Marking of electrical and electronic equipment in accordance with Article 11(2) of Directive 2002/96/EC (WEEE)

This European Standard specifies a marking of electrical and electronic equipment in accordance with Article 11(2) of Directive 2002/96/EC (WEEE); that applies to electrical and electronic equipment falling under Annex IA of Directive 2002/96/EC, provided the equipment concerned is not part of another type of equipment that does not fall within the scope of this Directive. Annex IB of Directive 2002/96/EC contains an indicative list of the products, which fall under the categories set out in Annex IA of this Directive; that serves to clearly identify the producer of the equipment and that the equipment has been put on the market after 13 August 2005. The definition of a technical carrier medium for identifying the producer, such as a barcode, electronic data medium or microchip, is not covered by this standard.

Kennzeichnung von Elektro- und Elektronikgeräten entsprechend Artikel 11(2) der Richtlinie 2002/96/EG (WEEE)

Diese Europäische Norm legt eine Kennzeichnung fest –   von elektrischen und elektronischen Geräten entsprechend Artikel 11(2) der Richtlinie 2002/96/EG (WEEE); ANMERKUNG Dies stellt einen Zusatz zur Kennzeichnungsanforderung in Artikel 10(3) dieser Richtlinie dar, die vom Hersteller fordert, elektrische und elektronische Geräte, die nach dem 13. August 2005 in Verkehr gebracht wurden, mit dem Symbol einer „durchkreuzten Abfalltonne “ zu kennzeichnen. –   die für elektrische und elektronische Geräte gilt, die unter den Anhang IA der Richtlinie 2002/96/EG fallen, sofern sie nicht Teil eines anderen Gerätetyps sind, die nicht in den Anwendungsbereich dieser Richtlinie fällt. Anhang IB der Richtlinie 2002/96/EG enthält eine Liste mit Beispielen für Produkte, die unter die Kategorien fallen, die im Anhang IA dieser Richtlinie angegeben sind; –   die dazu dient, den Hersteller des Geräts eindeutig zu identifizieren sowie dass das Gerät nach dem 13. August 2005 in Verkehr gebracht worden ist. Die Festlegung eines technischen Trägermediums zur Identifizierung des Herstellers wie zum Beispiel Strichcodes, elektronische Datenmedien oder Mikrochips wird von dieser Norm nicht abgedeckt.

Marquage des équipements électriques et électroniques conformément à l'Article 11(2) de la Directive 2002/96/CE (DEEE)

La présente Norme Européenne spécifie un marquage •   des équipements électriques et électroniques conformément à l’Article 11(2) de la directive 2002/96/CE (DEEE); NOTE Ceci vient en complément des exigences de marquage de l’Article 10(3) de cette Directive qui impose aux producteurs de marquer les équipements électriques et électroniques mis sur le marché après le 13 août 2005 avec un symbole de «poubelle à roulettes barrée d’une croix». •   qui s’applique aux équipements électriques et électroniques relevant de l’Annexe IA de la Directive 2002/96/CE, pour autant que l’équipement considéré ne fasse pas partie d’une autre type d’équipement qui n’entre pas dans le champ d’application de cette directive. L’Annexe IB de la Directive 2002/96/CE fournit une liste indicative des produits qui relèvent des catégories énumérées à l’Annexe IA de cette Directive; •   qui sert à identifier clairement le producteur de l’équipement et que cet équipement a été mis sur le marché après le 13 août 2005. La définition d’un moyen technique d’identification du producteur, tel qu’un code à barres, un support électronique des données ou une micro-puce n’est pas couverte dans cette norme.

