SIST ETS 300 081 E1:2003
(Main)Integrated Services Digital Network (ISDN); Teletex end-to-end protocol over the ISDN
Integrated Services Digital Network (ISDN); Teletex end-to-end protocol over the ISDN
Definition of the end-to-end protocols to be used by Teletex terminals
Digitalno omrežje z integriranimi storitvami (ISDN) – Protokoli za sistem Teletex pri izvedbi konec-konec prek sistema ISDN
General Information
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Digitalno omrežje z integriranimi storitvami (ISDN) – Protokoli za sistem Teletex pri izvedbi konec-konec prek sistema ISDNIntegrated Services Digital Network (ISDN); Teletex end-to-end protocol over the ISDN33.080Digitalno omrežje z integriranimi storitvami (ISDN)Integrated Services Digital Network (ISDN)33.050.30Oprema za teleks, teletekst, telefaksEquipment for telex, teletext, telefaxICS:Ta slovenski standard je istoveten z:ETS 300 081 Edition 1SIST ETS 300 081 E1:2003en01-december-2003SIST ETS 300 081 E1:2003SLOVENSKI
STANDARD
SIST ETS 300 081 E1:2003
EUROPEANETS 300 081TELECOMMUNICATIONFebruary 1993STANDARDSource: ETSI TC-TEReference: T/TE 07-11ICS:33.080Key words:ISDN, TeletexIntegrated Services Digital Network (ISDN);Teletex end-to-end protocol over the ISDNETSIEuropean Telecommunications Standards InstituteETSI SecretariatPostal address: F-06921 Sophia Antipolis CEDEX - FRANCEOffice address: 650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCEX.400: c=fr, a=atlas, p=etsi, s=secretariat - Internet: secretariat@etsi.frTel.: +33 92 94 42 00 - Fax: +33 93 65 47 16Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and theforegoing restriction extend to reproduction in all media.© European Telecommunications Standards Institute 1993. All rights reserved.SIST ETS 300 081 E1:2003
Page 2ETS 300 081: February 1993Whilst every care has been taken in the preparation and publication of this document, errors in content,typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to"ETSI Editing and Committee Support Dept." at the address shown on the title page.SIST ETS 300 081 E1:2003
Page 3ETS 300 081: February 1993ContentsForeword.51Scope and field of application.72Normative references.73Definitions and abbreviations.74Protocol description.84.1Network/Transport layer description.84.2Session layer description.84.3Presentation layer description.84.4Application layer description.85Protocol conformance requirements.8Annex A (normative):Additional session layer requirements.9A.1Additional ETSI-specific requirements to CCITT Recommendation T.62.9A.1.1Paragraph 3.4.1.2a.9A.1.2Paragraph 3.4.4.3.9A.1.3Paragraph 3.4.5.1.9A.1.4Paragraph 3.4.12.9A.1.5Paragraph 3.2.3.2.9A.1.6Paragraph 3.2.10.9A.1.7Paragraph 3.3.1.1c.9A.1.8Paragraph 3.3.2.6.9A.1.9Paragraph 3.3.2.7b.9A.1.10Paragraph 3.3.2.9.10A.1.11Paragraph 3.4.3.10A.1.12Paragraph 3.4.3.2e.10A.1.13Paragraph 3.4.4.4.10A.1.14Paragraph 3.5.3.10A.1.15Paragraph 4.1.3.10A.1.16Annex J, paragraph 2.1.1c.10Annex B (normative):Test procedures for end-to-end protocols.11B.1Introduction.11B.2References.11B.3Test limitations.11B.4Test numbering.11B.5Tests for additional session layer requirements.12Annex C (informative):Advisory notes and additional information.15History.16SIST ETS 300 081 E1:2003
Page 4ETS 300 081: February 1993Blank pageSIST ETS 300 081 E1:2003
Page 5ETS 300 081: February 1993ForewordThis European Telecommunication Standard (ETS) has been produced by the Terminal Equipment (TE)Technical Committee of the European Telecommunications Standards Institute (ETSI).This ETS makes major reference to a number of CCITT Recommendations provided in the Normativereferences Clause (Clause 2), and can only be applied when considered together with elements of theCCITT Recommendations.Annex A is normative and provides additional session layer requirements plus the necessary amendmentsneeded to CCITT Recommendation T.62 [3]. Annex B is also normative and sets down test procedures forend-to-end protocols with reference to prETS 300 017 [8] together with CCITT Recommendation T.64 [7].SIST ETS 300 081 E1:2003
Page 6ETS 300 081: February 1993Blank pageSIST ETS 300 081 E1:2003
