SIST-TS CEN/TS 16635:2014
(Main)Railway application - Design for PRM Use - Equipment and Components onboard Rolling Stock - Toilets
Railway application - Design for PRM Use - Equipment and Components onboard Rolling Stock - Toilets
CEN/TS 16635 describes the specific ‘Design for PRM use’ requirements applying to rolling stock on the Trans-European Network (TEN) covered by the TSI for PRM and the assessment of those requirements. Regarding this document, the following statements apply. - The definitions and requirements describe specific aspects of ‘Design for PRM use’ required by persons with reduced mobility as defined in the TSI PRM. - The definitions and requirements of this specification will be used for rolling stock applications. - This specification only refers to aspects of accessibility for PRM passengers; it does not define general requirements and general definitions for specific components and systems. - This specification assumes that the vehicle is in the nominal operating condition; any damage or operating failures will not be taken into account when assessing these requirements. - Where minimum or maximum dimensions are quoted, these are absolute NOT nominal requirements. Measurement methods and/or assessment procedures needed to establish a clear pass/fail assessment are provided where necessary.
Bahnanwendungen - Gestaltung für mobilitätseingeschränkte Menschen - Ausrüstungen und Bauteile in Schienenfahrzeugen - Toiletten
Diese Technische Spezifikation beschreibt die spezifischen Anforderungen und deren Nachweisführung für die „Gestaltung für mobilitätseingeschränkte Menschen“ an Infrastruktur und Fahrzeuge, die auf dem Trans-Europäischen Eisenbahnnetz (TEN) verkehren. Die nachfolgenden Punkte gelten für dieses Dokument:
Die Definitionen und Anforderungen beschreiben bestimmte Aspekte der "Gestaltung für mobilitätseingeschränkte Menschen", die wie in der TSI PRM festgelegt, für mobilitätseingeschränkte Menschen erforderlich sind.
Die Definitionen und Anforderungen dieser Spezifikation gelten für Fahrzeuge.
Diese Spezifikation behandelt ausschließlich spezifische Anforderungen von PRM-Fahrgästen an ausgewählte Bauteile und Systeme. Sie definiert keine allgemeinen Festlegungen für Bauteile und Systeme.
Diese Spezifikation geht von der Annahme aus, dass sich das Fahrzeug im festgelegten Betriebszustand befindet. Bei der Nachweisführung in Bezug auf die Anforderungen sind Beschädigungen oder Betriebsfehler nicht zu berücksichtigen.
Sind Maße für Mindest- oder Höchstabmessungen angegeben, ist zu beachten, dass es sich hierbei NICHT um Nominalwerte handelt.
Wo erforderlich, werden Messverfahren und/oder Verfahren für die Nachweisführung bereitgestellt, wenn diese für die Erstellung von Abnahmekriterien benötigt werden.
Applications ferroviaires - Conception à l'usage des personnes à mobilité réduite - Équipements et éléments à bord du matériel roulant - Toilettes
La présente Spécification Technique décrit les exigences spécifiques relatives à la « conception à l'usage des PMR » s'appliquant au matériel roulant sur le réseau transeuropéen (TEN) couvertes par la STI relative aux PMR, ainsi qu'à l'évaluation de ces exigences. En ce qui concerne le présent document, les déclarations suivantes s’appliquent.
Les définitions et exigences décrivent des aspects spécifiques de « conception à l'usage des PMR » requis par les personnes à mobilité réduite telles que définies dans la STI PMR.
Les définitions et exigences de la présente Spécification seront utilisées pour les applications de matériel roulant.
La présente Spécification ne se rapporte qu'aux aspects d'accessibilité pour les passagers à mobilité réduite. Elle ne définit pas d'exigences et de définitions générales pour des éléments et des systèmes spécifiques.
La présente Spécification suppose que le véhicule se trouve dans les conditions d'exploitation définies ; toute détérioration ou tout mode dégradé ne sera pas pris en compte lors de l'évaluation des exigences.
