43.040.30 - Indicating and control devices

ISO 15005:2017 specifies ergonomic principles for the design of the dialogues that take place between the driver of a road vehicle and the vehicle's transport information and control systems (TICS) while the vehicle is in motion. It also specifies compliance verification conditions for the requirements related to these principles.
ISO 15005:2017 is applicable to TICS consisting of either single or multiple devices, which can be either independent or interconnected. It is not applicable to TICS ...view more

This European Standard is intended to provide technical specifications for mechanical seals to enhance the security of digital tachograph system. It applies to the category of vehicles as defined in European Regulation n°165/2014.
NOTE 1   This European Standard is intended primarily to digital tachographs but can be applied to analog tachographs.
NOTE 2   Any type of seals which meet the requirements within this European Standard can be used.

This European Standard is intended to provide technical specifications for mechanical seals to enhance the security of digital tachograph system. It applies to the category of vehicles as defined in European Regulation n°165/2014.
NOTE 1   This European Standard is intended primarily to digital tachographs but can be applied to analog tachographs.
NOTE 2   Any type of seals which meet the requirements within this European Standard can be used.

ISO 15007-1:2014 defines key terms and parameters applied in the analysis of driver visual behaviour focused on glance and glance-related measures. These terms and parameters can be applied in environments from real-world driving experiments to laboratory-based driving simulator studies.
The procedures described in this part of ISO 15007 could also apply to more general assessments of driver visual behaviour without the introduction of TICS-specific systems. The parameters and definitions descr...view more

This part of ISO 13207 specifies the characteristics of LED (Light Emitting Diode) lamps used as direction indicators when optionally monitored. It applies primarily to those lamps which are installed on 24V truck/trailer combinations. It will enable lamp-failure detection of LED lamps on the drawn vehicle to be compatible with that for bulbs when analysed by the towing unit.

ISO 2575:2010 specifies symbols (i.e. conventional signs) for use on controls, indicators and tell-tales applying to passenger cars, light and heavy commercial vehicles and buses, to ensure identification and facilitate use. It also indicates the colours of possible optical tell-tales, which inform the driver of either correct operation or malfunctioning of the related devices.

ISO 4040:2009 specifies the location of controls in motor vehicles by subdividing the space within reach of drivers into specific zones, to which certain controls essential to the safe operation of vehicles are assigned. It also specifies certain combinations of functions for multifunction controls and the degree to which certain indicators and tell-tales are to be visible. ISO 4040:2009 is applicable to hand-operated controls, to indicators and to tell-tales in all motor vehicles, excluding mot...view more

ISO 16154:2005 specifies the characteristics and installation of lighting and marking devices on agricultural and forestry tractors, self-propelled agricultural machines, agricultural trailers and trailed machines when operated on public roads. It is not applicable to purpose-built forestry machines as defined in ISO 6814 or to motor vehicles such as automobiles, buses, trucks and their trailers.