Railway applications - Communication, signalling and processing systems - Software for railway control and protection systems

1.1 This European Standard specifies procedures and technical requirements for the development of programmable electronic systems for use in railway control and protection applications. It is aimed at use in any area where there are safety implications. These may range from the very critical, such as safety signalling to the non-critical, such as management information systems. These systems may be implemented using dedicated microprocessors, programmable logic controllers, multiprocessor distributed systems, larger scale central processor systems or other architectures. 1.2 This European Standard is applicable exclusively to software and the interaction between software and the system of which it is part. 1.3 Software safety integrity levels above zero are for use in systems in which the consequences of failure could include loss of life. Economic or environmental considerations, however, may also justify the use of higher software safety integrity levels. 1.4 This European Standard applies to all software used in development and implementation of railway control and protection systems including: application programming; operating systems; support tools; firmware. Application programming comprises high level programming, low level programming and special purpose programming (for example: Programmable Logic Controller ladder logic). 1.5 The use of standard, commercially available software and tools is also addressed in this European Standard. 1.6 This European Standard also addresses the requirements for systems configured by application data. 1.7 This European Standard is not intended to address commercial issues. These should be addressed as an essential part of any contractual agreement. All the clauses of this European Standard will need careful consideration in any commercial situation. 1.8 This European Standard is not intended to be retrospective. It therefore applies primarily to new developments and only applies in its entirety to existing systems if these are subjected to major modifications. For minor changes, only clause 16 applies.

Bahnanwendungen - Telekommunikationstechnik, Signaltechnik und Datenverarbeitungssysteme - Software für Eisenbahnsteuerungs- und Überwachungssysteme

Applications ferroviaires - Systèmes de signalisation, de télécommunication et de traitement - Logiciels pour systèmes de commande et de protection ferroviaire

Železniške naprave – Komunikacijski, signalni in procesni sistemi – Programska oprema za železniške krmilne in zaščitne sisteme

General Information

Status
Withdrawn
Publication Date
15-Mar-2001
Withdrawal Date
31-Oct-2003
Current Stage
9960 - Withdrawal effective - Withdrawal
Start Date
25-Apr-2017
Completion Date
25-Apr-2017

Relations

Buy Standard

Standard
EN 50128:2002
English language
104 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 50128:2002
01-marec-2002
äHOH]QLãNHQDSUDYH±.RPXQLNDFLMVNLVLJQDOQLLQSURFHVQLVLVWHPL±3URJUDPVND
RSUHPD]DåHOH]QLãNHNUPLOQHLQ]DãþLWQHVLVWHPH
Railway applications - Communication, signalling and processing systems - Software for
railway control and protection systems
Bahnanwendungen - Telekommunikationstechnik, Signaltechnik und
Datenverarbeitungssysteme - Software für Eisenbahnsteuerungs- und
Überwachungssysteme
Applications ferroviaires - Systèmes de signalisation, de télécommunication et de
traitement - Logiciels pour systèmes de commande et de protection ferroviaire
Ta slovenski standard je istoveten z: EN 50128:2001
ICS:
35.240.60 Uporabniške rešitve IT v IT applications in transport
transportu in trgovini and trade
45.020 Železniška tehnika na Railway engineering in
splošno general
SIST EN 50128:2002 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 50128:2002

---------------------- Page: 2 ----------------------

SIST EN 50128:2002
EUROPEAN STANDARD EN 50128
NORME EUROPÉENNE
EUROPÄISCHE NORM March 2001
ICS 29.280; 45.060.10
English version
Railway applications -
Communications, signalling and processing systems -
Software for railway control and protection systems
Applications ferroviaires - Bahnanwendungen -
Systèmes de signalisation, de Telekommunikationstechnik, Signal-
télécommunication et de traitement - technik und Datenverarbeitungssysteme -
Logiciels pour systèmes de commande Software für Eisenbahnsteuerungs- und
et de protection ferroviaire Überwachungssysteme
This European Standard was approved by CENELEC on 2000-11-01. CENELEC members are bound
to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any
other language made by translation under the responsibility of a CENELEC member into its own
language and notified to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Czech
Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg,
Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2001 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 50128:2001 E

---------------------- Page: 3 ----------------------

SIST EN 50128:2002
EN 50128:2001 - 2 -
Foreword
This European Standard was prepared by SC 9XA, Communication, signalling and processing systems, of
Technical Committee CENELEC TC 9X, Electrical and electronic applications for railways.
The text of the draft was submitted to the formal vote and was approved by CENELEC as EN 50128 on
2000-11-01.
The following dates were fixed:
- latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2001-11-01
- latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2003-11-01
This European Standard should be read in conjunction with EN 50126: "Railway applications - The
specification and demonstration of Reliability, Availability, Maintainability and Safety (RAMS)” and
EN 50129: "Railway applications - Safety related electronic systems for signalling".
Annexes designated "normative" are part of the body of the standard.
Annexes designated "informative" are given for information only.
In this standard, annex A is normative and annex B is informative.
__________

---------------------- Page: 4 ----------------------

SIST EN 50128:2002
- 3 - EN 50128:2001
Contents
Pages
Introduction.5
1 Scope .7
2 Normative references.7
3 Definitions.8
4 Objectives and conformance.
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.