Integrated circuit - EMC evaluation of transceivers - Part 6: PSI5 transceivers

This document specifies test and measurement methods for EMC evaluation of Peripheral Sensor Interface 5 (PSI5) transceiver integrated circuits (ICs) under network condition. It defines test configurations, test conditions, test signals, failure criteria, test procedures, test setups and test boards. It is applicable for PSI5 satellite ICs (e.g. sensors) and ICs with embedded PSI5 transceivers (e.g. PSI5 Electronic control unit IC). The document covers - the emission of RF disturbances, - the immunity against RF disturbances, - the immunity against impulses and - the immunity against electrostatic discharges (ESD).

Integrierte Schaltungen - Bewertung der elektromagnetischen Verträglichkeit von Sende-Empfangsgeräten - Teil 6: PSI5-Transceiver

Circuits intégrés - Évaluation de la CEM des émetteurs-récepteurs - Partie 6: Émetteurs-récepteurs PSI5

L’IEC 62228-6:2022 spécifie les méthodes d’essai et de mesure pour l’évaluation de la compatibilité électromagnétique (CEM) des circuits intégrés (CI) émetteurs-récepteurs PSI5 (Peripheral Sensor Interface 5) placés en réseau. Elle définit les montages d’essai, les conditions d’essai, les signaux d’essai, les critères de défaillance, les modes opératoires d’essai, les montages d’essai et les cartes d’essai. Elle est applicable aux CI satellites PSI5 (par exemple capteurs) et aux CI avec émetteurs-récepteurs PSI5 intégrés (par exemple CI d’unité de commande électronique PSI5). Le présent document couvre  
l’émission de perturbations radioélectriques,
l’immunité aux perturbations radioélectriques,
l’immunité aux impulsions, et
l’immunité aux décharges électrostatiques (DES).

Integrirana vezja - Vrednotenje elektromagnetne združljivosti (EMC) oddajnikov-sprejemnikov - 6. del: Oddajniki-sprejemniki PSI5 (IEC 62228-6:2022)

Ta dokument določa preskusne in merilne metode za vrednotenje elektromagnetne združljivosti (EMC) integriranih vezij oddajnikov-sprejemnikov PSI5. Opredeljuje konfiguracije preskusov, preskusne pogoje, preskusne signale, merila za neuspešno opravljen preskus, preskusne postopke, nastavitve preskusa in preskusne plošče. Uporablja se za satelitska integrirana vezja PSI5 (npr. senzorji) in integrirana vezja z vdelanimi oddajniki-sprejemniki PSI5 (npr. integrirano vezje elektronske nadzorne enote PSI5). Dokument obravnava:
– oddajanje radiofrekvenčnih motenj;
– odpornost na radiofrekvenčne motnje;
– odpornost na impulze; in
– odpornost na elektrostatične razelektritve (ESD).

General Information

Status
Published
Publication Date
15-Dec-2022
Current Stage
6060 - Document made available - Publishing
Start Date
16-Dec-2022
Due Date
28-Feb-2023
Completion Date
16-Dec-2022

Buy Standard

Standard
EN IEC 62228-6:2023 - BARVE
English language
52 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)


SLOVENSKI STANDARD
01-februar-2023
Integrirana vezja - Vrednotenje elektromagnetne združljivosti (EMC) oddajnikov-
sprejemnikov - 6. del: Oddajniki-sprejemniki PSI5 (IEC 62228-6:2022)
Integrated circuit - EMC Evaluation of transceivers - Part 6: PSI5 transceivers (IEC
62228-6:2022)
Integrierte Schaltungen - EMV-Bewertung von Transceivern - Teil 6: PSI5-Transceiver
(IEC 62228-6:2022)
Circuits intégrés - Évaluation de la CEM des émetteurs-récepteurs - Partie 6: Émetteurs-
récepteurs PSI5 (IEC 62228-6:2022)
Ta slovenski standard je istoveten z: EN IEC 62228-6:2022
ICS:
31.200 Integrirana vezja, Integrated circuits.
mikroelektronika Microelectronics
33.100.01 Elektromagnetna združljivost Electromagnetic compatibility
na splošno in general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EUROPEAN STANDARD EN IEC 62228-6

NORME EUROPÉENNE
EUROPÄISCHE NORM December 2022
ICS 31.200
English Version
Integrated circuit - EMC evaluation of transceivers - Part 6: PSI5
transceivers
(IEC 62228-6:2022)
Circuits intégrés - Évaluation de la CEM des émetteurs- Integrierte Schaltungen - EMV-Bewertung von Transceivern
récepteurs - Partie 6: Émetteurs-récepteurs PSI5 - Teil 6: PSI5-Transceiver
(IEC 62228-6:2022) (IEC 62228-6:2022)
This European Standard was approved by CENELEC on 2022-12-13. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.

