Admixtures for concrete, mortar and grout - Part 4: Admixtures for grout for prestressing tendons - Definitions, requirements, conformity, marking and labelling

This European Standard defines and specifies requirements and conformity criteria for admixtures for the use in grouts for prestressing tendons according to EN 447. It covers admixtures for use in site ) mixed grout only.
Provisions for the use of grout admixtures are not part of this standard but are covered by EN 447.

Zusatzmittel für Beton, Mörtel und Einpressmörtel - Teil 4: Zusatzmittel für Einpressmörtel für Spannglieder - Definitionen, Anforderungen, Konformität, Kennzeichnung und Beschriftung

Diese Europäische Norm enthält Definitionen, Festlegungen für Anforderungen und Konformitätskriterien für
Zusatzmittel für die Verwendung in Einpressmörtel für Spannglieder nach EN 447. Sie gilt nur für Zusatzmittel für
auf der Baustelle gemischten Einpressmörtel1).
Bestimmungen über die Anwendung von Zusatzmitteln für Einpressmörtel sind nicht Bestandteil dieser Norm,
sondern werden in EN 447 behandelt.

Adjuvants pour béton, mortier et coulis - Partie 4: Adjuvants pour coulis de câble de précontrainte - Définitions, exigences, conformité, marquage et étiquetage

La présente Norme Européenne définit et spécifie les exigences et les critères de conformité pour les adjuvants devant être utilisés dans les coulis pour câbles de précontrainte conformes à l'EN 447. Elle traite uniquement des adjuvants pour coulis fabriqué sur chantier.
Les dispositions relatives à l'utilisation des adjuvants pour coulis ne font pas partie de la présente norme mais sont traitées dans l'EN 447.

Kemijski dodatki za beton, malto in injekcijsko maso - 4. del: Kemijski dodatki za injekcijsko maso za prednapete kable - Definicije, zahteve, skladnost, označevanje in obeleževanje

General Information

Status
Published
Publication Date
26-May-2009
Current Stage
9093 - Decision to confirm - Review Enquiry
Completion Date
18-Jun-2021

Relations

Buy Standard

Standard
EN 934-4:2009
English language
19 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 934-4:2009
01-september-2009
1DGRPHãþD
SIST EN 934-4:2002
SIST EN 934-4:2002/A1:2004
.HPLMVNLGRGDWNL]DEHWRQPDOWRLQLQMHNFLMVNRPDVRGHO.HPLMVNLGRGDWNL]D
LQMHNFLMVNRPDVR]DSUHGQDSHWHNDEOH'HILQLFLMH]DKWHYHVNODGQRVWR]QDþHYDQMH
LQREHOHåHYDQMH
Admixtures for concrete, mortar and grout - Part 4: Admixtures for grout for prestressing
tendons - Definitions, requirements, conformity, marking and labelling
Zusatzmittel für Beton, Mörtel und Einpressmörtel - Teil 4: Zusatzmittel für
Einpressmörtel für Spannglieder - Definitionen, Anforderungen, Konformität,
Kennzeichnung und Beschriftung
Adjuvants pour béton, mortier et coulis - Partie 4: Adjuvants pour coulis de câble de
précontrainte - Définitions, exigences, conformité, marquage et étiquetage
Ta slovenski standard je istoveten z: EN 934-4:2009
ICS:
91.100.10 Cement. Mavec. Apno. Malta Cement. Gypsum. Lime.
Mortar
91.100.30 Beton in betonski izdelki Concrete and concrete
products
SIST EN 934-4:2009 en,fr
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 934-4:2009

---------------------- Page: 2 ----------------------

SIST EN 934-4:2009
EUROPEAN STANDARD
EN 934-4
NORME EUROPÉENNE
EUROPÄISCHE NORM
May 2009
ICS 91.100.30 Supersedes EN 934-4:2001
English Version
Admixtures for concrete, mortar and grout - Part 4: Admixtures
for grout for prestressing tendons - Definitions, requirements,
conformity, marking and labelling
Adjuvants pour béton, mortier et coulis - Partie 4: Adjuvants Zusatzmittel für Beton, Mörtel und Einpressmörtel - Teil 4:
pour coulis de câble de précontrainte - Définitions, Zusatzmittel für Einpressmörtel für Spannglieder -
exigences, conformité, marquage et étiquetage Definitionen, Anforderungen, Konformität, Kennzeichnung
und Beschriftung
This European Standard was approved by CEN on 24 April 2009.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the CEN Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the CEN Management Centre has the same status as the
official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal,
Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2009 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 934-4:2009: E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN 934-4:2009
EN 934-4:2009 (E)
Contents Page
Foreword .3
1 Scope .4
2 Normative references .4
3 Terms and definitions .4
4 Composition and preparation of test mix .5
4.1 Constituent materials .5
4.2 Water/cement ratio.5
4.3 Fluidity .5
4.4 Mixing .5
5 Requirements .5
5.1 General .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.