Lorsque des dimensions minimales ou maximales sont mentionnées, il ne s'agit en aucun cas d'exigences nominales.
Les méthodes de mesure et/ou les modes opératoires d'évaluation nécessaires à l'établissement d'une évaluation claire de succès/échec sont fournis en cas de besoin.
Železniške naprave - Načrtovanje za osebe z omejenimi gibalnimi sposobnostmi - Oprema in sestavni deli na železniških vozilih - Stranišča
Standard CEN/TS 16635 opisuje posebne zahteve za načrtovanje za osebe z omejenimi gibalnimi sposobnostmi, ki se uporabljajo za železniška vozila na vseevropskem železniškem omrežju (TEN) in so obravnavane v tehničnih specifikacijah za interoperabilnost za osebe z omejenimi gibalnimi sposobnostmi, ter oceno teh zahtev. V zvezi s tem dokumentom se uporabljajo naslednje izjave. – Definicije in zahteve opisujejo posebne vidike načrtovanja za osebe z omejenimi gibalnimi sposobnostmi, ki jih potrebujejo osebe z omejenimi gibalnimi sposobnostmi, kot je opredeljeno v tehničnih specifikacijah za interoperabilnost za osebe z omejenimi gibalnimi sposobnostmi. – Definicije in zahteve iz te specifikacije se bodo uporabile za naprave na železniških vozilih. – Ta specifikacija se nanaša le na vidike dostopnosti za potnike z omejenimi gibalnimi sposobnostmi; ne določa splošnih zahtev in splošnih definicij za posebne komponente in sisteme. – Ta specifikacija predvideva, da je vozilo v nominalnem obratovalnem stanju; morebitna škoda ali težave v zvezi z obratovanjem se ne bodo upoštevale pri oceni teh zahtev. – Kadar so navedene najmanjše ali največje dimenzije, te nikakor NE veljajo za nominalne zahteve. Merilne metode in/ali postopki za ocenjevanje, potrebni za določitev jasne ocene za sprejem/zavrnitev, so podani po potrebi.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST-TS CEN/TS 16635:2014
01-oktober-2014
äHOH]QLãNHQDSUDYH1DþUWRYDQMH]DRVHEH]RPHMHQLPLJLEDOQLPLVSRVREQRVWPL
2SUHPDLQVHVWDYQLGHOLQDåHOH]QLãNLKYR]LOLK6WUDQLãþD
Railway application - Design for PRM Use - Equipment and Components onboard Rolling
Stock - Toilets
Bahnanwendungen - Gestaltung für mobilitätseingeschränkte Menschen - Ausrüstungen
und Bauteile in Schienenfahrzeugen - Toiletten
Applications ferroviaires - Conception à l'usage des personnes à mobilité réduite -
Équipements et éléments à bord du matériel roulant - Toilettes
Ta slovenski standard je istoveten z: CEN/TS 16635:2014
ICS:
11.180.01 3ULSRPRþNL]D Aids for disabled and
RQHVSRVREOMHQHLQ handicapped persons in
KHQGLNHSLUDQHRVHEHQD general
VSORãQR
45.060.01 Železniška vozila na splošno Railway rolling stock in
general
SIST-TS CEN/TS 16635:2014 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST-TS CEN/TS 16635:2014
---------------------- Page: 2 ----------------------
SIST-TS CEN/TS 16635:2014
TECHNICAL SPECIFICATION
CEN/TS 16635
SPÉCIFICATION TECHNIQUE
TECHNISCHE SPEZIFIKATION
August 2014
ICS 43.060.20
English Version
Railway application - Design for PRM Use - Equipment and
Components onboard Rolling Stock - Toilets
Applications ferroviaires - Conception à l'usage des Bahnanwendungen - Auslegung für eingeschränkt mobile
personnes à mobilité réduite - Équipements et éléments à Personen - Einrichtungen und Komponenten in
bord du matériel roulant - Toilettes Schienenfahrzeugen - Toiletten
This Technical Specification (CEN/TS) was approved by CEN on 26 November 2013 for provisional application.
