SIST EN 12704:2012
(Main)Adhesives for paper and board, packaging and disposable sanitary products - Determination of foam formation for aqueous adhesives
Adhesives for paper and board, packaging and disposable sanitary products - Determination of foam formation for aqueous adhesives
This European Standard specifies a test method to determine the foam formation, or air entrainment during rapid stirring of aqueous adhesives with a maximum viscosity of 10 000 MPa ? s at room temperature determined in accordance with EN 12092.
Klebstoffe für Papier, Verpackung und Hygieneprodukte - Bestimmung der Schaumbildung von wässrigen Klebstoffen
Diese Europäische Norm legt ein Prüfverfahren zur Untersuchung der Schaumbildung oder des Lufteintrags beim schnellen Rühren wässriger Klebstoffe fest, deren größte nach EN 12092 bestimmte Viskosität bei Raumtemperatur 10 000 MPa s beträgt.
Adhésifs pour papier, carton, emballage et produits sanitaires jetables - Détermination de la formation de mousse des adhésifs aqueux
La présente Norme européenne spécifie une méthode d'essai pour évaluer la formation de mousse ou l'entraînement d'air dans les adhésifs aqueux ayant une viscosité maximale de 10 000 MPa×s, lorsqu'ils sont soumis à une agitation rapide à la température ambiante déterminée conformément à l'EN 12092.
Lepila za papir in karton za embalažo in za higienske proizvode za enkratno uporabo - Ugotavljanje nastajanja pene pri vodnih vrstah lepil
Ta evropski standard določa preskusno metodo za ugotavljanje nastajanja pene ali pojava zračnih mehurčkov med hitrim mešanjem vodnih vrst lepil z najvišjo viskoznostjo 10.000 MPa pri sobni temperaturi, ki se določa v skladu s standardom EN 12092.
General Information
Relations
Standards Content (Sample)
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Lepila za papir in karton za embalažo in za higienske proizvode za enkratno uporabo - Ugotavljanje nastajanja pene pri vodnih vrstah lepilKlebstoffe für Papier, Verpackung und Hygieneprodukte - Bestimmung der Schaumbildung von wässrigen KlebstoffenAdhésifs pour papier, carton, emballage et produits sanitaires jetables - Détermination de la formation de mousse des adhésifs aqueuxAdhesives for paper and board, packaging and disposable sanitary products - Determination of foam formation for aqueous adhesives83.180LepilaAdhesives55.040SDNLUDQMHPackaging materials and accessoriesICS:Ta slovenski standard je istoveten z:EN 12704:2012SIST EN 12704:2012en,fr,de01-september-2012SIST EN 12704:2012SLOVENSKI
STANDARDSIST EN 12704:20001DGRPHãþD
SIST EN 12704:2012
EUROPEAN STANDARD NORME EUROPÉENNE EUROPÄISCHE NORM
EN 12704
March 2012 ICS 83.180 Supersedes EN 12704:1999English Version
Adhesives for paper and board, packaging and disposable sanitary products - Determination of foam formation for aqueous adhesives
Adhésifs pour papier, carton, emballage et produits sanitaires jetables - Détermination de la formation de mousse des adhésifs aqueux
Klebstoffe für Papier, Verpackung und Hygieneprodukte - Bestimmung der Schaumbildung von wässrigen KlebstoffenThis European Standard was approved by CEN on 5 February 2012.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions.
CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre:
Avenue Marnix 17,
B-1000 Brussels © 2012 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN 12704:2012: ESIST EN 12704:2012
EN 12704:2012 (E) 2 Contents Page Foreword .31 Scope .42 Normative references .43 Terms and definitions .44 Principle .45 Apparatus .46 Procedure .57 Expression of results .68 Test report .6 SIST EN 12704:2012
EN 12704:2012 (E) 3 Foreword This document (EN 12704:2012) has been prepared by Technical Committee CEN/TC 193 “Adhesives”, the secretariat of which is held by AENOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by September 2012, and conflicting national standards shall be withdrawn at the latest by September 2012. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent rights. This document supersedes EN 12704:1999. SAFETY STATEMENT — Persons using this document should be familiar with the normal laboratory practice, if applicable. This document does not purport to address all of th
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.