EN 12414:2020

Vehicle parking control equipment - Requirements and test methods for a parking terminal

This document specifies the technical and functional requirements including test methods for parking terminals. It applies to unattended terminals used to obtain the right to park for visual and / or electronic control of multiple road vehicles, with payment where applicable.
This document only covers parking terminals.
For parking terminals connected to centralised system, this document covers the minimum information to be exchanged with a centralised system. It does not define a standard protocol between parking terminals and centralised systems. It does not define the centralised system.
This document does not cover pay-on-foot terminals.

Einrichtungen zur Parküberwachung von Fahrzeugen - Anforderungen und Prüfverfahren für Parkautomaten

Dieses Dokument legt die technischen und funktionellen Anforderungen einschließlich der Prüfverfahren für Parkautomaten fest. Es gilt für unbeaufsichtigte Automaten, die für die Berechtigung zum Parken zur Sicht  und/oder elektronischen Kontrolle zahlreicher Straßenfahrzeuge gegebenenfalls mit Bezahlung eingesetzt werden.
Dieses Dokument gilt nur für Parkautomaten.
Für Parkautomaten, die an ein Zentralsystem angeschlossen sind, behandelt dieses Dokument die mit dem Zentralsystem auszutauschenden Mindestangaben. Es legt kein Standardprotokoll zwischen Parkautomaten und Zentralsystemen fest. Es enthält keine Festlegungen zum Zentralsystem.
Dieses Dokument gilt nicht für Kassenautomaten.

Équipement de contrôle du stationnement des véhicules - Exigences et méthodes d'essai pour un terminal de stationnement

Le présent document spécifie les exigences techniques et fonctionnelles en incluant des méthodes d’essai pour les terminaux de stationnement. Il s’applique aux terminaux non surveillés utilisés pour obtenir le droit de stationner pour le contrôle visuel et/ou électronique de plusieurs véhicules routiers, le cas échéant avec paiement.
Le présent document couvre exclusivement les terminaux de stationnement.
Pour les terminaux de stationnement connectés à un système centralisé, le présent document couvre les informations minimales devant être échangées avec un système centralisé. Il ne définit pas un protocole normalisé entre les terminaux de stationnement et les systèmes centraux. Il ne définit pas le système centralisé.
Le présent document ne couvre pas les terminaux de type Payer à pied.

Nadzorna oprema za parkirišča - Zahteve in preskusne metode za parkirne avtomate

General Information

• Status: Published
• Publication Date: 30-Jun-2020
• Withdrawal Date: 30-Jan-2021
• ICS: 39.040.99 - Other time-measuring instruments
• Technical Committee: CEN/TC 226 - Road equipment
• Drafting Committee: CEN/TC 226 - Road equipment
• Current Stage: 6060 - Definitive text made available (DAV) - Publishing
• Start Date: 01-Jul-2020
• Due Date: 13-Sep-2020
• Completion Date: 01-Jul-2020
• Ref Project: SIST EN 12414:2020 - Vehicle parking control equipment - Requirements and test methods for a parking terminal

Relations

• Replaces: EN 12414:1999 - Vehicle parking control equipment - Pay and display ticket machine - Technical and functional requirements
• Effective Date: 08-Jul-2020

Standards Content (Sample)

SLOVENSKI STANDARD
01-september-2020
Nadomešča:
SIST EN 12414:2002
Nadzorna oprema za parkirišča - Zahteve in preskusne metode za parkirne
avtomate
Vehicle parking control equipment - Requirements and test methods for a parking
terminal
Einrichtungen zur Parküberwachung von Fahrzeugen - Parkautomaten - Anforderungen
und Prüfverfahren
Équipement de contrôle du stationnement des véhicules - Exigences et méthodes
d'essai pour un terminal de stationnement
Ta slovenski standard je istoveten z: EN 12414:2020
ICS:
39.040.99 Drugi merilniki časa Other time-measuring
instruments
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

