ISO 5129:2001/Amd 1:2013
(Amendment)Acoustics — Measurement of sound pressure levels in the interior of aircraft during flight — Amendment 1
Acoustics — Measurement of sound pressure levels in the interior of aircraft during flight — Amendment 1
Acoustique — Mesurage des niveaux de pression acoustique à l'intérieur des aéronefs en vol — Amendement 1
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 5129
Third edition
2001-10-01
AMendMent 1
2013-05-15
Acoustics — Measurement of sound
pressure levels in the interior of
aircraft during flight
AMendMent 1
Acoustique — Mesurage des niveaux de pression acoustique à
l’intérieur des aéronefs en vol
AMendeMent 1
Reference number
ISO 5129:2001/Amd.1:2013(E)
©
ISO 2013
---------------------- Page: 1 ----------------------
ISO 5129:2001/Amd.1:2013(e)
COPYRIGHt PROteCted dOCUMent
© ISO 2013
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2013 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 5129:2001/Amd.1:2013(e)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International
Standards adopted by the technical committees are circulated to the member bodies for voting.
Publication as an International Standard requires approval by at least 75 % of the member bodies
casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. ISO shall not be held responsible for identifying any or all such patent rights.
Amendment 1 to ISO 5129:2001 was prepared by Technical Committee ISO/TC 43, Acoustics,
Subcommittee SC 1, noise.
© ISO 2013 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 5129:2001/Amd.1:2013(e)
Acoustics — Measurement of sound pressure levels in the
interior of aircraft during flight
AMendMent 1
Page 1, 1.3, line 2
Delete “one-third-octave band sound pressure levels”, insert “one-third-octave-band sound pressure levels”.
Page 1, Clause 2
Replace the preamble by the following text.
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated
references, the latest edition of the referenced document (including any amendments) applies.
Page 1, Clause 2
Delete ISO 31-7, footnote 1), and ISO 266 and insert the following.
ISO 80000-8, Quantities and units — Part 8: Acoustics
Delete IEC 61260, and insert the following.
IEC 61260-1,
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.