EN 40-3-1:2013

Lighting columns - Part 3-1: Design and verification - Specification for characteristic loads

This European Standard specifies design loads for lighting columns. It applies to lighting columns of nominal height (including any bracket) not exceeding 20 m. Special structural designs to permit the attachment of signs, overhead wires, etc. are not covered by this European Standard.
The requirements for lighting columns made from materials other than concrete, steel, aluminium or fibre reinforced polymer composite (for example wood, plastic and cast iron) are not specifically covered in this standard. Fibre reinforced polymer composite lighting columns are covered in this document, in conjunction with Annex B of EN 40-7:2002.
This European Standard includes performance requirements for horizontal loads due to wind. Passive safety and the behaviour of a lighting column under the impact of a vehicle are not addressed. Such lighting columns will have additional requirements (see EN 12767).

Lichtmaste - Teil 3-1: Bemessung und Nachweis - Charakteristische Werte der Lasten

Diese Europäische Norm legt Bemessungslasten für Lichtmaste fest. Sie gilt für Lichtmaste (einschließlich jegliche Ausleger) mit einer Nennhöhe bis zu 20 m. Besondere Bauformen, die das Anbringen von Verkehrsschildern, Freileitungen usw. ermöglichen, werden durch diese Europäische Norm nicht erfasst.
Die Anforderungen an Lichtmaste aus anderen Werkstoffen als Beton, Stahl, Aluminium oder faserverstärktem Polymerverbundstoff (z. B. Holz, Kunststoff und Gusseisen) werden in dieser Norm nicht besonders behandelt. Lichtmaste aus faserverstärktem Polymerverbundstoff werden in dieser Norm behandelt, in Verbindung mit EN 40-7:2002, Anhang B.
Diese Europäische Norm enthält Leistungsanforderungen hinsichtlich horizontaler Lasten aus Wind. Passive Sicherheit und das Verhalten des Lichtmastes bei einem Anprall eines Fahrzeuges werden nicht behandelt. Für diese Lichtmaste gelten zusätzliche Anforderungen (siehe EN 12767).

Candélabres d'éclairage public - Partie 3-1: Conception et vérification - Spécification pour charges caractéristiques

La présente Norme européenne spécifie les charges de calcul des candélabres d'éclairage public. Elle s’applique aux candélabres d’éclairage public d’une hauteur nominale (avec la crosse) ne dépassant pas 20 m. Les conceptions structurelles particulières permettant de fixer des panneaux de signalisation, des fils aériens, etc., ne sont pas traitées dans la présente Norme européenne.
Les exigences relatives aux candélabres d'éclairage public réalisés dans d'autres matériaux que le béton, l'acier, l'aluminium ou le composite polymère renforcé de fibres (par exemple le bois, le plastique et la fonte) ne sont pas spécifiquement traitées dans la présente norme. Les candélabres d’éclairage public en composite polymère renforcé de fibres sont traités dans le présent document, conjointement avec l'Annexe B de l'EN 40-7:2002.
La présente Norme européenne inclut les exigences de performance pour les charges horizontales dues au vent. La sécurité passive et le comportement d'un candélabre d'éclairage public soumis à l'impact d'un véhicule ne sont pas abordés. Des exigences supplémentaires s’appliqueront à cette catégorie de candélabres (voir EN 12767).

Drogovi za razsvetljavo - Projektiranje in preverjanje - 3-1. del: Specifikacija za značilne obtežbe

Ta evropski standard določa projektne obtežbe za drogove za razsvetljavo. Velja za drogove za razsvetljavo nazivne višine (vključno z vsemi nosilci), ki ne presega 20 m. Posebno projektiranje konstrukcij, ki omogoča namestitev znakov, nadzemnih žic itd., ni obravnavano v tem evropskem standardu. V tem standardu niso posebej obravnavane zahteve za drogove za razsvetljavo, ki niso izdelani iz betona, jekla, aluminija ali vlaknatoarmiranega polimernega kompozita (npr. les, plastika in železova litina). Drogovi za razsvetljavo iz vlaknatoarmiranega polimernega kompozita so obravnavani v tem dokumentu v povezavi z dodatkom B standarda EN 40-7:2002. Ta evropski standard vključuje zahteve glede zmogljivosti za vodoravne obtežbe zaradi vetra. Pasivna varnost in učinek, ki ga ima trčenje vozila na drog za razsvetljavo, nista obravnavana. Za takšne drogove za razsvetljavo se bodo uporabljale dodatne zahteve (glej EN 12767).

General Information

• Status: Published
• Publication Date: 19-Feb-2013
• Withdrawal Date: 30-Aug-2013
• ICS: 91.160.20 - Exterior building lighting
• ICS: 93.080.40 - Street lighting and related equipment
• Technical Committee: CEN/TC 50 - Lighting columns and spigots
• Drafting Committee: CEN/TC 50/WG 5 - Revision of product standards
• Current Stage: 9092 - Decision on results of review/2YR ENQ - revise - Review Enquiry
• Completion Date: 16-Nov-2018
• Directive: 305/2011 - Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec
• Directive: 89/106/EEC - Construction products
• Mandate: M/111 - Mandate to CEN/CENELEC concerning the execution of standardization work for harmonized standards on circulation fixtures
• Ref Project: SIST EN 40-3-1:2013 - Lighting columns - Design and verification - Part 3-1: Specification for characteristic loads

Relations

• Replaces: EN 40-3-1:2000 - Lighting columns - Part 3-1: Design and verification - Specification for characteristic loads
• Effective Date: 27-Feb-2013

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Lichtmaste - Bemessung und Nachweis - Teil 3-1: Charakteristische Werte der LastenCandélabres d'éclairage public - Conception et vérification - Partie 3-1: Spécification pour charges caractéristiquesLighting columns - Design and verification - Part 3-1: Specification for characteristic loads93.080.40Street lighting and related equipment91.160.20Zunanja razsvetljava stavbExterior building lightingICS:Ta slovenski standard je istoveten z:EN 40-3-1:2013SIST EN 40-3-1:2013en,fr,de01-maj-2013SIST EN 40-3-1:2013SLOVENSKI
STANDARDSIST EN 40-3-1:20011DGRPHãþD



SIST EN 40-3-1:2013



EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 40-3-1
February 2013 ICS 93.080.40 Supersedes EN 40-3-1:2000English Version
Lighting columns - Part 3-1: Design and verification - Specification for characteristic loads
Candélabres d'éclairage public - Partie 3-1: Conception et vérification - Spécification pour charges caractéristiques
Lichtmaste - Teil 3-1: Bemessung und Nachweis - Charakteristische Werte der Lasten This European Standard was approved by CEN on 25 November 2012.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2013 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 40-3-1:2013: ESIST EN 40-3-1:2013



EN 40-3-1:2013 (E) 2 Contents Page Foreword .3 1 Scope .4 2 Normative references .4 3 Terms and definitions .4 4 Symbols .4 5 Basis of loads .5 5.1 Dead loads .5 5.2 Wind pressures .5 5.2.1 General .5 5.2.2 Reference wind pressure q(10) .6 5.2.3 Factor for column size δ .6 5.2.4 Factor for the dynamic behaviour of lighting columns, β .6 5.2.5 Topography factor f .7 5.2.6 Exposure coefficient ce(z) .7 5.3 Shape coefficient .9 5.3.1 Shape coefficient for columns and brackets with circular cross-sections .
...