EN ISO 23537-2:2023
(Main)Requirements for sleeping bags - Part 2: Fabric and material properties (ISO 23537-2:2023)
Requirements for sleeping bags - Part 2: Fabric and material properties (ISO 23537-2:2023)
This document specifies the fabric and material properties as well as provisions for labelling of adult sized sleeping bags for use in sports and leisure time activities.
This document does not apply to sleeping bags intended for specific purposes such as military use and extreme climate zone expedition. It does not apply to sleeping bags for children or babies.
Anforderungen an Schlafsäcke - Teil 2: Gewebe- und Werkstoffeigenschaften (ISO 23537-2:2023)
Dieses Dokument legt die Gewebe- und Werkstoffeigenschaften sowie Bestimmungen zur Kennzeichnung von Schlafsäcken für Erwachsene fest, die bei Sport und Freizeitaktivitäten benutzt werden.
Dieses Dokument ist nicht anwendbar für Schlafsäcke, die für besondere Zwecke vorgesehen sind, wie z. B. die militärische Verwendung und die Verwendung bei Expeditionen in extremen Klimazonen. Es ist nicht anwendbar für Schlafsäcke für Kinder oder Säuglinge.
Exigences pour les sacs de couchage - Partie 2: Propriétés de l'étoffe et des matières (ISO 23537-2:2023)
Le présent document spécifie les propriétés de l’étoffe et des matières, ainsi que les dispositions à prendre concernant l’étiquetage des sacs de couchage pour adultes utilisés pour les sports et loisirs.
Le présent document ne s’applique pas aux sacs de couchage à usage spécifique, comme ceux destinés à un usage militaire ou utilisés dans le cadre d’expéditions dans des conditions climatiques extrêmes. Il ne s’applique pas non plus aux sacs de couchage pour enfants ou bébés (appelés gigoteuses).
Zahteve za spalne vreče - 2. del: Lastnosti tkanine in materiala (ISO 23537-2:2023)
Ta dokument določa lastnosti tkanine in materiala ter določbe za označevanje spalnih vreč za odrasle za uporabo v športnih in prostočasnih dejavnostih.
Dokument se ne uporablja za spalne vreče za posebne namene, na primer za uporabo v vojski in ekstremnih podnebnih razmerah. Standard se ne uporablja za spalne vreče za otroke ali dojenčke.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-november-2023
Nadomešča:
SIST EN ISO 23537-2:2017
Zahteve za spalne vreče - 2. del: Lastnosti tkanine in materiala (ISO 23537-2:2023)
Requirements for sleeping bags - Part 2: Fabric and material properties (ISO 23537-
2:2023)
Anforderungen an Schlafsäcke - Teil 2: Gewebe- und Werkstoffeigenschaften (ISO
23537-2:2023)
Exigences pour les sacs de couchage - Partie 2: Propriétés de l'étoffe et des matières
(ISO 23537-2:2023)
Ta slovenski standard je istoveten z: EN ISO 23537-2:2023
ICS:
97.200.30 Oprema za taborjenje in Camping equipment and
tabori camp-sites
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EN ISO 23537-2
EUROPEAN STANDARD
NORME EUROPÉENNE
August 2023
EUROPÄISCHE NORM
ICS 97.200.30 Supersedes EN ISO 23537-2:2016
English Version
Requirements for sleeping bags - Part 2: Fabric and
material properties (ISO 23537-2:2023)
Exigences pour les sacs de couchage - Partie 2: Anforderungen an Schlafsäcke - Teil 2: Gewebe- und
Propriétés de l'étoffe et des matières (ISO 23537- Werkstoffeigenschaften (ISO 23537-2:2023)
2:2023)
This European Standard was approved by CEN on 28 July 2023.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 23537-2:2023 E
worldwide for CEN national Members.
Contents Page
European foreword . 3
European foreword
This document (EN ISO 23537-2:2023) has been prepared by Technical Committee ISO/TC 83 "Sports
and other recreational facilities and equipment" in collaboration with Technical Committee CEN/TC
136 “Sports, playground and other recreational facilities and equipment” the secretariat of which is held
by DIN.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by February 2024, and conflicting national standards
shall be withdrawn at the latest by February 2024.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 23537-2:2016.
