This European Standard specifies two methods for the determination of total organic carbon (TOC) in sludge, treated biowaste, soil, waste and sediment samples containing more than 1 g carbon per kg of dry matter (0,1 %).
When present, elementary carbon, carbides, cyanides, cyanates, isocyanates, isothiocyanates and thio-cyanates are determined as organic carbon using the methods described in this European Standard. An interpretation of the measured value may therefore be problematic in cases where the samples contain relevant levels of the above mentioned components. If necessary, these components should be determined separately by means of a suitable validated procedure and be recorded in the test report.
For sludge, treated biowaste and soil only Method A is validated.

  • Standard
    23 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    23 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This document specifies an instrumental method for the routine determination of pH within the range pH 2 to pH 12 using a glass electrode in a 1:5 (volume fraction) suspension of soil, sludge and treated biowaste in water (pH in H2O), in 1 mol/l potassium chloride solution (pH in KCl) or in 0,01 mol/l calcium chloride solution (pH in CaCl2).
This International Standard is applicable to all types of soil, sludge and biowaste, for example
pretreated in accordance with ISO 11464 or EN 16179.

  • Standard
    15 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Draft
    12 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This document specifies a basic method of determining the particle size distribution applicable to a wide range of mineral soil materials, including the mineral fraction of organic soils. It also offers procedures to deal with the less common soils mentioned in the introduction. This document has been developed largely for use in the field of environmental science, and its use in geotechnical investigations is something for which professional advice might be required.
A major objective of this document is the determination of enough size fractions to enable the construction of a reliable particle-size-distribution curve.
This document does not apply to the determination of the particle size distribution of the organic components of soil, i.e. the more or less fragile, partially decomposed, remains of plants and animals. It is also realized that the chemical pre-treatments and mechanical handling stages in this document could cause disintegration of weakly cohesive particles that, from field inspection, might be regarded as primary particles, even though such primary particles could be better described as aggregates. If such disintegration is undesirable, then this document is not used for the determination of the particle size distribution of such weakly cohesive materials.

  • Standard
    43 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    43 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    38 pages
    English language
    sale 15% off
  • Standard
    40 pages
    French language
    sale 15% off

ISO/IEC 17025:2017 specifies the general requirements for the competence, impartiality and consistent operation of laboratories.
ISO/IEC 17025:2017 is applicable to all organizations performing laboratory activities, regardless of the number of personnel.
Laboratory customers, regulatory authorities, organizations and schemes using peer-assessment, accreditation bodies, and others use ISO/IEC 17025:2017 in confirming or recognizing the competence of laboratories.

  • Standard
    39 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard – translation
    51 pages
    Slovenian and English language
    sale 10% off
    e-Library read for
    1 day

This document specifies three methods for the determination of dry bulk density of soils calculated
from the mass and the volume of a soil sample. The methods involve drying and weighing a soil sample,
the volume of which is either known [core method (see 4.1)] or determined [excavation method (see 4.2)
and clod method (see 4.4)].

  • Standard
    22 pages
    English language
    sale 10% off
    e-Library read for
    1 day

EN-ISO 10693 specifies a method or the determination of carbonate content in soil samples. It is applicable to all types of air-dried soil samples.

  • Standard
    12 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This European Standard specifies the determination of total nitrogen (organic and inorganic) according to the procedure of Dumas in sludge, treated biowaste and soil. A typical limit of detection is 0,02 % nitrogen, and a typical limit of quantification is 0,08 % nitrogen.

  • Standard
    11 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This European Standard specifies the pretreatment required for sludge, treated biowaste and soil (including soil-like materials), that are subject to the analysis of organic as well as inorganic chemical and physicochemical parameters. The pretreatment of samples aims at preparing a (small) test sample which is representative for the original sample. This European Standard describes the pretreatment which could be performed under field conditions if necessary and the sample pretreatment under laboratory conditions. For determining inorganic chemical and physico-chemical parameters this European Standard describes procedures to prepare: - test samples for tests under field moist conditions; - test samples for testing after drying, crushing, grinding, sieving etc.; - test samples of liquid sludge. For determination of organic compounds three pretreatment methods are specified: - a pretreatment method if volatile organic compounds are to be measured; - a pretreatment method if moderately volatile to non-volatile organic compounds are to be measured and the result of the following analysis will be accurate and reproducible; - a pretreatment method if moderately volatile to non-volatile organic compounds are to be measured and the extraction procedure prescribes a field moist sample or if only indicative results are required. The choice of the method depends above all on the volatility of the analyte. It also depends on the particle size distribution of the material, the heterogeneity of the sample and the following analytical procedure.

  • Standard
    45 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This European Standard specifies methods for the calculation of the dry matter fraction of sludge, treated biowaste, soil and waste for which the results of performed analysis are to be calculated to the dry matter basis. Depending on the nature and origin of the sample, the calculation is based on a determination of the dry residue (Method A) or a determination of the water content (Method B). It applies to samples containing more than 1 % (mass fraction) of dry residue or more than 1 % (mass fraction) of water. Method A applies to sludge, treated biowaste, soil and solid waste. Method B applies to liquid waste and to samples which are suspected or known to contain volatiles except for water.

  • Standard
    19 pages
    English language
    sale 10% off
    e-Library read for
    1 day

This International Standard specifies the pretreatments required for soil samples that are to be subjected to physico-chemical analyses of stable and non-volatile parameters and describes the following five types of pretreatment of samples: drying, crushing, sieving, dividing and milling. The pretreatment procedures described in this International Standard are not applicable if they affect the results of the determinations to be made. This International Standard is also not applicable to samples when volatile compounds are measured. In general, International Standards for analytical methods will state when it is necessary to adopt other procedures.

  • Standard
    11 pages
    English language
    sale 15% off
  • Standard
    15 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    11 pages
    French language
    sale 15% off
  • Standard
    5 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    5 pages
    English language
    sale 15% off
  • Standard
    5 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    5 pages
    French language
    sale 15% off

Specifies a method for the determination of the total nitrogen (ammonium-N, nitrate-N, nitrite-N and organic N) content of a soil. Nitrogen in N-N-linkages, N-O-linkages and some heterocyclics (especially pyridine) is only partially determined. Applicable to all types of soils.

  • Standard
    4 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    4 pages
    English language
    sale 15% off
  • Standard
    4 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    4 pages
    French language
    sale 15% off

Specifies a method for the determination of the total carbon content in soil after dry combustion. The organic carbon content is calculated from this content after correcting for carbonates present in the sample. If carbonates are removed beforehand, the organic carbon content is measured directly. Applicable to all types of air-dried soil samples.

  • Standard
    7 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    7 pages
    English language
    sale 15% off
  • Standard
    7 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    7 pages
    French language
    sale 15% off
  • Standard
    7 pages
    French language
    sale 15% off

The method specified can be applied to all types of soil samples. Different procedures are specified for air-dried soil samples, e.g. samples pretreated according to ISO 11464, and for field-moist soil samples. Its principle is drying soil samples to constant mass at 105 °C and using the difference in mass of an amount of soil before and after the drying procedure to calculate the dry matter and water contents on a mass basis. For the determination of soil water content on a volume basis, refer to ISO 11461.

  • Standard
    3 pages
    English language
    sale 15% off
  • Standard
    3 pages
    English language
    sale 10% off
    e-Library read for
    1 day
  • Standard
    4 pages
    French language
    sale 15% off
  • Standard
    4 pages
    French language
    sale 15% off