EN 50110-2:2023
(Main)Operation of electrical installations - Part 2: National annexes
Operation of electrical installations - Part 2: National annexes
The European Standard EN 50110 series consists of two parts: - the first part, EN 50110 1, contains minimum requirements valid for all CENELEC countries and some additional informative annexes dealing with safe working; - the second part, prEN 50110 2, is a set of national annexes (one per each member country) which specify either additional safety requirements actually in force or national supplements to the minimum requirements set by EN 50110-1. The national annexes are the responsibility of an have to be maintained by the respective member country. National Committees shall notify CENELEC of any changes needed to their national annex.
Betrieb von elektrischen Anlagen - Teil 2: Nationale Anhänge
Exploitation des installations électriques - Partie 2: Annexes nationales
Obratovanje električnih postrojev - 2. del: Nacionalni dodatki
Evropski standard serije EN 50110 je sestavljen iz dveh delov:
– prvi del, EN 50110 1, vsebuje minimalne zahteve, ki veljajo za vse države, v katerih je pristojen Evropski odbor za elektrotehniško standardizacijo (CENELEC), in nekaj dodatnih informativnih dodatkov, v katerih se obravnava varno delo;
– drugi del, prEN 50110 2, je sklop nacionalnih dodatkov (po en dodatek na posamezno državo članico), ki določa bodisi dodatne veljavne varnostne zahteve bodisi nacionalne dodatke k minimalnim zahtevam, določenim v standardu EN 50110-1.
Za nacionalne dodatke in njihovo vzdrževanje so odgovorne zadevne države članice.
Nacionalni odbori morajo Evropski odbor za elektrotehniško standardizacijo obvestiti o morebitnih spremembah, ki jih je treba vključiti v nacionalni dodatek.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
01-september-2023
Obratovanje električnih postrojev - 2. del: Nacionalni dodatki
Operation of electrical installations - Part 2: National annexes
Betrieb von elektrischen Anlagen - Teil 2: Nationale Anhänge
Exploitation des installations électriques - Partie 2: Annexes nationales
Ta slovenski standard je istoveten z: EN 50110-2:2023
ICS:
29.240.01 Omrežja za prenos in Power transmission and
distribucijo električne energije distribution networks in
na splošno general
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
EUROPEAN STANDARD EN 50110-2
NORME EUROPÉENNE
EUROPÄISCHE NORM June 2023
ICS 29.240 Supersedes EN 50110-2:2021
English Version
Operation of electrical installations - Part 2: National annexes
Exploitation des installations électriques - Partie 2: Annexes Betrieb von elektrischen Anlagen - Teil 2: Nationale
nationales Anhänge
This European Standard was approved by CENELEC on 2023-05-29. CENELEC members are bound to comply with the CEN/CENELEC
Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the
same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the
Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Türkiye and the United Kingdom.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2023 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members.
Ref. No. EN 50110-2:2023 E
Contents Page
European foreword . 4
Introduction . 5
1 Austria (AT) . 6
2 Belgium (BE) . 7
3 Bulgaria (BG) — No reply — . 8
4 Croatia (HR) — No reply — . 9
5 Cyprus (CY) — No reply — . 9
6 Czech Republic (CZ) . 10
7 Denmark (DK) . 14
8 Estonia (EE) . 15
9 Finland (FI) . 16
10 Former Yugoslav Republic of Macedonia (MK) — No reply — . 16
11 France (FR) . 17
12 Germany (DE) . 20
13 Greece (GR) . 23
14 Hungary (HU) . 24
15 Iceland (IS) . 25
16 Ireland (IE) . 25
17 Italy (IT) . 27
18 Latvia (LV) . 28
19 Lithuania (LT) . 30
20 Luxembourg (LU) — No reply — . 31
21 Malta (MT) — No reply —. 31
22 Netherlands (NL) . 32
23 Norway (NO) . 33
24 Poland (PL) . 34
25 Portugal (PT) . 35
26 Romania (RO) . 36
27 Serbia (SRB) . 37
28 Slovakia (SK) . 38
29 Slovenia (SI) . 41
30 Spain (ES) . 43
31 Sweden (SE) . 44
32 Switzerland (CH) . 46
33 Turkey (TR) — No reply — . 47
34 United Kingdom (UK) . 47
European foreword
This document (EN 50110-2:2023) has been prepared by CLC/BTTF 62-3, “Operation of electrical installations”.
The following dates are fixed:
• latest date by which this document has to be (dop) 2024-05-29
implemented at national level by publication of
an identical national standard or by
endorsement
• latest date by which the national standards (dow) 2026-05-29
conflicting with this document have to be
withdrawn
This document supersedes EN 50110-2:2021 and all of its amendments and corrigenda (if any).
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
Any feedback and questions on this document should be directed to the users’ national committee. A complete
listing of these bodies can be found on the CENELEC website.
Introduction
The European Standard EN 50110 series consists of two parts:
— the first part, EN 50110-1, contains minimum requirements valid for all CENELEC countries and some
additional informative annexes dealing with safe working;
— the second part, EN 50110-2, is a set of national annexes (one per country) which specify either the
additional present safety requirements or give the national supplements to these minimum requirements at
the time when this document was prepared.