European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2022 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN IEC 62228-6:2022 E

European foreword
The text of document 47A/1145/FDIS, future edition 1 of IEC 62228-6, prepared by SC 47A
"Integrated circuits" of IEC/TC 47 "Semiconductor devices" was submitted to the IEC-CENELEC
parallel vote and approved by CENELEC as EN IEC 62228-6:2022.
The following dates are fixed:
• latest date by which the document has to be implemented at national (dop) 2023-09-13
level by publication of an identical national standard or by endorsement
• latest date by which the national standards conflicting with the (dow) 2025-12-13
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national committee. A
complete listing of these bodies can be found on the CENELEC website.
Endorsement notice
The text of the International Standard IEC 62228-6:2022 was approved by CENELEC as a European
Standard without any modification.
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
The following documents are referred to in the text in such a way that some or all of their content
constitutes requirements of this document. For dated references, only the edition cited applies. For
undated references, the latest edition of the referenced document (including any amendments)
applies.
NOTE 1  Where an International Publication has been modified by common modifications, indicated by (mod),
the relevant EN/HD applies.
NOTE 2  Up-to-date information on the latest versions of the European Standards listed in this annex is available
here: www.cenelec.eu.
Publication Year Title EN/HD Year
IEC 61967-1 - Integrated circuits - Measurement of EN IEC 61967-1 -
electromagnetic emissions - Part 1: General
conditions and definitions
IEC 61967-4 - Integrated circuits - Measurement of EN IEC 61967-4 -
electromagnetic emissions - Part 4:
Measurement of conducted emissions - 1
ohm/150 ohm direct coupling method
IEC 62132-1 - Integrated circuits - Measurement of EN 62132-1 -
electromagnetic immunity - Part 1: General
conditions and definitions
IEC 62132-4 - Integrated circuits - Measurement of EN 62132-4 -
electromagnetic immunity 150 kHz to 1 GHz -
Part 4: Direct RF power injection method
IEC 62215-3 - Integrated circuits - Measurement of impulse EN 62215-3 -
immunity - Part 3: Non-synchronous transient
injection method
IEC 62228-1 - Integrated circuits - EMC evaluation of EN IEC 62228-1 -
transceivers - Part 1: General conditions and
definitions
ISO 7637-2 - Road vehicles - Electrical disturbances from - -
conduction and coupling - Part 2: Electrical
transient conduction along supply lines only
ISO 10605 - Road vehicles - Test methods for electrical - -
disturbances from electrostatic discharge

IEC 62228-6 ®
Edition 1.0 2022-11
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
colour
inside
Integrated circuit – EMC evaluation of transceivers –

Part 6: PSI5 transceivers
Circuits intégrés – Évaluation de la CEM des émetteurs-récepteurs –

Partie 6: Émetteurs-récepteurs PSI5

INTERNATIONAL
ELECTROTECHNICAL
COMMISSION
COMMISSION
ELECTROTECHNIQUE
INTERNATIONALE
ICS 31.200 ISBN 978-2-8322-6028-9

– 2 – IEC 62228-6:2022 © IEC 2022
CONTENTS
FOREWORD . 5
1 Scope . 7
2 Normative references . 7
3 Terms, definitions and abbreviated terms . 8
3.1 Terms and definitions . 8
3.2 Abbreviated terms . 8
4 General . 8
5 Test and operating conditions . 11
5.1 Supply and ambient conditions. 11
5.2 Test operation modes . 11
5.3 Test configuration . 13
5.3.1 General test configuration for functional test . 13
5.3.2 General test configuration for unpowered ESD test . 14
5.3.3 Coupling ports for functional tests . 14
5.3.4 Coupling ports for unpowered ESD tests . 16
5.4 Test signals . 17
5.4.1 General . 17
5.4.2 Test signals for Asynchronous mode . 17
5.4.3 Test signal for Synchronous parallel bus mode . 20
5.5 Evaluation criteria . 21
5.5.1 General . 21
5.5.2 Evaluation criteria in functional operation modes during exposure to
disturbances . 22
5.5.3 Evaluation criteria in unpowered condition after exposure to
disturbances . 22
6 Test and measurement . 23
6.1 Emission of RF disturbances . 23
6.1.1 Test method . 23
6.1.2 Test setup . 23
6.1.3 Test procedure and parameters . 25
6.2 Immunity to RF disturbances . 25
6.2.1 Test method . 25
6.2.2 Test setup . 25
6.2.3 Test procedure and parameters . 27
6.3 Immunity to impulses . 29
6.3.1 Test method . 29
6.3.2 Test setup . 29
6.3.3 Test procedure and parameters . 30
6.4 Electrostatic discharge (ESD) . 32
6.4.1 Test method . 32
6.4.2 Test setup . 32
6.4.3 Test procedure and parameters . 34
7 Test report . 35
Annex A (normative) PSI5 test circuits . 36
A.1 General . 36
A.2 Test circuit for emission and immunity tests on a PSI5 ECU IC . 36
A.3 Test circuit for emission and immunity tests on a PSI5 satellite IC . 39

IEC 62228-6:2022 © IEC 2022 – 3 –
A.4 Test circuit for an unpowered ESD test on a PSI5 IC . 41
Annex B (normative) Test circuit boards. 43
B.1 Test circuit board for emission and immunity tests . 43
B.2 ESD test . 43
Annex C (informative) Examples of test limits for PSI5 transceiver in automotive
applications . 44
C.1 General . 44
C.2 Emission of RF disturbances . 44
C.3 Immunity to RF disturbances . 45
C.4 Immunity to Impulses . 48
C.5 ESD . 48
Bibliography . 49

Figure 1 – PSI5 system overview . 9
Figure 2 – Example PSI5 wiring diagram with a single sensor and equivalent model . 10
Figure 3 – PSI5-A configuration with a single sensor connection with two wires . 12
Figure 4 – PSI5-P configuration with two sensor connection .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.