Page 7ETS 300 081: February 19931Scope and field of applicationThis ETS refers to the low layer protocols to be used in the Integrated Services Digital Network (ISDN), asdefined in CCITT Recommendation T.90 [1] together with ETS 300 080 [2].This ETS specifies the end-to-end protocols to be used between two end systems as defined in CCITTRecommendation T.62 [3].In addition, it defines the octet-string to be interchanged based on the coding scheme, as defined inCCITT Recommendation T.61 [4].This ETS gives a general tool for a manufacturer-independent compatible text communication betweenend systems over the ISDN, based on the Telematic protocol stack.2Normative referencesThis ETS incorporates by dated or undated reference, provisions from other publications. Thesenormative references are cited at the appropriate places in the text and the publications are listedhereafter. For dated references, subsequent amendments to or revisions of any of these publicationsapply to this ETS only when incorporated in it by amendment or revision. For undated references the latestedition of the publication referred to applies.[1]CCITT Recommendation T.90 (1992): "Characteristics and protocols forterminals for telematics services in ISDN".[2]ETS 300 080 (1992): "Integrated Services Digital Network (ISDN); ISDN lowerlayer protocols for telematic terminals".[3]CCITT Recommendation T.62 (1988): "Control procedures for teletex andGroup 4 facsimile services".[4]CCITT Recommendation T.61 (1988): "Character repertoire and codedcharacter sets for the international teletex service".[5]CCITT Recommendation T.60 (1988): "Terminal equipment for use in theteletex service".[6]CCITT Recommendation T.62 bis (1988): "Control procedures for teletex and G4 facsimile services based on Recommendations X.215 and X.225".[7]CCITT Recommendation T.64 (1988): "Conformance testing procedures for theteletex Recommendations".[8]Draft prETS 300 017: Terminal Equipment (TE); "Test procedures for Teletex".3Definitions and abbreviationsFor the purpose of this ETS, the following definitions apply:Teletex document: octet strings encoded according to the primary and supplementary sets of graphiccharacter and the primary and supplementary sets of control functions as defined in CCITTRecommendation T.61 [4], §4.1 and §4.2, representing only characters out of the basic graphic characterrepertoire and the basic control function repertoire as defined in CCITT Recommendation T.61 [4], §3.2and §3.3, and complying with the basic page formats as defined in CCITT Recommendation T.60 [5],§4.2.The other terms and all abbreviations used throughout this ETS are as defined in the ETSs/CCITTRecommendations provided in Clause 2.SIST ETS 300 081 E1:2003
Page 8ETS 300 081: February 19934Protocol description4.1Network/Transport layer descriptionThe implementation of the Network/Transport layers shall be fully in line with the provisions laid down anddescribed in CCITT Recommendation T.90 [1] together with those in ETS 300 080 [2].4.2Session layer descriptionThe implementation of the Session layer shall be fully in line with the provisions laid down and describedin CCITT Recommendations T.62 [3] or T.62 bis [6] together with additional Session layer requirements(see Annex A).4.3Presentation layer descriptionThe implementation of the Presentation layer shall be fully in line with the provisions laid down anddescribed in CCITT Recommendation T.61 [4], §3.3, §4.1 and §4.2 and CCITT Recommendation T.60 [5],§4.2.4.4Application layer descriptionNone.5Protocol conformance requirementsThe protocol for the exchange of Teletex documents between two end systems is in conformity with theprovisions laid down in Clause 5 if the protocols fulfil the following requirements:-for Network/Transport conformance testing see ETS 300 080 [2];-for Session conformance testing see CCITT Recommendation T.64 [7] and Annex B of this ETS;-no tests are required for printing and displaying the received document.SIST ETS 300 081 E1:2003
Page 9ETS 300 081: February 1993Annex A (normative):Additional session layer requirementsA.1Additional ETSI-specific requirements to CCITT Recommendation T.62A.1.1Paragraph 3.4.1.2aIf a normal document is transmitted from a Teletex terminal to the Teletex conversion facility thisparameter shall be indicated.A.1.2Paragraph 3.4.4.3All terminals shall examine the non-basic terminal capabilities indicated in CSS or RSSP and shall not relyon subsequent CDCL/RDCLP exchange to negotiate the use of any capabilities from table 3/CCITTRecommendation T.62 [3].A.1.3Paragra
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.