iTeh StandardsiTeh Standards
EURUSD
Your shopping cart is empty.
CEN

EN 437:1993/A2:1999

(Amendment)

Test gases - Test pressures - Appliance categories

Test gases - Test pressures - Appliance categories

Migrated from Progress Sheet (TC Comment) (2000-07-10): UAP of 4 months (TC Res C 84/1998) (CC/981223)

Prüfgase - Prüfdrücke - Gerätekategorien

Gaz d'essais - Pressions d'essais - Catégories d'appareils

Preskusni plini - Preskusni tlaki - Kategorije aparatov

General Information

Status
Withdrawn
Publication Date
19-Oct-1999
Withdrawal Date
20-May-2003
ICS
27.060.20 - Gas fuel burners
91.140.40 - Gas supply systems
Technical Committee
CEN/TC 238 - Test gases, test pressures and categories of appliances
Drafting Committee
CEN/TC 238 - Test gases, test pressures and categories of appliances
Current Stage
9960 - Withdrawal effective - Withdrawal
Start Date
21-May-2003
Completion Date
21-May-2003
Directive
90/396/EEC - Appliances burning gaseous fuels
Mandate
M/BC/CEN/89/6 - Standardization request to CEN concerning appliances burning gaseous fuels
Ref Project
SIST EN 437:1997/A2:2001 - Test gases - Test pressures - Appliance categories

Relations

Replaced By
EN 437:2003 - Test gases - Test pressures - Appliance categories
Effective Date
22-Dec-2008
Amends
EN 437:1993 - Test gases - Test pressures - Appliance categories
Effective Date
22-Dec-2008

Buy Standard

EN 437:1997/A2:2001EN 437:1997/A2:2001
PreviousNext
Amendment
EN 437:1997/A2:2001
English language
8 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 437:1997/A2:2001
01-februar-2001
Preskusni plini - Preskusni tlaki - Kategorije aparatov
Test gases - Test pressures - Appliance categories
Prüfgase - Prüfdrücke - Gerätekategorien
Gaz d'essais - Pressions d'essais - Catégories d'appareils
Ta slovenski standard je istoveten z: EN 437:1993/A2:1999
ICS:
27.060.20 Plinski gorilniki Gas fuel burners
91.140.40 Sistemi za oskrbo s plinom Gas supply systems
SIST EN 437:1997/A2:2001 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 437:1997/A2:2001

---------------------- Page: 2 ---------
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.

This May Also Interest You

CEN
EN 437:2021(Main)
Test gases - Test pressures - Appliance categories
SIST EN 437:2021

This document specifies the test gases, test pressures and categories of appliances relative to the use of gaseous fuels of the first, second and third families. It serves as a reference document in the specific standards for appliances.
The document makes recommendations for the use of the gases and pressures to be applied for the tests of appliances burning gaseous fuels.
NOTE   Procedures for tests are given in the corresponding appliance standards. The test gases and the test pressures specified in this standard are in principle intended to be used with all types of appliances.
However, the use of some test gases and test pressures may not be appropriate in the following cases:
-   appliances with nominal heat input greater than 300 kW;
-   appliances constructed on site;
-   appliances in which the final design is influenced by the user;
-   appliances constructed for use with high supply pressures (notably direct use of the saturated vapour pressure).
In these cases, the specific appliance standards may specify other test conditions in order to establish compliance with their requirements.

  • Standard
    57 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    57 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 437:2003/prA1(Amendment)
Test gases - Test pressures - Appliance categories
SIST EN 437:2005/kprA1:2008

This standard specifies the test gases, test pressures and categories of appliances relative to use of combustible gases of the first, second and third families. It serves as a reference document in the specific standards for appliances that fall within the scope of the Council Directive on the approximation of the laws of Member States concerning gas appliances.
The standard makes recommendations for the use of the gases and pressures to be applied for the tests. The full procedure will be given the corresponding appliance standards.
NOTE The test gases and the test pressures specified in this standard are in principle intended to be used with all the appliances in order to establish conformity with the corresponding standards.

  • Draft
    28 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 437:2021(Main)
Test gases - Test pressures - Appliance categories
SIST EN 437:2021

This document specifies the test gases, test pressures and categories of appliances relative to the use of gaseous fuels of the first, second and third families. It serves as a reference document in the specific standards for appliances.
The document makes recommendations for the use of the gases and pressures to be applied for the tests of appliances burning gaseous fuels.
NOTE   Procedures for tests are given in the corresponding appliance standards. The test gases and the test pressures specified in this standard are in principle intended to be used with all types of appliances.
However, the use of some test gases and test pressures may not be appropriate in the following cases:
-   appliances with nominal heat input greater than 300 kW;
-   appliances constructed on site;
-   appliances in which the final design is influenced by the user;
-   appliances constructed for use with high supply pressures (notably direct use of the saturated vapour pressure).
In these cases, the specific appliance standards may specify other test conditions in order to establish compliance with their requirements.

