49.030.60 - Rivets

This document specifies the requirements relating to:
Steel FE-PA11
Softened and cold drawn
Wires for rivets
1 mm ≤ D ≤ 10 mm
for aerospace applications.

TC - mistake in drawing

TC - mistake in drawing

This European Standard specifies the dimensions, tolerances and mass of rivets with 100° medium flush head, close tolerance, inch series, for aerospace application.

This standard specifies the dimensions, tolerances and mass of rivets with universal head, close tolerance, inch series, for aerospace application.

This standard specifies the configuration, dimension, tolerances and mass of a stainless steel blind bolt with protruding head, for aerospace application.

This standard specifies the dimensions, tolerances and masses of rivets with 100° normal flush head, close tolerance, inch series, for aerospace application.

This European Standard specifies the dimensions, tolerances and mass of rivets with universal head, close tolerance, inch series, for aerospace application.

This European Standard specifies the dimensions, tolerances and mass of rivets with 100° medium flush head, close tolerance, inch series, for aerospace application.

This European Standard specifies the dimensions, tolerances and masses of rivets with 100° normal flush head, close tolerance, inch series, for aerospace application.

This standard specifies the configuration, dimension, tolerances and mass of a stainless steel blind bolt with protruding head, for aerospace application.

ISO 12289:2016 specifies the characteristics and quality assurance requirements for solid rivets made in corrosion-resisting steel for aerospace construction. It is applicable whenever it is referenced in a definition document.

This European Standard defines the characteristics of solid rivets, with universal head, metric series, in nickel base alloy, for maximum operating temperature 650 °C.

This European Standard specifies the requirements for ultrasonic inspection of tubes in metallic materials with an external diameter  5 mm.
For other cases, the use of this standard is by agreement between the manufacturer and the purchaser.
The purpose of the ultrasonic inspection is the detection of defects within the wall thickness and at the outer and inner surfaces of the tube. The method will detect two dimensional defects in the longitudinal and circumferential directions perpendicular...view more

This European Standard defines the characteristics of solid rivets, with universal head, metric series, in nickel base alloy, for maximum operating temperature 650 °C.

This standard specifies the requirements for shear testing rivet wire and rivets in metallic materials for aerospace applications.
It shall be applied when referred to in the EN technical specification or material standard unless otherwise specified on the drawing, order or inspection schedule.

This standard specifies the dimensions, tolerances and mass of rivets with 100° reduced flush head, close tolerance, inch series, for aerospace application.

This standard specifies the performance and test requirements for corrosion and heat resisting solid steel rivets intended for aerospace applications. It applies whenever it is specified in the document defining the rivet.
Its use, after agreement between the customer and the supplier, for solid rivets made from other materials, requires determination, case by case, of the minimum tensile and double shear loads.

This standard specifies the performance and test requirements for solid rivets in the nickel alloys quoted below, intended for aerospace applications. It applies wherever it is specified in the document defining the rivet.
Its use, after agreement between the customer and the supplier, for solid rivets made from other materials, requires determination, case by case, of the minimum tensile and double shear loads.

This standard specifies the performance and test requirements for solid rivets in the nickel alloys quoted below, intended for aerospace applications. It applies wherever it is specified in the document defining the rivet.
Its use, after agreement between the customer and the supplier, for solid rivets made from other materials, requires determination, case by case, of the minimum tensile and double shear loads.