSHOD
Solid biofuels - Method for the determination of ash content
Feste Biobrennstoffe - Verfahren zur Bestimmung des Aschegehaltes
Biocombustibles solides - Méthode détermination de la teneur en cendre
Ta slovenski standard je istoveten z: CEN/TS 14775:2004
ICS:
75.160.10 Trda goriva Solid fuels
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
TECHNICAL SPECIFICATION
CEN/TS 14775
SPÉCIFICATION TECHNIQUE
TECHNISCHE SPEZIFIKATION
August 2004
ICS 75.160.10
English version
Solid biofuels - Method for the determination of ash content
Feste Biobrennstoffe - Verfahren zur Bestimmung des
Aschegehaltes
This Technical Specification (CEN/TS) was approved by CEN on 5 February 2004 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to submit their
comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS available
promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the CEN/TS)
until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2004 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 14775:2004: E
worldwide for CEN national Members.
Contents Page
Foreword.3
1 Scope .4
2 Normative references .4
3 Terms and definitions .4
4 Principle.4
5 Apparatus .4
5.1 Dish .4
5.2 Furnace .5
5.3 Balance .5
5.4 Desiccator.5
6 Preparation of test sample.5
7 Procedure .5
8 Calculations.6
9 Precision.6
10 Test Report.7
Annex A .8
Bibliography .9
Foreword
This document (CEN/TS 14775:2004) has been prepared by Technical Committee CEN/TC 335 “Solid
Biofuels”, the secretariat of which is held by SIS.
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to announce this CEN Technical Specification : Austria, Belgium, Cyprus, Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland
and United Kingdom.
1 Scope
This document specifies a method for the determination of ash content of all solid biofuels (CEN/TS 14588).
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
CEN/TS 14588:2003, Solid biofuels – Terminology, definitions and description
CEN/TS 14774-3, Solid Biofuels – Method for the determination of moisture content – Oven dry method – Part
3: Moisture in general analysis sample
prCEN/TS 14779, Solid Biofuels – Methods for preparing sampling plans and sampling certificates
prCEN/TS 14780, Solid Biofuels – Methods for sample reduction
3 Terms and definitions
For the purpose of this document, the terms and definitions given in CEN/TS 14588:2003 and the following
apply.
3.1
Ash content, dry basis
Mass of inorganic residue remaining after ignition of a fuel under specified conditions expressed as a
percentage of the mass of the dry matter in the fuel
4 Principle
The ash content is determined by calculation from the mass of the residue remaining after the sample is
heated in air under rigidly controlled conditions of time, sample weight and equipment specifications to a
controlled temperature of (550±10) °C.
NOTE Difference in the ash content determined at a higher temperature, 815 °C, according to ISO 1171-1997,
compared to 550 °C can be explained by the loss of volatile inorganic compounds, further oxidation (higher oxidation
state) of inorganic compounds and the decomposition of carbo
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.