The national annexes are summarized by the respective member country.
National Committees are expected to notify CENELEC of any changes needed to their national annex.
For the user’s understanding, it is important to publish this document in all official CENELEC languages (English,
French and German) (see also the footnotes No. 1 to 4). In effect, every clause in the following example of
structure for each national annex which is marked by index 2 and 4 “Written in all official CENELEC
languages…” will be translated accordingly.
To reduce effort, every national Committee is recommended to prepare these clauses in their own national
annex in English. The French and German translations will be provided by CENELEC with publishing.
The structure of each national annex shall comply to the structure shown in “Example of the structure”:
Example of the Structure
# Name of Country
#.1 Laws and regulations
#.1.#
Title of national law or regulation ➔ void
#.1.#.1
Translation of Title of national law or regulation ➔ void
#.1.#.2
Explanation of content of national law or regulation ➔ void
#.2 Standards
#.2.# Title of national Standard
#.2.#.1 Translation of Title of national Standard
#.2.#.2 Explanation of content of national Standard
#.3 Other documents
#.3.# Title of the national document
#.3.#.1 Translation of Title of the national document
#.3.#.2 Explanation of content of the national document
NOTE Each Headline except “Name of Country”, “Laws and Regulations”, “Standards” and “Other documents” is a
placeholder. In case there is no item to mention, the remark “➔ void” is added after the placeholder as shown in the first
clause of this example of the structure.
Written in all official CENELEC languages.
If there is no item, the following Information has to be added after the name of country “— No reply —“.
Written in all official CENELEC languages.
Written in national language.
Written in all official CENELEC languages and in italics.
1 Austria (AT)
1.1. Laws and regulations
1.1.1. 13. Verordnung des Bundesministers für Wirtschaft und Arbeit, mit der die Verordnung über den
Nachweis der Fachkenntnisse (Fachkenntnisnachweis-Verordnung – FK-V) erlassen wird sowie die
Verordnung über den Nachweis der Fachkenntnisse für die Vorbereitung und Organisation von
bühnentechnischen und beleuchtungstechnischen Arbeiten, die Verordnung über die Fachausbildung der
Sicherheitsfachkräfte und die Besonderheiten im untertägigen Bergbau, die Bauarbeiterschutzverordnung, die
Druckluft- und Taucherarbeitenverordnung, die Verordnung über den Schutz der Dienstnehmer und der
Nachbarschaft beim Betrieb von Steinbrüchen, Lehm-, Ton-, Sand- und Kiesgruben sowie bei
Haldenabtragungen und die Sprengarbeitenverordnung geändert werden (BGBl. II Nr. 13/2007, idgF).
1.1.1.1. Regulation on Skills for Hazardous Work
1.1.1.2. This regulation provides instruction to personnel who have to prepare and organize specific live
working procedures for voltages exceeding 1 kV (BGBL II Nr. 13/2007).
1.2. Standards
1.2.1. ÖVE/ÖNORM EN 50110-1 (EN 50110-2-100 eingearbeitet) – Betrieb von elektrischen Anlagen – Teil
1: Allgemeine Anforderungen – Teil 2-100: Nationale Ergänzungen
1.2.1.1. ÖVE/ÖNORM EN 50110-1 (EN 50110-2-100 integrated) – Operation of electrical installations –
Part 1: General requirements - Part 2-100: National annexes
1.2.1.2. The Austrian national annex ÖVE/ÖNORM EN 50110-2-100 was integrated in ÖVE/ÖNORM
EN 50110-1 with the aim to achieve a better readability of the standard. Part 2-100 represents the Austrian
supplement to EN 50 110-1 and is more detailed than EN 50110-1
1.2.2. ÖVE/ÖNORM EN 50110-2 – Betrieb von elektrischen Anlagen – Teil 2: Nationale Anhänge
1.2.2.1. ÖVE/ÖNORM EN 50110-2 – Operation of electrical installations – Part 2: National annexes
1.2.2.2. ÖVE/ÖNORM EN 50110-2 is a set of national annexes to EN 50110-1 including the national
supplements and safety requirements of the European National countries
1.2.3. ÖVE EN 50110-2-700 – Betrieb von elektrischen Anlagen – Teil 2-700: Betrieb elektrischer Anlagen im
Bergbau
1.2.3.1. ÖVE/ÖNORM EN 50110-2-700 – Operation of electrical installations – Part 2-700: Operation of
electrical installations in mines
1.2.3.2. This standard covers particular requirements for the operation of electrical installations in mines
1.2.4. ÖVE/ÖNORM E 8385 – Betrieb von elektrischen Anlagen – Besondere Festlegungen für
landwirtschaftliche und gartenbauliche Betriebsstätten
1.2.4.1. ÖVE/ÖNORM E 8385 – Operation of electrical installations – Particular requirements for agricultural
and horticultural plants
1.2.4.2. This standard covers particular requirements for the ope
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.