SIST EN 12808-3:2002

Grouts for tiles - Part 3: Determination of flexural and compressive strength

This European Standard applies to all ceramic tile grouts for internal and external tile installations on walls and floors.
This standard describes the test method to be used to determine the compressive and flexural strength of ceramic tile grouts.
This European Standard does not contain performance requirements or recommendations for the design and installation of ceramic tiles.
NOTE   Ceramic tile grouts can also be used for other types of tiles (natural and agglomerated stones, etc. ), where these do not adversely affect the stones.

Klebstoffe und Fugenmörtel für Fliesen und Platten - Teil 3: Bestimmung der Biege- und Druckfestigkeit

Diese Europäische Norm ist auf sämtliche Klebstoffe und Fugenmörtel für keramische Fliesen und Platten an Wand und Boden für innen und außen anwendbar.
Diese Norm beschreibt das Prüfverfahren zur Bestimmung der Biege- und Druckfestigkeit von Fugenmörtel für keramische Fliesen und Platten.
Diese Europäische Norm enthält keine Anforderungen an und Empfehlungen für die Planung und Verlegung von keramischen Fliesen und Platten.
ANMERKUNG   Fugenmörtel für keramische Fliesen und Platten können auch für andere Materialarten verwendet werden (Natur-, Betonwerksteine usw.), sofern diese die Steine nicht negativ beeinflussen.

Mortiers de joints pour carrelages - Partie 3: Détermination de la résistance a la flexion et a la compression

La présente Norme européenne s'applique a tous les mortiers utilisés pour le jointoiement de carrelages céramiques sur les murs et au sol, a l'intérieur et a l'extérieur.
La présente norme spécifie la méthode d'essai qui doit etre utilisée pour déterminer la résistance a la flexion et a la compression des mortiers de joints.
La présente Norme européenne ne contient pas de spécifications, ni de recommandations pour la conception et la pose des carrelages en céramique.
NOTE   Les mortiers de joints peuvent etre également utilisés pour d'autres types de carrelage (pierre naturelle ou agglomérée, etc.) s'ils sont compatibles.

Lepila in fugirne malte za ploščice - 3. del: Ugotavljanje upogibne in tlačne trdnosti

General Information

• Status: Withdrawn
• Publication Date: 31-Oct-2002
• Withdrawal Date: 19-Jan-2009
• ICS: 83.180 - Adhesives
• ICS: 91.100.10 - Cement. Gypsum. Lime. Mortar
• ICS: 91.100.23 - Ceramic tiles
• Technical Committee: IKER - Ceramics
• Current Stage: 9900 - Withdrawal (Adopted Project)
• Start Date: 15-Jan-2009
• Due Date: 07-Feb-2009
• Completion Date: 20-Jan-2009
• Directive: 89/106/EEC - Construction products
• Mandate: M/BC/CEN/92/22 - CPD: Internal finishes of walls & partitions.
• Ref Project: EN 12808-3:2001 - Grouts for tiles - Part 3: Determination of flexural and compressive strength

Relations

• Replaced By: SIST EN 12808-3:2009 - Grouts for tiles - Part 3: Determination of flexural and compressive strength
• Effective Date: 01-Mar-2009
• Parent: SIST EN 13888:2003 - Grouts for tiles - Definitions and specifications
• Effective Date: 22-Dec-2008

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Klebstoffe und Fugenmörtel für Fliesen und Platten - Teil 3: Bestimmung der Biege- und DruckfestigkeitMortiers de joints pour carrelages - Partie 3: Détermination de la résistance a la flexion et a la compressionGrouts for tiles - Part 3: Determination of flexural and compressive strength91.100.23Ceramic tiles91.100.10Cement. Mavec. Apno. MaltaCement. Gypsum. Lime. Mortar83.180LepilaAdhesivesICS:Ta slovenski standard je istoveten z:EN 12808-3:2001SIST EN 12808-3:2002en01-november-2002SIST EN 12808-3:2002SLOVENSKI
STANDARD



SIST EN 12808-3:2002



EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 12808-3December 2001ICS 91.100.10English versionGrouts for tiles - Part 3: Determination of flexural andcompressive strengthMortiers de joints pour carrelages - Partie 3: Déterminationde la résistance à la flexion et à la compressionKlebstoffe und Fugenmörtel für Fliesen und Platten - Teil 3:Bestimmung der Biege- und DruckfestigkeitThis European Standard was approved by CEN on 3 November 2001.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2001 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 12808-3:2001 ESIST EN 12808-3:2002



EN 12808-3:2001 (E)2ContentspageForeword.31Scope.42Normative references.43Sampling.44Test conditions.45Test materials.46Apparatus.47Procedure.57.1Mixing of grouts.57.2Preparation of test specimens.57.3Flexural strength under standard conditions.57.4Compressive strength under standard conditions.57.5Flexural and compressive strength after freeze-thaw cycles.58Evaluation of results.68.1Flexural strength.68.2Compressive strength.69Test report.6Bibliography.9SIST EN 12808-3:2002



EN 12808-3:2001 (E)3ForewordThis European Standard has been prepared by Technical Committee CEN /TC 67 "Ceramic tiles", the secretariat ofwhich is held by UNI.This European Standard shall be given the status of a national standard, either by publication of an identical textor by endorsement, at the latest by June 2002, and conflicting national standards shall be withdrawn at the latestby June 2002.According to the CEN/CENELEC Internal Regulations, the national standards organizations of the followingcountries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland,France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden,Switzerland and the United Kingdom.SIST EN 12808-3:2002



EN 12808-3:2001 (E)41 ScopeThis European Standard applies to all ceramic tile grouts for internal and external tile installations on walls andfloors.This standard describes the test method to be used to determine the compressive and flexural strength ofceramic tile grouts.This European Standard does not contain performance requirements or recommendations for the design andinstallation of ceramic tiles.NOTECeramic tile grouts can also be used for other types of tiles (natural and agglomerated stones, etc. ), where thesedo not adversely affect the stones.2 Normative referencesThis European Standard incorporates by dated or undated reference, provisions from other publications. Thesenormative references are cited at the appropriate places in the text, and the publications are listed hereafter. Fordated references subsequent amendments to, or revisions of, any of these publications apply to this Europ
...