EN 60512-27-100:2012
(Main)Connectors for electronic equipment - Tests and measurements - Part 27-100: Signal integrity tests up to 500 MHz on IEC 60603-7 series connectors - Tests 27a to 27g
Connectors for electronic equipment - Tests and measurements - Part 27-100: Signal integrity tests up to 500 MHz on IEC 60603-7 series connectors - Tests 27a to 27g
IEC 60512-27-100:2011 specifies the test methods for transmission performance for IEC 60603-7 series connectors up to 500 MHz. It is also suitable for testing lower frequency connectors if they meet the requirements of the detail specifications and of this standard. The test methods provided are: - insertion loss, - return loss, - near-end crosstalk (NEXT), - far-end crosstalk (FEXT), - transverse conversion loss (TCL) and - transverse conversion transfer loss (TCTL). For the transfer impedance (Zt) test, see IEC 60512-26-100 and for the coupling attenuation, see IEC 62153-4-12.
Steckverbinder für elektronische Einrichtungen - Mess- und Prüfverfahren - Teil 27-100: Signalintegritätsprüfungen bis 500 MHz an Steckverbindern der Reihe IEC 60603-7 - Prüfungen 27a bis 27g
Connecteurs pour équipements électroniques - Essais et mesures - Partie 27-100: Essais d'intégrité des signaux jusqu'à 500 MHz sur les connecteurs de la série CEI 60603-7 - Essais 27a à 27g
La CEI 60512-27-100:2011 spécifie les méthodes d'essai relatives aux performances de transmission des connecteurs de la série CEI 60603-7 jusqu'à 500 MHz. Elle est également applicable aux essais réalisés sur des connecteurs à fréquences plus basses s'ils satisfont aux exigences des spécifications particulières et de la présente norme. Les méthodes d'essai spécifiées sont: - perte d'insertion, - affaiblissement de réflexion, - paradiaphonie (NEXT), - télédiaphonie (FEXT), - perte de conversion transverse (TCL), - perte de transfert de conversion transverse (TCTL). Pour l'essai d'impédance de transfert (Zt), voir la CEI 60512-26-100 et pour l'affaiblissement de couplage, voir la CEI 62153-4-12.
Konektorji za elektronsko opremo - Preskusi in meritve - 27-100. del: Preskušanje neokrnjenosti signalov do 500 MHz na konektorjih serije IEC 60603-7 - Preskusi od 27a do 27g
Ta del standarda IEC 60512 določa preskusne metode za lastnosti prenosa na konektorjih serije IEC 60603-7 do 500 MHz. Prav tako je primeren za preskušanje konektorjev z nižjimi frekvencami, če ustrezajo zahtevam podrobnih specifikacij in tega standarda. Tukaj so podane naslednje preskusne metode: – dodano dušenje, preskus 27a; – povratno dušenje, preskus 27b; – bližnji presluh (NEXT), preskus 27c; – daljni presluh (FEXT), preskus 27d; – prečno dušenje pretvorbe (TCL), preskus 27f; – prečno dušenje pretvorbe prenosa (TCTL), preskus 27g. Za preskus impedance prenosa (Zt) glejte IEC 60512-26-100, preskus 26e. Za slabljenje stikov glejte IEC 62153-4-12.
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 60512-27-100:2012
01-maj-2012
Konektorji za elektronsko opremo - Preskusi in meritve - 27-100. del: Preskušanje
neokrnjenosti signalov do 500 MHz na konektorjih serije IEC 60603-7 - Preskusi od
27a do 27g
Connectors for electronic equipment - Tests and measurements - Part 27-100: Signal
integrity tests up to 500 MHz on IEC 60603-7 series connectors - Tests 27a to 27g
Steckverbinder für elektronische Einrichtungen - Mess- und Prüfverfahren - Teil 27-100:
Signalintegritätsprüfungen bis 500 MHz an Steckverbindern der Reihe IEC 60603-7 -
Prüfungen 27a bis 27g
Connecteurs pour équipements électroniques - Essais et mesures - Partie 27-100:
Essais d'intégrité des signaux jusqu'à 500 MHz sur les connecteurs de la série CEI
60603-7 - Essais 27a à 27g
Ta slovenski standard je istoveten z: EN 60512-27-100:2012
ICS:
31.220.10 9WLþLLQYWLþQLFHNRQHNWRUML Plug-and-socket devices.
Connectors
SIST EN 60512-27-100:2012 en,fr,de
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 60512-27-100:2012
---------------------- Page: 2 ----------------------
SIST EN 60512-27-100:2012
EUROPEAN STANDARD
EN 60512-27-100
NORME EUROPÉENNE
February 2012
EUROPÄISCHE NORM
ICS 31.220.10
English version
Connectors for electronic equipment -
Tests and measurements -
Part 27-100: Signal integrity tests up to 500 MHz on IEC 60603-7 series
connectors -
Tests 27a to 27g
(IEC 60512-27-100:2011)
Connecteurs pour équipements Steckverbinder für elektronische
électroniques - Einrichtungen -
Essais et mesures - Mess- und Prüfverfahren -
Partie 27-100: Essais d'intégrité des Teil 27-100: Signalintegritätsprüfungen bis
signaux jusqu'à 500 MHz sur les 500 MHz an Steckverbindern der Reihe
connecteurs de la série CEI 60603-7 - IEC 60603-7 -
Essais 27a à 27g Prüfungen 27a bis 27g
(CEI 60512-27-100:2011) (IEC 60512-27-100:2011)
This European Standard was approved by CENELEC on 2012-01-11. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland, Turkey and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Management Centre: Avenue Marnix 17, B - 1000 Brussels
© 2012 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60512-27-100:2012 E
---------------------- Page: 3 ----------------------
SIST EN 60512-27-100:2012
EN 60512-27-100:2012 - 2 -
Foreword
The text of document 48B/2262/FDIS, future edition 1 of IEC 60512-27-100, prepared by SC 48B,
"Connectors", of IEC TC 48, "Electromechanical components and mechanical structures for electronic
equipment" was submitted to the IEC-CENELEC parallel vote and approved by CENELEC as
EN 60512-27-100:2012.
The following dates are fixed:
(dop) 2012-10-11
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
• latest date by which the national (dow) 2015-01-11
standards conflicting with the
document have to be withdrawn
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such patent
rights.
Endorsement notice
The text of the International Standard IEC 60512-27-100:2011 was approved by CENELEC as a
European Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:
IEC 60603-7-4 NOTE Harmonized as EN 60603-7-4.
IEC 60603-7-5 NOTE Harmonized as EN 60603-7-5.
---------------------- Page: 4 ----------------------
SIST EN 60512-27-100:2012
- 3 - EN 60512-27-100:
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.