The period of validity of this CEN/TS is limited initially to three years. After two years the members of CEN will be requested to submit their
comments, particularly on the question whether the CEN/TS can be converted into a European Standard.
CEN members are required to announce the existence of this CEN/TS in the same way as for an EN and to make the CEN/TS available
promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the CEN/TS)
until the final decision about the possible conversion of the CEN/TS into an EN is reached.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United
Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2014 CEN All rights of exploitation in any form and by any means reserved Ref. No. CEN/TS 16635:2014 E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST-TS CEN/TS 16635:2014
CEN/TS 16635:2014 (E)
Contents Page
Foreword .3
Introduction .4
1 Scope .5
2 Normative references .5
3 Terms and definitions .5
4 Symbols and abbreviations .5
5 Requirements – Universal toilet dimensions .6
6 Assessment – Universal toilet internal space .6
Annex A (normative) Transportable wheelchair . 11
A.1 Engineering limits . 11
A.2 Characteristics . 11
Annex B (normative) Simplified wheelchair profile . 13
Annex C (informative) Wheelchair accessible toilet transfer guidance and examples . 14
Bibliography . 17
2
---------------------- Page: 4 ----------------------
SIST-TS CEN/TS 16635:2014
CEN/TS 16635:2014 (E)
Foreword
This document (CEN/TS 16635:2014) has been prepared by Technical Committee CEN/TC 256 “Railway
applications”, the secretariat of which is held by DIN.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following
countries are bound to announce this Technical Specification: Austria, Belgium, Bulgaria, Croatia, Cyprus,
Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.
3
---------------------- Page: 5 ----------------------
SIST-TS CEN/TS 16635:2014
CEN/TS 16635:2014 (E)
Introduction
This document is a Technical Specification for the assessment of the internal space requirements of a
universal (wheelchair accessible) toilet.
This document aims to define the assessment and measuring methodology to allow a clear pass/fail
assessment and allow successful implementation of the Technical Specification for Interoperability (TSI) for
Persons with Reduced Mobility (PRM) [1]. Clause 5 reflects the requirements in the TSI and Clause 6 adds
assessment criteria based on those requirements.
This document will be used until the issuing of EN 16585-1, Railway applications — Design for PRM use —
Equipment and components onboard rolling stock — Part 1: Toilets [2].
4
---------------------- Page: 6 ----------------------
SIST-TS CEN/TS 16635:2014
CEN/TS 16635:2014 (E)
1 Scope
This Technical Specification describes the specific ‘Design for PRM use’ requirements applying to rolling stock
on the Trans-European Network (TEN) covered by the TSI for PRM and the assessment of those
requirements. Regarding this document, the following statements apply.
— The definitions and requirements describe specific aspects of ‘Design for PRM use’ required by persons
with reduced mobility as defined in the TSI PRM.
— The definitions and requirements of this specification will be used for rolling stock applications.
— This specification only refers to aspects of accessibility for PRM passengers; it does not define general
requirements and general definitions for specific components and systems.
— This specification assumes that the vehicle is in the nominal operating condition; any damage or
operating failures will not be taken into account when assessing these requirements.
— Where minimum or maximum dimensions are quoted, these are absolute NOT nominal requirements.
Measurement methods and/or assessment procedures needed to establish a clear pass/fail assessment are
provided where necessary.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are
indispensable for its application. For dated references, only the edition cited applies. For undated references,
the latest edition of the referenced document (including any amendments) applies.
EN 12183: 2014, Manual wheelchairs - Requirements and test methods
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
3.1
universal toilet
toilet designed to be used by all passengers including passengers in wheelchairs
4 Symbols and abbreviations
Table 1 — Abbreviations
Abbreviation Designation
PRM Persons with Reduced Mobility
TEN Trans-European Network
TSI Technical Specification of Interoperability
Table 2 — Symbols
Symbol Designation
%ile Percentile
3D 3 Dimension
5
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.