EN 50083-2-4:2019
(Main)Cable networks for television signals, sound signals and interactive services - Part 2-4: Interference Mitigation Filters operating in the 700 MHz and 800 MHz bands for DTT reception
Cable networks for television signals, sound signals and interactive services - Part 2-4: Interference Mitigation Filters operating in the 700 MHz and 800 MHz bands for DTT reception
This document provides requirements for passive filters intended to reduce RF interference from mobile Base Stations (BS) and User Equipment (UE) to receiving equipment and master antenna cable distribution systems of broadcast DVB-T and DVB-T2 signals in the VHF and UHF bands. While primarily intended to be used with VHF/UHF DVB-T and DVB-T2 receivers and signal distribution systems, filters can also be useful for mitigation of interference to VHF FM or DAB radio.
Kabelnetze für Fernsehsignale, Tonsignale und interaktive Dienste - Teil 2-4: Filter zur Vermeidung von Störungen in den 700-MHz- und 800-MHz-Bändern für DTT-Empfang
Réseaux de distribution par câbles pour signaux de télévision, signaux de radiodiffusion sonore et services interactifs - Partie 2-4: Filtres d'atténuation de brouillage fonctionnant dans les bandes 700 MHz et 800 MHz pour la réception TNT
Le présent document établit les exigences relatives aux filtres passifs destinés à réduire le brouillage RF transmis par les stations de base (BS) mobiles et les matériels d'utilisateur (UE) aux matériels de réception et aux réseaux de distribution par câbles à antenne collective des signaux de radiodiffusion DVB-T et DVB-T2 dans les bandes VHF et UHF. Même s'ils sont essentiellement destinés à être utilisés avec des récepteurs et des réseaux de distribution de signaux VHF/UHF DVB-T et DVB-T2, ces filtres peuvent également être utiles dans le cadre de l'affaiblissement du brouillage sur les bandes radio VHF FM ou DAB.
Kabelska omrežja za televizijske in zvokovne signale ter interaktivne storitve - 2-4. del: Filtri za dušenje motenj, ki delujejo v pasovih 700 MHz in 800 MHz, za sprejem DTT
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
01-november-2020
Kabelska omrežja za televizijske in zvokovne signale ter interaktivne storitve - 2-4.
del: Filtri za dušenje motenj, ki delujejo v pasovih 700 MHz in 800 MHz, za sprejem
DTT
Cable networks for television signals, sound signals and interactive services - Part 2-4:
Interference Mitigation Filters operating in the 700 MHz and 800 MHz bands for DTT
reception
Kabelnetze für Fernsehsignale, Tonsignale und interaktive Dienste - Teil 2-4: Filter zur
Vermeidung von Störungen in den 700 MHz- und 800 MHz-Bändern für DTT-Empfang
Réseaux de distribution par câbles pour signaux de télévision, signaux de radiodiffusion
sonore et services interactifs - Partie 2-4: Filtres d'atténuation de brouillage fonctionnant
dans les bandes 700 MHz et 800 MHz pour la réception TNT
Ta slovenski standard je istoveten z: EN 50083-2-4:2019
ICS:
33.060.40 Kabelski razdelilni sistemi Cabled distribution systems
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN 50083-2-4
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2019
ICS 33.060.40
English Version
Cable networks for television signals, sound signals and
interactive services - Part 2-4: Interference Mitigation Filters
operating in the 700 MHz and 800 MHz bands for DTT reception
Réseaux de distribution par câbles pour signaux de Kabelnetze für Fernsehsignale, Tonsignale und interaktive
télévision, signaux de radiodiffusion sonore et services Dienste - Teil 2-4: Filter zur Vermeidung von Störungen in
interactifs - Partie 2-4: Filtres d'atténuation de brouillage den 700 MHz- und 800 MHz-Bändern für DTT-Empfang
fonctionnant dans les bandes 700 MHz et 800 MHz pour la
réception TNT
This European Standard was approved by CENELEC on 2019-11-25. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 50083-2-4:2019 E
Contents Page
European Foreword .3
Introduction .3
1 Scope .5
2 Normative references .5
3 Terms, definitions and abbreviations .5
3.1 Terms and definitions .5
3.2 Abbreviations .6
4 Filter characteristics.6
4.1 General .6
4.2 Pass-band and stop-band .6
4.3 Types of standard filter .6
4.4 Filter specifications .7
4.5 Connections, EMC, environmental and other factors.8
4.5.1 Connections .8
4.5.2 EMC – Screening effectiveness .8
4.5.3 DC and 50 Hz line power considerations .8
4.5.4 Climate and operating temperature range .8
4.5.5 Drop test .8
4.5.6 Fixings .9
4.6 Information to be supplied by the manufacturer or responsible vendor .9
European Foreword
This document (EN 50083-2-4:2019) has been prepared by CLC/TC 209 “Cable networks for television
signals, sound signals and interactive services”.
The following dates are fixed:
• latest date by which this document has (dop) 2020-11-25
to be implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2022-11-25
standards conflicting with this document
have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Introduction
Standards and deliverables of EN 60728 series and EN 50083 series deal with cable networks including
equipment and associated methods of measurement for headend reception, processing and distribution of
television and sound signals and for processing, interfacing and transmitting all kinds of data signals for
interactive services using all applicable transmission media. These signals are typically transmitted in
networks by frequency-multiplexing techniques.
This includes, for instance:
a) regional and local broadband cable networks;
b) extended satellite and terrestrial television distribution systems;
c) individual satellite and terrestrial television receiving systems;
and all kinds of equipment, systems and installations used in such cable networks, distribution and receiving
systems.
The extent of this standardization work is from the antennas and/or special signal source inputs to the
headend or other interface points to the network up to the terminal input of the customer premises
equipment.
The standardization work will consider coexistence with users of the RF spectrum in wired and wireless
transmission systems.
The standardization of any user terminals (i.e. tuners, receivers, decoders, multimedia terminals etc.) as well
as of any coaxial, balanced and optical cables and accessories thereof is excluded.
This document introduces the requirements for DTT filters with stop-bands for the 700 MHz and 800 MHz
bands. These filters are for use in individual and MATV antenna installations for reception of DTT signals
when the 700 MHz band will be used by telecommunication services in addition to the 800 MHz band.
These requirements extend those of CLC/TS 50083-2-3 for mitigation filters for LTE services operating in the
800 MHz band only and ETSI EN 303 354 V.1.1.1 (2017-03), that deals with “Amplifiers and active antennas
for TV broadcast reception in domestic premises; Harmonized standard covering the essential requirements
of article 3.2 of Directive 2014/53/EU”. The ETSI document is mainly applicable to new equipment available
on the market, while this document has the purpose to allow the existing individual and MATV antenna
installations as well as amplifiers designed for the full spectrum of band 4 and 5 for reception of DTT signals
to avoid or mitigate the interference due to the new telecommunication services when the 700 MHz band is
added to the 800 MHz band already used.
These DTT filters are not designed to be used for CATV networks.
1 Scope
This document provides requirements for passive filters intended to reduce RF interference from mobile
Base Stations (BS) and User Equipment (UE) to receiving equipment and master antenna cable distribution
systems of broadcast DVB-T and DVB-T2 signals in the VHF and UHF bands. While primarily intended to be
used with VHF/UHF DVB-T and DVB-T2 receivers and signal distribution systems, filters can also be useful
for mitigation of interference to VHF FM or DAB radio.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes
requirements of this document. For dat
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.