SIST EN 45556:2019
(Main)General method for assessing the proportion of reused components in energy-related products
General method for assessing the proportion of reused components in energy-related products
This document deals with the assessment of the proportion of re-used components in energy-related products on a generic level. All energy-related products are in the scope of this standard.
Allgemeines Verfahren zur Bewertung des Anteils an wiederverwendeten Komponenten in einem energieverbrauchsrelevanten Produkt
Méthode générale d'évaluation de la proportion de composants 2 réutilisés dans les produits liés à l'énergie
Splošna metoda za ocenjevanje deleža ponovno uporabljenih komponent v izdelkih, povezanih z energijo
Ta dokument obravnava ocenjevanje deleža ponovno uporabljenih komponent v izdelkih, povezanih z energijo, na splošni ravni. Na področje uporabe tega standarda spadajo vsi izdelki, povezani z energijo.
General Information
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 45556:2019
01-september-2019
Splošna metoda za ocenjevanje deleža ponovno uporabljenih komponent v
izdelkih, povezanih z energijo
General method for assessing the proportion of reused components in energy-related
products
Allgemeines Verfahren zur Bewertung des Anteils an wiederverwendeten Komponenten
in einem energieverbrauchsrelevanten Produkt
Méthode générale d'évaluation de la proportion de composants 2 réutilisés dans les
produits liés à l'énergie
Ta slovenski standard je istoveten z: EN 45556:2019
ICS:
13.030.50 Recikliranje Recycling
29.020 Elektrotehnika na splošno Electrical engineering in
general
31.020 Elektronske komponente na Electronic components in
splošno general
SIST EN 45556:2019 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 45556:2019
---------------------- Page: 2 ----------------------
SIST EN 45556:2019
EUROPEAN STANDARD EN 45556
NORME EUROPÉENNE
EUROPÄISCHE NORM
June 2019
ICS 13.030.50; 29.020; 31.020
English Version
General method for assessing the proportion of reused
components in energy-related products
Méthode générale d'évaluation de la proportion de Allgemeines Verfahren zur Bewertung des Anteils an
composants réutilisés dans les produits liés à l'énergie wiederverwendeten Komponenten in
energieverbrauchsrelevanten Produkten
This European Standard was approved by CENELEC on 15 April 2019. CEN and CENELEC members are bound to comply with the
CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard
without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC
Management Centre or to any CEN and CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN and CENELEC member into its own language and notified to the CEN-CENELEC Management Centre
has the same status as the official versions.
CEN and CENELEC members are the national standards bodies and national electrotechnical committees of Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia,
Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2019 All rights of exploitation in any form and by any means reserved worldwide for CEN national Members and for
CEN/CENELEC CENELEC Members.
Ref. No. EN 45556:2019 E
---------------------- Page: 3 ----------------------
SIST EN 45556:2019
EN 45556:2019 (E)
Contents Page
European foreword . 3
Introduction . 4
1 Scope . 5
2 Normative references . 5
3 Terms and definitions . 5
4 Assessment method for the proportion of reused components in an energy-related
product . 5
4.1 General considerations . 5
4.2 Calculation of the proportion of reused components . 6
4.2.1 Proportion of reused components by mass on product level . 6
4.2.2 Proportion of reused components by number on product level . 6
4.2.3 Proportion of reused components by mass balance . 7
4.2.4 Proportion of reused components by number balance . 7
5 Documenting the assessment of the proportion of reused components . 7
5.1 General . 7
5.2 Elements of the assessment . 8
Bibliography . 10
2
---------------------- Page: 4 ----------------------
SIST EN 45556:2019
EN 45556:2019 (E)
European foreword
This document (EN 45556:2019) has been prepared by CEN/CLC/JTC 10 “Energy-related products - Material
Efficiency Aspects for Ecodesign”.
The following dates are fixed:
• latest date by which this document has to be (dop) 2020-04-15
implemented at national level by publication of
an identical national standard or by
endorsement
• latest date by which the national standards (dow) 2022-04-15
conflicting with this document have to be
withdrawn
This document has been prepared under a mandate given to CENELEC by the European Commission and the
European Free Trade Association.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. CENELEC shall not be held responsible for identifying any or all such patent rights.
The dual logo CEN-CENELEC standardization deliverables, in the numerical range of 45550 – 45559, have
been developed under standardization request M/543 of the European Commission and are intended to
potentially apply to any product within the scope of the energy-related products (ErP) Directive (2009/125/EC).
Topics covered in the above standardization request are linked to the following material efficiency aspects:
a) Extending product lifetime.
b) Ability to reuse components or recycle materials from products at end-of-life.
c) Use of reused components and/or recycled materials in products.
These standards are general in nature and describe or define fundamental principles, concepts, terminology or
technical characteristics. They can be cited together with other product-specific or product-group standards,
e.g. developed by product technical committees.
This document is intended to be used by product technical committees when producing product-specific or
product-group standards.
3
---------------------- Page: 5 ----------------------
SIST EN 45556:2019
EN 45556:2019 (E)
Introduction
This document provides general methods for assessing the proportion of reused components in an energy-
related product. Four calculation methods based on mass of re-used components and the number of reused
components are presented. Other methods may exist and be more suitable for certain products or product-
groups. While writing product standards on assessing the proportion of reused components product technical
committees should apply the most suitable methods for their product-group.
