EN ISO 17268:2020

Gaseous hydrogen land vehicle refuelling connection devices (ISO/FDIS 17268:2019)

This document defines the design, safety and operation characteristics of gaseous hydrogen land vehicle (GHLV) refuelling connectors.
GHLV refuelling connectors consist of the following components, as applicable:
—     receptacle and protective cap (mounted on vehicle);
—     nozzle;
—     communication hardware.
This document is applicable to refuelling connectors which have nominal working pressures or hydrogen service levels up to 70 MPa.
This document is not applicable to refuelling connectors dispensing blends of hydrogen with natural gas.

Anschlussvorrichtungen für die Betankung von Landfahrzeugen mit gasförmigem Wasserstoff (ISO 17268:2020)

Dieses Dokument legt die Auslegung, die Sicherheit und die betrieblichen Eigenschaften von Anschlüssen zur Betankung von Landfahrzeugen, die mit gasförmigem Wasserstoff (GHLV; en: gaseous hydrogen land vehicle) betrieben werden, fest.
GHLV-Betankungsanschlüsse bestehen ggf. aus den folgenden Bauteilen:
—   Empfängerstutzen und Schutzkappe (am Fahrzeug angebracht);
—   Füllstutzen;
—   Kommunikations-Hardware.
Dieses Dokument gilt für Betankungsanschlüsse mit Nennbetriebsdrücken oder Wasserstoffbetriebsstufen von bis zu 70 MPa.
Betankungsanschlüsse zur Abgabe von Wasserstoff-Erdgas-Gemischen sind vom Anwendungsbereich dieses Dokuments ausgeschlossen.

Dispositifs de raccordement pour le ravitaillement des véhicules terrestres en hydrogène gazeux (ISO/FDIS 17268:2019)

Le présent document définit les caractéristiques de conception, de sécurité et d'exploitation des connecteurs destinés au ravitaillement des véhicules terrestres à hydrogène gazeux (GHLV).
Les connecteurs de ravitaillement des GHLV sont constitués des éléments suivants, selon le cas:
—          un réceptacle et un bouchon de protection (montés sur le véhicule);
—          un pistolet;
—          un module de communication.
Le présent document s'applique aux connecteurs de ravitaillement ayant une pression de service nominale ou un niveau de service d'hydrogène ne dépassant pas 70 MPa.
Le présent document ne s'applique pas aux connecteurs de ravitaillement servant à distribuer des mélanges d'hydrogène et de gaz naturel.

Priključne naprave za oskrbo kopenskih vozil s plinastim vodikom (ISO 17268:2020)

General Information

• Status: Published
• Publication Date: 25-Feb-2020
• Withdrawal Date: 30-Aug-2020
• ICS: 43.180 - Diagnostic, maintenance and test equipment
• ICS: 71.100.20 - Gases for industrial application
• Technical Committee: CEN/TC 268 - Cryogenic vessels
• Drafting Committee: CEN/TC 268/WG 5 - Specific hydrogen technologies applications
• Current Stage: 6060 - Definitive text made available (DAV) - Publishing
• Start Date: 26-Feb-2020
• Completion Date: 26-Feb-2020
• Directive: 2014/94/EU - Directive 2014/94/EU of The European Parliament and of The Council of 22 October 2014 on the deployment of alternative fuels infrastructure
• Mandate: M/533 - [C(2015)1330] Standardisation request addressed to CEN, CENELEC and ETSI in support of the implementation of the Directive 2014/94/EU on the deployment of alternative fuels infrastructure
• Ref Project: SIST EN ISO 17268:2020 - Gaseous hydrogen land vehicle refuelling connection devices (ISO 17268:2020)

Relations

• Replaces: EN ISO 17268:2016 - Gaseous hydrogen land vehicle refuelling connection devices (ISO 17268:2012)
• Effective Date: 04-Mar-2020
• Revised: prEN ISO 17268-1 - Gaseous hydrogen land vehicle refuelling connection devices - Part 1: Flow capacities up to and including 120 g/s (ISO/DIS 17268-1:2024)
• Effective Date: 19-Jan-2023

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 17268:2020
01-maj-2020
Nadomešča:
SIST EN ISO 17268:2017
Priključne naprave za oskrbo kopenskih vozil s plinastim vodikom (ISO
17268:2020)
Gaseous hydrogen land vehicle refuelling connection devices (ISO 17268:2020)
Gasförmiger Wasserstoff - Anschlussvorrichtungen für die Betankung von
Landfahrzeugen (ISO 17268:2020)
Dispositifs de raccordement pour le ravitaillement des véhicules terrestres en hydrogène
gazeux (ISO 17268:2020)
Ta slovenski standard je istoveten z: EN ISO 17268:2020
ICS:
43.180 Diagnostična, vdrževalna in Diagnostic, maintenance and
preskusna oprema test equipment
71.100.20 Industrijski plini Gases for industrial
application
SIST EN ISO 17268:2020 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------
SIST EN ISO 17268:2020

---------------------- Page: 2 ----------------------
SIST EN ISO 17268:2020


EN ISO 17268
EUROPEAN STANDARD

NORME EUROPÉENNE

February 2020
EUROPÄISCHE NORM
ICS 43.180; 71.100.20 Supersedes EN ISO 17268:2016
English Version

Gaseous hydrogen land vehicle refuelling connection
devices (ISO 17268:2020)
Dispositifs de raccordement pour le ravitaillement des
véhicules terrestres en hydrogène gazeux (ISO
17268:2020)
This European Standard was approved by CEN on 24 January 2020.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,
Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels
© 2020 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 17268:2020 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------
SIST EN ISO 17268:2020
EN ISO 17268:2020 (E)
Contents Page
European foreword . 3

2

---------------------- Page: 4 ----------------------
SIST EN ISO 17268:2020
EN ISO 17268:2020 (E)
European foreword
This document (EN ISO 17268:2020) has been prepared by Technical Committee ISO/TC 197
"Hydrogen technologies" in collaboration with Technical Committee CEN/TC 268 “Cryogenic vessels
and specific hydrogen technologies applications” the secretariat of which is held by AFNOR.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by August 2020, and conflicting national standards shall
be withdrawn at the latest by August 2020.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN shall not be held responsible for identifying any or all such patent rights.
This document supersedes EN ISO 17268:2016.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of
North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the
United Kingdom.
Endorsement notice
The text of ISO 17268:2020 has been approved by CEN as EN ISO 17268:2020 without any modification.

3

---------------------- Page: 5 ----------------------
SIST EN ISO 17268:2020

---------------------- Page: 6 ----------------------
SIST EN ISO 17268:2020
INTERNATIONAL ISO
STANDARD 17268
Third edition
2
...