EN 1970:2000/A1:2005
(Amendment)Adjustable beds for disabled persons - Requirements and test methods
Adjustable beds for disabled persons - Requirements and test methods
This standard specifies essential requirements and related test methods for non-electrically and electrically operated adjustable beds, including detachable bed boards, bed lifts, side rails, grab handles and lifting poles intended to be used by disabled persons to alleviate or compensate for a disability or handicap. The standard also applies to stand up beds. The standard does not apply to lateral tilt beds.
Verstellbare Betten für behinderte Menschen - Anforderungen und Prüfverfahren
Lits réglables pour les personnes handicapées - Exigences et méthodes d'essai
Nastavljive postelje za invalidne osebe - Zahteve in preskusne metode
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-junij-2005
Nastavljive postelje za invalidne osebe - Zahteve in preskusne metode
Adjustable beds for disabled persons - Requirements and test methods
Verstellbare Betten für behinderte Menschen - Anforderungen und Prüfverfahren
Lits réglables pour les personnes handicapées - Exigences et méthodes d'essai
Ta slovenski standard je istoveten z: EN 1970:2000/A1:2005
ICS:
11.180 3ULSRPRþNL]DLQYDOLGHLQ Aids for disabled or
IXQNFLRQDOQRRYLUDQHRVHEH handicapped persons
97.140 Pohištvo Furniture
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD
EN 1970:2000/A1
NORME EUROPÉENNE
EUROPÄISCHE NORM
March 2005
ICS 11.180; 97.140
English version
Adjustable beds for disabled persons - Requirements and test
methods
Lits réglables pour les personnes handicapées - Exigences Verstellbare Betten für behinderte Menschen -
et méthodes d'essai Anforderungen und Prüfverfahren
This amendment A1 modifies the European Standard EN 1970:2000; it was approved by CEN on 3 February 2005.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for inclusion of this
amendment into the relevant national standard without any alteration. Up-to-date lists and bibliographical references concerning such
national standards may be obtained on application to the Central Secretariat or to any CEN member.
This amendment exists in three official versions (English, French, German). A version in any other language made by translation under the
responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2005 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 1970:2000/A1:2005: E
worldwide for CEN national Members.
Contents
Page
Foreword .3
Introduction.4
1 Modification to Clause 2 Normative references .4
2 Modification to subclause 5.11 Electrotechnical requirements .4
3 Modification to Clause 6 Instruction for use .4
4 Modification to Clause 7 Marking .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.