4
---------------------- Page: 6 ----------------------
SIST EN 45556:2019
EN 45556:2019 (E)
1 Scope
This document deals with the assessment of the proportion of reused components in energy-related products
on a generic level, which can be applied at any point in the life of the product.
This document is intended to be used by product technical committees when producing product, or product-
group, standards.
This document can be applied where no product-specific standard exists.
Aspects like performance, validation, verification and suitability of reused components are not in the scope of
this document.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes
requirements of this document. For dated references, only the edition cited applies. For undated references, the
latest edition of the referenced document (including any amendments) applies.
EN 45559:2019, Methods for providing information relating to material efficiency aspects of ene
...
SLOVENSKI STANDARD
oSIST prEN 45556:2018
01-oktober-2018
Splošna metoda za ocenjevanje deleža ponovno uporabljenih komponent v
izdelkih, povezanih z energijo
General method for assessing the proportion of re-used components in energy-related
products
Allgemeines Verfahren zur Bewertung des Anteils an wiederverwendeten Komponenten
in einem energieverbrauchsrelevanten Produkt
Méthode générale d'évaluation de la proportion de composants 2 réutilisés dans les
produits liés à l'énergie
Ta slovenski standard je istoveten z: prEN 45556
ICS:
13.030.50 Recikliranje Recycling
29.020 Elektrotehnika na splošno Electrical engineering in
general
31.020 Elektronske komponente na Electronic components in
splošno general
oSIST prEN 45556:2018 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
oSIST prEN 45556:2018
---------------------- Page: 2 ----------------------
oSIST prEN 45556:2018
EUROPEAN STANDARD DRAFT
prEN 45556
NORME EUROPÉENNE
EUROPÄISCHE NORM
August 2018
ICS 13.030.50; 29.020; 31.020
English Version
General method for assessing the proportion of re-used
components in energy-related products
Méthode générale d'évaluation de la proportion de To be completed
composants 2 réutilisés dans les produits liés à l'énergie
This draft European Standard is submitted to CENELEC members for enquiry. Deadline for CENELEC: 2018-11-09.
It has been drawn up by the Technical Committee CEN/CLC/JTC 10. If this draft becomes a European Standard, CEN and CENELEC
members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration.
This draft European Standard was established by CEN and CENELEC in three official versions (English, French, German). A version in any
other language made by translation under the responsibility of a CEN and CENELEC member into its own language and notified to the
CEN-CENELEC Management Centre has the same status as the official versions.
CEN and CENELEC members are the national standards bodies and national electrotechnical committees of Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia,
Slovenia, Spain, Sweden, Switzerland, Turkey and United Kingdom
Recipients of this draft are invited to submit, with their comments, notification of any relevant patent rights of which they are aware and to
provide supporting documentation.
Warning : This document is not a European Standard. It is distributed for review and comments. It is subject to change without notice and
shall not be referred to as a European Standard.
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2018 All rights of exploitation in any form and by any means reserved worldwide for CEN national Members and for
CEN/CENELEC CENELEC Members.
Ref. No. prEN 45556 E
---------------------- Page: 3 ----------------------
oSIST prEN 45556:2018
prEN 45556:2018 (E)
1 Contents Page
2 European foreword . 3
3 Introduction . 4
4 1 Scope . 5
5 2 Normative references . 5
6 3 Terms and definitions . 5
7 4 Assessment method for the proportion of re-used components in an Energy-related
8 product . 5
9 4.1 General considerations . 5
10 4.2 Calculation of re-used component index . 6
11 5 Reporting the proportion of re-used components aspects . 6
12 5.1 General . 6
13 5.2 Elements of the assessment report . 7
14 Bibliography . 8
15
2
---------------------- Page: 4 ----------------------
oSIST prEN 45556:2018
prEN 45556:2018 (E)
16 European foreword
17 This document (prEN 45556:2018) has been prepared by CEN/CLC/JTC 10 "Energy-related products - Material
18 Efficiency Aspects for Ecodesign".
19 This document is currently submitted to the Enquiry.
20 The following dates are proposed:
• latest date by which the existence of this (doa) dor + 6 months
document has to be announced at national level
• latest date by which this document has to be (dop) dor + 12 months
implemented at national level by publication of
an identical national standard or by
endorsement
• latest date by which the national standards (dow) dor + 36 months
conflicting with this document have to be (to be confirmed or
withdrawn modified when voting)
21 This document has been prepared under a mandate given to CENELEC by the European Commission and the
22 European Free Trade Association.
23 The dual logo CEN-CENELEC standardization deliverables, in the numerical range of 45550 – 45559, have
24 been developed under standardization request M/543 of the European Commission and are intended to
25 potentially apply to any product within the scope of the Energy-related Products (ErP) Directive (2009/125/EC).
26 Topics covered in the above standardization request are linked to the following material efficiency aspects:
27 a) Extending product lifetime.
28 b) Ability to re-use components or recycle materials from products at end-of-life.
29 c) Use of re-used components and/or recycled materials in products.
30 These standards are general in nature and describe or define fundamental principles, concepts, terminology or
31 technical characteristics. They can be cited together with other product-specific or product group standards, e.g.
32 developed by product technical committees.
33 The present standard is intended to be used by product technical committees when producing product-specific
34 or product group standards.
3
---------------------- Page: 5 ----------------------
oSIST prEN 45556:2018
prEN 45556:2018 (E)
35 Introduction
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.