Označevanje električne in elektronske opreme v skladu s členom 11(2) direktive 2002/96/ES (WEEE)

General Information

Status
Published
Publication Date
31-Aug-2006
Current Stage
6060 - National Implementation/Publication (Adopted Project)
Start Date
01-Sep-2006
Due Date
01-Sep-2006
Completion Date
01-Sep-2006

Relations

Buy Standard

Standard
EN 50419:2006
English language
8 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 50419:2006
01-september-2006
1DGRPHãþD
SIST EN 50419:2005
2]QDþHYDQMHHOHNWULþQHLQHOHNWURQVNHRSUHPHYVNODGXVþOHQRP  GLUHNWLYH
(6 :(((
Marking of electrical and electronic equipment in accordance with Article 11(2) of
Directive 2002/96/EC (WEEE)
Kennzeichnung von Elektro- und Elektronikgeräten entsprechend Artikel 11(2) der
Richtlinie 2002/96/EG (WEEE)
Marquage des équipements électriques et électroniques conformément à l'Article 11(2)
de la Directive 2002/96/CE (DEEE)
Ta slovenski standard je istoveten z: EN 50419:2006
ICS:
01.080.40 *UDILþQLVLPEROL]DXSRUDERY Graphical symbols for use on
ULVEDKGLDJUDPLKQDþUWLKY electrical and electronics
HOHNWURWHKQLNLLQHOHNWURQLNL engineering drawings,
WHUYXVWUH]QLWHKQLþQL diagrams, charts and in
SURL]YRGQLGRNXPHQWDFLML relevant technical product
documentation
29.020 Elektrotehnika na splošno Electrical engineering in
general
31.020 Elektronske komponente na Electronic components in
splošno general
SIST EN 50419:2006 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 50419:2006

---------------------- Page: 2 ----------------------

SIST EN 50419:2006


EUROPEAN STANDARD
EN 50419

NORME EUROPÉENNE
March 2006
EUROPÄISCHE NORM

ICS 01.080.20; 29.020; 31.020 Supersedes EN 50419:2005


English version


Marking of electrical and electronic equipment in accordance
with Article 11(2) of Directive 2002/96/EC (WEEE)



Marquage des équipements  Kennzeichnung von Elektro-
électriques et électroniques und Elektronikgeräten
conformément à l'Article 11(2) entsprechend Artikel 11(2)
de la Directive 2002/96/CE (DEEE) der Richtlinie 2002/96/EG (WEEE)





This European Standard was approved by CENELEC on 2006-03-01. CENELEC members are bound to
comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and
notified to the Central Secretariat has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Cyprus, the Czech
Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Central Secretariat: rue de Stassart 35, B - 1050 Brussels


© 2006 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 50419:2006 E

---------------------- Page: 3 ----------------------

SIST EN 50419:2006
EN 50419:2006 – 2 –
Foreword
This European Standard was prepared by CENELEC BTTF 116-3, Waste from electrical and electronic
equipment (WEEE).
The text of a draft amendment to EN 50419:2005 was submitted to the formal vote and was approved by
CENELEC on 2006-03-01 to be combined and published as a new edition of EN 50419.
This European Standard supersedes EN 50419:2005 and its corrigendum February 2005.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2006-06-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2006-06-01
This European Standard was prepared under the mandate M/336 given to CENELEC by the European
Commission and the European Free Trade Association and supports the essential requirements of
Directive 2002/96/EC.
__________

---------------------- Page: 4 ----------------------

SIST EN 50419:2006
– 3 – EN 50419:2006
Contents
Page
1 Scope.4
2 Normative references .4
3 Definitions .4
4 Marking .5
4.1 Requirements of marking.5
4.2 Design of the marking .5
4.3 Location of the marking .7
Bibliography.8

---------------------- Page: 5 ----------------------

SIST EN 50419:2006
EN 50419:2006 – 4 –
1 Scope
This European Standard specifies a marking
• of electrical and electronic equipment in accordance with Article 11(2) of Directive 2002/96/EC
(WEEE);
NOTE This is in addition to the marking requirement in Article 10(3) of this Directive which requires producers to mark
electrical and electronic equipment put on the market after 13 August 2005 with a ‘crossed-out wheeled bin’ symbol.
• that applies to electrical and electronic equipment falling under Annex IA of Directive 2002/96/EC,
provided the equipment concerned is not part of another type of equipment that does not fall within
the scope of this Directive. Annex IB of Directive 2002/96/EC contains an indicative list of the
products, which fall under the categories set out in Annex IA of this Directive;
• that serves to clearly identify the producer of the equipment and that the equipment has been put on
the market after 13 August 2005.
The definition of a technical carrier medium for identifying the producer, such as a barcode, electronic
data medium or microchip, is not covered by this standard.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
ISO 8601:2004,
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.