Any feedback and questions on this document should be directed to the users’ national standards
body/national committee. A complete listing of these bodies can be found on the CEN website.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Türkiye and the
United Kingdom.
Endorsement notice
The text of ISO 23537-2:2023 has been approved by CEN as EN ISO 23537-2:2023 without any
modification.
INTERNATIONAL ISO
STANDARD 23537-2
Second edition
2023-08
Requirements for sleeping bags —
Part 2:
Fabric and material properties
Exigences pour les sacs de couchage —
Partie 2: Propriétés de l'étoffe et des matières
Reference number
ISO 23537-2:2023(E)
ISO 23537-2:2023(E)
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
ISO 23537-2:2023(E)
Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Requirements and test methods . 2
4.1 Fabrics . 2
4.1.1 Down proofness . 2
4.1.2 Synthetic fibre proofness. 2
4.1.3 Mechanical properties . . 2
4.2 Filling material . 3
4.2.1 Feather and/or down . 3
4.2.2 Filling material other than feather and/or down – Mass per unit area . 3
4.3 Finished articles . 3
4.3.1 Inside dimensions . . 3
4.3.2 Total mass . 4
4.3.3 Volume under load . 4
5 Test report . 4
6 Marking . . 4
7 Information supplied to the consumer . 5
7.1 Mandatory information . 5
7.2 Optional information . 6
iii
ISO 23537-2:2023(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described in the ISO/IEC Directives, Part 1. In particular, the different approval criteria needed for the
different types of ISO document should be noted. This document was drafted in accordance with the
editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives).
ISO draws attention to the possibility that the implementation of this document may involve the use
of (a) patent(s). ISO takes no position concerning the evidence, validity or applicability of any claimed
patent rights in respect thereof. As of the date of publication of this document, ISO had not received
notice of (a) patent(s) which may be required to implement this document. However, implementers are
cautioned that this may not represent the latest information, which may be obtained from the patent
database available at www.iso.org/patents. ISO shall not be held responsible for identifying any or all
such patent rights.
Any trade name used in this document is information given for the convenience of users and does not
constitute an endorsement.
For an explanation of the voluntary nature of standards, the meaning of ISO specific terms and
expressions related to conformity assessment, as well as information about ISO's adherence to
the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see
www.iso.org/iso/foreword.html.
This document was prepared by Technical Committee ISO/TC 83, Sports and other recreational facilities
and equipment, in collaboration with the European Committee for Standardization (CEN) Technical
Committee CEN/TC 136, Sports, playground and other recreational facilities and equipment, in accordance
with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement).
This second edition cancels and replaces the first edition (ISO 23537-2:2016), which has been technically
revised.
The main changes are as follows:
— the requirement for colour fastness has been clarified to avoid misunderstanding (see 4.1.3.3);
— normative references have been updated (see Clause 2).
A list of all parts in the ISO 23537 series can be found on the ISO website.
Any feedback or questions on this document should be directed to the user’s national standards body. A
complete listing of these bodies can be found at www.iso.org/members.html.
iv
ISO 23537-2:2023(E)
Introduction
The ISO 23537 series consists of two parts, which allows for separate validation of thermal properties
and product and material performance. This separation of parts also allows for continued development
of new product combinations as it encourages manufacturers to consider new combinations of materials
which, for example, are not suitable to be tested by traditional textile physical tests, but which can still
have thermal properties evaluated.
This document considers important aspects concerning the physical and performance properties of the
sleeping bag. Thermal and dimensional requirements are specified in ISO 23537-1.
NOTE No prediction model exists for the determination of the limit temperatures based on the thermal
resistance of the sleeping bag for children and babies. Moreover, such a model for testing cannot be developed
because the necessary controlled sleep trials with children or babies in climatic chambers are, out of ethical
reasons, not possible.
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.