EN 12414
EUROPEAN STANDARD
NORME EUROPÉENNE
July 2020
EUROPÄISCHE NORM
ICS 39.040.99 Supersedes EN 12414:1999
English Version
Vehicle parking control equipment - Requirements and
test methods for a parking terminal
Équipement de contrôle du stationnement des Einrichtungen zur Parküberwachung von Fahrzeugen -
véhicules - Exigences et méthodes d'essai pour un Anforderungen und Prüfverfahren für Parkautomaten
terminal de stationnement
This European Standard was approved by CEN on 3 May 2020.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 12414:2020 E
worldwide for CEN national Members.

Contents Page
European foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 7
4 Functional requirements. 9
4.1 Modes of operation . 9
4.1.1 General . 9
4.1.2 Pay and Display mode (with ticket) . 9
4.1.3 Pay and Go mode (without ticket) . 10
4.1.4 Pay on departure . 11
4.2 User interface . 13
4.2.1 Screen . 13
4.2.2 Ticket and receipt attributes . 13
4.2.3 Transaction confirmation function . 14
4.2.4 Transaction cancellation function . 14
4.2.5 Tariff selection . 14
4.2.6 Physical keyboard . 14
4.2.7 Screen standby mode . 15
4.2.8 Parking terminal visibility . 15
4.2.9 Out of service and out of order . 15
4.2.10 Languages . 15
4.2.11 Displayed information during the transaction . 15
4.2.12 Parking time calculation. 16
4.2.13 Labels, legends and button colours . 16
4.3 Connectivity of the parking terminal . 17
4.3.1 General . 17
4.3.2 Category A – Not connected parking terminal . 17
4.3.3 Category B – Connected parking terminal . 17
4.4 Payment means . 18
4.4.1 General . 18
4.4.2 Various payment means . 18
4.4.3 Confirmation and acceptance of payment . 19
4.4.4 Collection systems . 20
4.5 Embedded software . 20
4.5.1 Software configuration . 20
4.5.2 Software updates . 21
4.6 Management at the terminal . 21
4.6.1 Display of warnings (impending out of order situation) . 21
4.6.2 Ease of maintenance . 21
4.6.3 Secured access to maintenance actions . 21
4.6.4 Storage of operating and management data . 21
4.6.5 Verification of revenue held . 21
4.7 Remote management and reporting . 22
4.7.1 General . 22
4.7.2 Online status and events monitoring . 22
4.7.3 Data for statistics. 22
4.7.4 Remote configuration . 23
4.8 Manuals . 23
5 Technical requirements . 24
5.1 Safety . 24
5.1.1 Electrical safety . 24
5.1.2 Ingress Protection (dust, water, and foreign objects) . 24
5.2 Operating capacity . 24
5.2.1 Ticket stock . 24
5.2.2 Capacity of the escrow for coins and tokens . 24
5.2.3 Capacity of the cashbox for coins and tokens . 24
5.2.4 Storage relating to transactions by electronic means of payment . 24
5.2.5 Energy autonomy . 24
5.3 Resistance to environmental conditions. 25
5.3.1 Terminal storage temperature resistance . 25
5.3.2 Terminal operation temperature and humidity resistance . 25
5.3.3 Terminal water flooding resistance . 25
5.4 Accessibility for end-user . 25
5.5 Protection against theft or burglary . 26
5.6 Data security requirements for a parking terminal . 26
5.7 Internal clock . 27
6 Test of the functional and technical requirements . 27
6.1 Tests conditions . 27
6.2 Test methods . 27
Annex A (normative) Energy autonomy test procedure . 28
A.1 Calculation of daily consumption . 28
A.2 Calculation of annual energy available . 29
A.2.1 Solar powered terminal . 29
A.2.2 Terminal powered by a combination of solar energy and a non-rechargeable battery . 30
A.3 Autonomy during 'no energy' days . 30
A.4 Energy autonomy of a terminal . 31
Annex B (normative) Security test proce
...