  • Standard
    57 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    57 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 437:2003/prA1(Amendment)
Test gases - Test pressures - Appliance categories
SIST EN 437:2005/kprA1:2008

This standard specifies the test gases, test pressures and categories of appliances relative to use of combustible gases of the first, second and third families. It serves as a reference document in the specific standards for appliances that fall within the scope of the Council Directive on the approximation of the laws of Member States concerning gas appliances.
The standard makes recommendations for the use of the gases and pressures to be applied for the tests. The full procedure will be given the corresponding appliance standards.
NOTE The test gases and the test pressures specified in this standard are in principle intended to be used with all the appliances in order to establish conformity with the corresponding standards.

  • Draft
    28 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 3525:2023(Main)
Aerospace series - Steel 15CrMoV6 (1.7334) - Air melted - Hardened and tempered - Plates - 6 mm ≤ a ≤ 20 mm - 1 080 MPa ≤ Rm ≤ 1 280 MPa
oSIST prEN 3525:2021

This document specifies the requirements relating to:
Steel 15CrMoV6 (1.7334)
Air melted
Hardened and tempered
Plates
6 mm ≤ a ≤ 20 mm
1 080 MPa ≤ Rm ≤ 1 280 MPa
for aerospace applications.
W.nr: 1.7334.
ASD-STAN designation: FE-PL1505.

  • Draft
    9 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 3524:2023(Main)
Aerospace series - Steel 15CrMoV6 (1.7334) - Air melted - Hardened and tempered - Sheets and strips - 2 mm ≤ a ≤ 6 mm - 1 080 MPa ≤ Rm ≤ 1 280 MPa
oSIST prEN 3524:2021

This document specifies the requirements relating to:
Steel 15CrMoV6 (1.7334)
Air melted
Hardened and tempered
Sheets and strips
2 mm ≤ a ≤ 6 mm
1 080 MPa ≤ Rm ≤ 1 280 MPa
for aerospace applications.
W.nr: 1.7334.
ASD-STAN designation: FE-PL1505.

  • Draft
    9 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
CEN/CLC ISO/IEC/TR 24029-1:2023(Main)
Artificial Intelligence (AI) - Assessment of the robustness of neural networks - Part 1: Overview (ISO/IEC TR 24029-1:2021)
kSIST-TP FprEN ISO/IEC/TR 24029-1:2023

This document provides background about existing methods to assess the robustness of neural networks.

  • Draft
    36 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 14944-3:2023(Main)
Influence of cementitious products on water intended for human consumption - Test methods - Part 3: Migration of substances from factory-made cementititous products
kSIST FprEN 14944-3:2023

This European Standard specifies a method to determine the migration of substances from factory made cementitious products into test waters after contact with the products.
This European Standard is applicable to factory made cementitious products, e.g. cement mortar linings to metallic pipes, tanks, concrete pipes etc., intended to be used for the transport and storage of water intended for human consumption, including raw water used for the production of drinking water.

  • Draft
    55 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 17428:2023(Main)
Packaging - Determination of the degree of disintegration under simulated home composting conditions
SIST EN 17428:2024

This document specifies a laboratory scale test method for determining the degree of disintegration of test items when exposed to well-managed home composting conditions by the weight evaluation method (WE method) using sieving and evaluation by weighing.
The test method is not applicable for the determination of the biodegradability of test items under home composting conditions. Additional testing is necessary for making claims concerning the suitability for home composting. This document is not appropriate for claims relating to the suitability for home composting.
This test method is carried out at laboratory scale under controlled conditions. Therefore, it does not reproduce any real home composting conditions, but it is devised to gain information on the potential of the test item to disintegrate sufficiently. A test item that passes this test is assumed to be capable of undergoing full disintegration in a 12 months home composting cycle carried out under well managed conditions. For features of well-managed home composting see EN 17427:2022, Annex E.

  • Draft
    15 pages
    English language
    sale 10% off
    e-Library read for
    1 day
CEN
EN 4708-002:2023(Main)
Aerospace series - Sleeving, heat-shrinkable, for binding, insulation and identification - Part 002: Index of Product standards
kSIST FprEN 4708-002:2022

This document lists the product standards, covered by technical specification EN 4708-001, for heat shrinkable sleeves.

  • Draft
    7 pages
    English language
    sale 10% off
    e-Library read for
    1 day